Multifunctional fibrous wound dressings for refractory wound healing

Refractory wounds have always been an important issue to healthcare systems, whose healing process is always delayed by multiple factors, including bacterial infections, chronic inflammation, and excessive exudates, etc. Employing multifunctional wound dressings is recognized as an effective strategy to deal with refractory wounds, which has yielded promising outcomes in recent years. Among these advanced wound dressings, fibrous dressings have gained growing attention due to their unique merits. Such wound dressings have demonstrated great potential in delivering theranostic agents, such as antibacterial agents, anti-inflammatory drugs, growth factors, and diagnostic probes, etc., for the purposes of accelerating wound healing. This paper reviews the development of multifunctional fibrous dressings and their applications in treating refractory wounds. The construction approaches of novel fibrous dressing with capabilities of antibacterial, anti-inflammation, exudate management and diagnosis were also introduced. Furthermore, the existing problems and challenges are also discussed briefly.     

Photoelectrochemical oxygen atom transfer enabling efficient selective oxygenation

Photoelectrochemical(PEC)technique represents a promising approach to chemical transformation by harvesting sustainable solar energy.Despite the wide applications of PEC systems such as environmental remediation and solar energy conversion,the reported PEC reactions are dominated by the radical-based processes that are initiated by the single electron transfer between photo-induced carriers and adsorbed species on photoelectrode surface[1,2].For instance,hydroxyl radicals are often involved in the PEC oxidation reactions.As well known,it is a grand challenge to control the formation and evolution rates of radicals,which inevitably leads to the unsatisfactory product selectivity of PEC reactions.Naturally,such a circumstance brings about a question to the research community whether a different mechanism can be established to sustain efficient and selective oxygenation.Recently,based on their previous findings on PEC water oxidation[3,4],Zhao and coworkers[5]reported that many substrates can be oxidized in an oxygen atom transfer(OAT)pathway,a non-radical two electron process,to oxygenated products byα-Fe2O3 photoanodes.     

透明塑料盒上的显色偏振

依据显色偏振、布鲁斯特角等原理详细解释了透明塑料盒上彩色条纹的形成过程,并进行实验验证,排除了薄膜干涉、色散、散射等其他理论解释.     

QEPAS系统中石英音叉模态仿真计算与研究

对石英音叉增强型光声光谱(QEPAS)系统中常用的石英音叉进行了有限元模态计算，获得石英音叉前6阶振型与模态频率，认知了第4阶对称摆动振型为有效振动，利用单因素法分析了石英音叉的音臂长度l₁、音臂宽度w₁、音臂厚度t、音臂切角θ、音臂圆孔直径d及音臂圆孔高度h对低阶有效共振频率(Fre)的影响，敏感度依次为： l₁> w₁>d>θ>t>h，考虑实际设计情形，筛选出了l₁，w₁，d与h四个石英音叉设计变量，采用Box-Behnken实验设计方案与RSM(response surface methodology)方法，以Fre为函数目标，建立l₁，w₁，d与h的二次回归响应面模型，得到了参数之间的交互作用，利用Design-Expert软件对响应面模型进行设计参数反求，结果表明，在15 000 Hz≤Fre≤25 000 Hz计算区域内误差较小，基本满足QEPAS系统的计算需求，所提出的研究与设计方法具有一定通用性，可为QEPAS系统中石英音叉结构参数设计提供参考。     

油水两液相一维非等温渗流的传递分析

在求解油水两液相非等温渗流的温度场、压力场基础上,以驱动功、驱动功率、驱动阻力、驱动速率为特征参数,对该过程进行(火用)传递分析。数值模拟的结果表明:含水通过降低油的相对渗透率、从而增大驱动阻力、减小驱动功率, 最终导致原油产量降低。     

一类小缺陷码的链条件

利用射影几何方法在小缺陷码中,NMDS码是链条件码;给出k维NμMDS(0μk-2)码满足链条件的一个充要条件与一些易判断的充分条件.     

烟气中Hg的氧化机理的研究

本文对Ｈｇ与Ｃｌ２在烟气中的氧化反应进行了热力平衡计算和动力学计算。平衡计算的结果表明有ＣＩ元索存在时Ｈｇ的氧化率为１００％，而在相同的条件下动力学计算纺果为Ｈｇ的氧化率在２０％～８０％之间变化，与实验结果吻合。实际的氧化反应是一种超平衡状态，不能达到理想的平衡状态。因此应采用动力学与热力平衡分析相结合的方法研究Ｈｇ在烟气中的反应机理。同时，计算结果显示Ｃｌ含量对Ｈｇ的氧化率的影响很大．     

网络环境下的物理实验教学模式

目前网络环境下的物理实验教学新模式主要有物理实验专题网站、实验教学网络管理、实验类网络课程及远程控制物理实验.本文简要介绍了各个模式的特点及实施方法.     

NA列加权乘积和的完全收敛性

本文讨论了NA和几类加权部分和及加权乘积和的完全收敛性，其中部分结果要优于iid列的已知结论。     

高温水蓄冷空调的原理和理论分析

介绍了一种新型高温水蓄冷空调方案的原理井进行了理论分析。它可利用高至３８℃水的显热或其它材料的相变潜热来蓄冷空调．分析了完全不掺混系统的性能与过冷水流率的关系；给出了完全掺混系统非稳态循环的性能变化；数值计算并讨论了蓄冷水部分掺混系统的温度分层和动态特性、为高温水蓄冷空调系统的设计和运行提供了理论指导．