Contributions of restructuring and oxidation to the aging of the surface of plasma polymers containing heteroatoms

The properties and composition of plasma polymer surfaces stored in air can change considerably over time, especially as a result of oxidative reactions. When plasma polymers contain an element other than O, it is possible to probe for mechanisms in addition to oxidation that contribute to the aging of the surface. Plasma polymers containing N were fabricated from either 1,3-diaminopropane (DAP),n-heptylamine (nHA), or allylamine (AA), and studied by X-ray photo-electron spectroscopy (XPS) and air/water contact angles (CA). For each of the plasma polymers, a multiexponential increase in the O/C ratio was observed over time using XPS. The N/C ratios remained constant (AA) or decreased somewhat (nHA and DAP). In contrast, the trends in CA values differed, declining for the nHA surfaces, rising for the AA, and changing little for the DAP. Surface roughness, assessed by scanning tunnelling or atomic force microscopy, did not change over time. The diverse adjustments in the polarity of each surface and the similar compositional changes between them are reconcilable if the aging of the plasma polymer surface is a manifestation of the superposition of concurrent oxidative reactions and partial surface reorientation; the former introduce polar groups and the latter transports then from the surface to deeper regions beyond the CA probe depth but within the XPS analysis depth. These processes vary between different plasma polymers. Data for the alkylamine plasma polymers is also compared with that for two plasma polymers fabricated from methanol. The change in composition, but not polarity, of the DAP surface after 4 days of storage demonstrates the importance of using multiple techniques to characterize the aging of plasma polymer surfaces.     

Partition and binding constants in micelles and vesicles from fluorescence quenching data

A method of analysing steady-state fluorescence quenching in compartmentalized systems is proposed which allows the evaluation of partition and binding constants where both association processes occur simultaneosly. The number of binding sites is shown to be dependent on the nature of the quencher.     

Method of immobilization of carboxymethyl-dextran affects resistance to tissue and cell colonization

Coatings from carboxymethylated dextrans (CMDs) were fabricated, analyzed by XPS, and investigated for their ability to inhibit corneal epithelial tissue outgrowth and bovine corneal epithelial cell attachment and growth. CMDs with differing degrees of carboxymethyl substitution and various molecular weights were synthesized by the solution reaction of dextrans with bromoacetic acid under different reactant ratios. The CMD compounds thus obtained were attached onto aminated surfaces produced in two ways: by the plasma deposition of a coating from n-heptylamine vapour, and by the plasma deposition of an acetaldehyde coating onto whose surface aldehyde groups the polyamine compounds polylysine, polyethyleneimine and polyallylamine were immobilized to provide platforms for CMD immobilization. XPS spectra showed that the latter route produced thicker coatings than the former approach. CMD molecules attached directly onto the plasma-fabricated amine surface supported some tissue migration; the extent of carboxymethyl substitution and the molecular weight of the CMDs had little influence. For CMDs immobilized via polyamine spacers, on the other hand, tissue outgrowth was completely inhibited, and again there were no discernible effects from the extent of carboxymethyl substitution and the molecular weight of the CMDs. In assays involving cell attachment and growth, analogous observations were found. Thus, the mode of immobilization of these polysaccharide coatings is the dominant factor in their anti-fouling performance, suggesting that optimization of the architecture of polysaccharide coatings may be an important factor for maximizing their cell-repellent abilities.     

The effects of sample preparation methods on the variability of the electrospray ionization response for model drug compounds

A post-column infusion system was developed in order to analyze suppression of electrospray ionization (ESI) tandem mass spectrometry response in the presence of endogenous plasma interferences. By enabling direct detection of these interfering components, this experimental system was used to analyze the ability of several common extraction procedures to remove endogenous plasma components that cause changes in the ESI response of model drug substances. Methyl-t-butyl ether (MTBE) liquid-liquid, Oasis and Empore solid-phase, and acetonitrile (ACN) protein precipitation sample preparation methods were tested using the post-column infusion system. In all cases, ACN protein precipitation samples showed the greatest amount of ESI response suppression while liquid-liquid extracts demonstrated the least. In addition, the three test compounds, phenacetin, caffeine, and a representative Merck compound, demonstrated that ESI response suppression is compound dependent. Suppression was greatest with caffeine, the most polar analyte, and the smallest for the Merck compound, the least polar analyte. Copyright 1999 John Wiley & Sons, Ltd.     

Gamma-ray spectroscopy with relativistic exotic heavy-ions

Feasibility of gamma-ray spectroscopy at relativistic energies with exotic heavy-ions and new generation of germanium detectors (segmented Clover) is discussed. An experiment with such detector array and radioactive is discussed.     

Ueber Instrumente zur Messung hoher Temperaturen

Ohne Zusammenfassung     

Percolative transport in the vicinity of charge-order ferromagnetic transition in a hole-doped manganite

We report measurements of non-linear charge transport in epitaxial (La_1−x Pr _x )_0.7Ca_0.3MnO₃ thin films fabricated on (100) oriented SrTiO₃ single crystals by pulsed laser deposition. The end members of this series, namely Pr_0.7Ca_0.3MnO₃ and La_0.7Ca_0.3MnO₃ are canonical charge-ordered (CO) and ferromagnetic manganites, respectively. The onset of the CO state in Pr_0.7Ca_0.3MnO₃ is manifested by a pronounced insulating behavior below ∼ 200 K. The CO state remains stable even when a large (∼ 2×10⁵ V/cm) electric field is applied across the thin film samples. However, on substitution of Pr with La, a crossover from the highly resistive CO state to a state of metallic character is observed at relatively low electric fields. The current-voltage characteristics of the samples at low temperatures show hysteretic and history dependent effects. The electric field driven charge transport in the system is modelled on the basis of an inhomogeneous medium consisting of ferromagnetic metallic clusters dispersed in a CO background.     

Concurrent restructuring and oxidation of the surface of n-hexane plasma polymers during aging in air

Angle-dependent XPS and air/water contact angle (CA) measurements were performed on specimens of n-hexane plasma polymers at various times after fabrication in order to monitor the aging of the surfaces in contact with air. XPS revealed incorporation of oxygen over extended periods of time. The depth distribution of O changed in the course of aging. CAs decreased over the first 3 weeks, then increased again, and finally stabilized at 5 weeks. These results were interpreted in terms of two concurrent processes: spontaneous oxidation (initiated by trapped radicals), which increased the surface polarity, and surface restructuring, which caused the partial removal of polar groups from the interface with air. The former process made a larger contribution to the overall aging of the surfaces but the latter process also contributed measurably. Over the first 3 weeks, oxidation was rapid and surface restructuring was not competitive. Subsequently, the oxygen uptake slowed down markedly, and the outermost surface layers became oxygen depleted relative to the deeper layers, due to partial surface reorientation. The surface topography, assessed by STM, did not change on aging. The aging of n-hexane plasma polymer surfaces thus is due to superimposed effects arising from post-deposition oxidative processes and partial surface reorientation.     

Dichtebestimmung

Ohne Zusammenfassung