Resonance-enhanced multiphoton ionisation photoelectron spectroscopy of the ClO radical: the C 2 sigma- state

A (2 + 1) one-colour resonance-enhanced multiphoton ionisation study is carried out on the C 2 sigma- state of the ClO radical in the one-photon energy range 29,500-31,250 cm-1. The ClO radical is produced by one-photon photolysis of ClO2 employing 359.2 nm photons derived from a separate laser. In this way a significant concentration of vibrationally excited ClO in its spin-orbit split X 2 pi omega (omega = 3/2 or 1/2) electronic ground state is produced. In addition to mass-resolved excitation spectra, kinetic-energy resolved photoelectron spectra for the X 3 sigma-(v+)<--C 2 sigma-(v' = 3-5) transitions are measured. These transitions are not completely Frank-Condon diagonal, and indicate a decrease in bond length on removal of the Rydberg electron from the C 2 sigma- state. In addition to an unambiguous assignment of the C 2 sigma- state, valuable information is obtained on the degree of vibrational excitation with which the nascent ClO radical is formed in the photolysis of ClO2. Analysis of the photoelectron spectra is supported by Franck-Condon calculations based on potential energy curves either from experimental spectroscopic parameters, or obtained by theoretical ab initio methods.     

Photoelastic determination of stresses in multiple-pin connectors

The design, fabrication, and testing of photoelastic models of double-lap, multiple-pin connectors are discussed. Interest is in the stresses in the inner laps. These stresses are determined by constructing models with photoelastic inner laps and transparent-acrylic outer laps. The connectors have two pins, in tandem, parallel to the load direction. A photoelastic-isotropic point is shown to permit the evaluation of load sharing between the two pins. A numerical scheme, utilizing the isochromatic- and isoclinic-photoelastic data and a finite-difference representation of the planestress equilibrium equations, is used to compute the stresses around the two pins. Representative stress distributions and stress-concentration factors are shown.     

Phage display-derived inhibitor of the essential cell wall biosynthesis enzyme MurF

Background  

To develop antibacterial agents having novel modes of action against bacterial cell wall biosynthesis, we targeted the essential MurF enzyme of the antibiotic resistant pathogen Pseudomonas aeruginosa. MurF catalyzes the formation of a peptide bond between D-Alanyl-D-Alanine (D-Ala-D-Ala) and the cell wall precursor uridine 5'-diphosphoryl N-acetylmuramoyl-L-alanyl-D-glutamyl-meso-diaminopimelic acid (UDP-MurNAc-Ala-Glu-meso-A2pm) with the concomitant hydrolysis of ATP to ADP and inorganic phosphate, yielding UDP-N-acetylmuramyl-pentapeptide. As MurF acts on a dipeptide, we exploited a phage display approach to identify peptide ligands having high binding affinities for the enzyme.     

Discrimination of Penicillium isolates by matrix-assisted laser desorption/ionization time-of-flight mass spectrometry fingerprinting

Matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOF MS) was used to generate highly reproducible mass spectral 'fingerprints' for twelve Penicillium species. Prior to MALDI-TOF MS analysis, eight replicate cultures of each Penicillium species were subjected to three one-minute bead-beating cycles in an acetonitrile/trifluoroacetic acid solvent. The mass spectra contained abundant peaks in the range of m/z 5000-20 000, and allowed unambiguous discrimination between species. In addition, a biomarker common to all Penicillium mass spectra was observed at m/z 13 900. Discriminant analysis using the MALDI-TOF MS data yielded classification error rates of 0% (i.e. 100% correct identification), indicating that MALDI-TOF MS data may be a useful diagnostic tool for the objective identification of Penicillium species of environmental and clinical importance.     

Fracture of thick laminated composites

The fracture of thick laminated graphite/epoxy composites has been the subject of an extensive research program. The program was divided into three major areas of investigation which included laminate thickness, laminate stacking sequence, and part-through surface flaws. The results from this program are reviewed with emphasis placed on their applicability to the design of thick laminated composite structures. Paper was presented at 1985 SEM Spring Conference on Experimental Mechanics held in Las Vegas on June 9–14, 1985.     

Non linear volume expansion in helium implanted erbium metal films

Large dimensional expansion has been observed at room temperature in erbium metal films implanted at room temperature with high fluences of helium. The interferometrically measured film thickness increases linearly with fluence up to a critical dose of 3 × 10¹⁷ He+/cm² (E = 160 keV) and is superlinear at higher fluences. Annealing at 400°C causes a reduction of the induced expansion for fluences below the critical dose without apparent release of helium. Annealing of samples implanted to fluences greater than 3.5 × 10¹⁷ He⁺/cm² causes accentuated expansion which is accompanied by formation and rupture of bubbles at the film surface.     

Localization of carboxyl groups at surface layer of carboxylated polymer emulsion particles by alkali treatment

For the purpose of localizing carboxyl groups from inside to particle surface, styrene — butyl acrylate — methacrylic acid (74.3/17.0/8.7, mol ratio) terpolymer emulsion was kept under pH 9 at different temperatures. The amount of carboxyl groups at the particle surface, As, was remarkably increased by the alkali-treatment above 35 °C. On the other hand, As value of the alkalitreated emulsion was decreased by keeping under ph 3 above 45 °C, although in the case of the original emulsion without the alkalitreatment, it was not changed by the acid-treatment. These results suggest that a part of polymer segments which have ionized carboxyl groups is dragged out at the surface by an increase in the affinity of the groups against water, and the dragged segments turn back into the inside again when the carboxyl groups are deionized.Part 97 of the series Studies on Suspension and Emulsion.     

Skeletons and Central Sets

Let be an open proper subset of Rⁿ. Its skeleton is the setof points with more than one nearest neighbour in the complementof its central set is the set of centres in maximal open ballsincluded in . Intuitively, if we think of as a land mass inwhich height is proportional to distance from the sea, its skeletonand central set can be thought of as corresponding to ridgesin the mountains of . In this note I discuss the metric andtopological properties of such sets. I show that any skeletonin Rⁿ is F, and has dimension at most n – 1, by any ofthe usual measures of dimension; that if is bounded and connected,its skeleton and central set are connected; and that separatesRⁿ iff its skeleton does iff its central set does. Any centralset in Rⁿ is a G set of topological dimension at most n –1. In the plane, I show that both skeletons and central setsare locally path-connected, and indeed include many paths offinite length. For any , its central set includes its skeleton;I give examples to show that the central set can be significantlylarger than the skeleton. 1991 Mathematics Subject Classification:54F99.