Sulfonated poly(aryl ether ether ketone ketone)s containing fluorinated moieties as proton exchange membrane materials

A series of sulfonated poly(aryl ether ether ketone ketone)s statistical copolymers with high molecular weights were synthesized via an aromatic nucleophilic substitution polymerization. The sulfonation content (SC), defined as the number of sulfonic acid groups contained in an average repeat unit, could be controlled by the feed ratios of monomers. Flexible and strong membranes in sodium sulfonate form could be prepared by the solution casting method, and readily transformed to their proton forms by treating them in 2 N sulfuric acid. The polymers showed high T_gs, which increased with an increase in SC. Membranes prepared from the present sulfonated poly(ether ether ketone ketone) copolymers containing the hexafluoroisopropylidene moiety (SPEEKK‐6F) and copolymers containing the pendant 3,5‐ditrifluoromethylphenyl moiety (SPEEKK‐6FP) had lower water uptakes and lower swelling ratios in comparison with previously prepared copolymers containing 6F units. All of the polymers possessed proton conductivities higher than 1 × 10^?2 S/cm at room temperature, and proton conductivity values of several polymers were comparable to that of Nafion at high relative humidity. Their thermal stability, oxidative stability, and mechanical properties were also evaluated. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 2299–2310, 2006     

贵金属对钴基催化剂上肉桂醛选择加氢反应的影响

 研究了贵金属改性的Co／γ－Al2O3催化剂上的肉桂醛选择加氢反应．结果表明，通过Pt，Pd和Ru贵金属改性，提高了催化剂的活性，但只有Pt改性的催化剂具有较高的选择性．w（Pt）＜0．5％时，催化剂的活性随着Pt含量的增加呈直线升高，当w（Pt）＝0．5％时，催化剂活性可提高近5倍，但催化剂的选择性变化很小．XRD结果表明，催化剂经还原后，γ－Al2O3上的钴主要为α－Co0．TPR结果表明，Pt的加入提高了Co3O4的还原性能，且Pt含量越高，Co3O4的还原温度越低．XPS结果表明，Pt改性的催化剂样品，其Co3O4大部分被还原为Co0．由于Pt与Co具有协同效应，故Pt改性的Co／γ－Al2O3催化剂既具有较高的活性，又具有很高的选择性．     

Fluorenyl-containing sulfonated poly(aryl ether ether ketone ketone)s (SPFEEKK) for fuel cell applications

A series of fluorenyl-containing sulfonated poly(aryl ether ether ketone ketone)s (SPFEEKK) were synthesized via aromatic nucleophilic substitution polymerization. The sulfonation content (SC) was controlled by the feed ratios of sulfonated and nonsulfonated monomers. Flexible and strong membranes in the sulfonic acid form were obtained from cast membranes in the sodium salt forms by treatment with acid. The thermal properties, water uptake, swelling ratio, water state, oxidative stability, proton conductivity and methanol permeability were investigated. All the polymers had proton conductivities greater than 1 × 10⁻² S/cm at room temperature, and the conductivity values of m-SPFEEKK-80 and p-SPFEEKK-80 were up to 1.86 × 10⁻¹ and 1.78 × 10⁻¹ S/cm at 100 °C. This series of polymers also possessed good dimensional stability in water and low methanol crossover.     

Crosslinking network structure governing particle shape and size distribution by one-step emulsion polymerization in the presence of particle coagulation

In this study, sub-200?nm, crosslinked latex particles with a narrow particle size distribution were prepared by one-step emulsion polymerization in the presence of particle coagulation. The relationship between the particle shape and particle coagulation was investigated by varying the time of crosslinking network structure formation and particle coagulation. Particles with irregular shapes such as doublet, triplet, and ellipsoid were obtained using divinylbenzene (DVB) and ethylene glycol dimethacrylate (EGDMA) as the crosslinking agents, because the crosslinking network structure of particles was formed before the particle coagulation. In contrast, latex particles with a uniform spherical shape were also prepared using triallyl isocyanurate (TAIC) or dihydrodicyclopentadienyl acrylate (DCPA) as the crosslinking agents by delaying the time of crosslinking network structure formation. Alternatively, uniform spherical latex particles were prepared by bringing forward the particle coagulation time using cationic initiator, 2, 2′-azobis (2-methylpropionamidine) dihydrochloride (AAPH). This study presents a new idea that would further broaden the application of particle coagulation in emulsion polymerization.     

Solvability of finite groups

H is called an ? _p -embedded subgroup of G, if there exists a p-nilpotent subgroup B of G such that H _p ∈ Syl _p (B) and B is ? _p -supplemented in G. In this paper, by considering prime divisor 3, 5, or 7, we use ? _p -embedded property of primary subgroups to investigate the solvability of finite groups. The main result is follows. Let E be a normal subgroup of G, and let P be a Sylow 5-subgroup of E. Suppose that 1 < d ? |P| and d divides |P|. If every subgroup H of P with |H| = d is ?₅-embedded in G, then every composition factor of E satisfies one of the following conditions: (1) I/C is cyclic of order 5, (2) I/C is 5′-group, (3) I/C ? A₅.     

An efficient algorithm for finding the largest chain graph according to a given chain graph

Chain graph (CG) is a general model of graphical Markov models. Some different chain graphs may describe the same conditional independence structure, then we say that these CGs are Markov equivalent. In 1990 Frydenberg showed that every class of Markov equivalent CGs has a CG which is called the largest chain graph with the greatest number of lines. This paper presents an efficient algorithm for finding the largest chain graph of the corresponding Markov equivalent class of a given CG. The computational complexity of the algorithm is O(n3). It is more efficient than the complexity O(n!) of the present algorithms. Also a more intuitive graphical characterization of the largest chain graph is provided based on the algorithm in this paper.     

Carboxyl-functionalized Nanocellulose Reinforced Nanocomposite Proton Exchange Membrane

Nanocellulose(NCC) was prepared through the acid hydrolysis of microcellulose(MCC) and was reacted with maleic anliydride to obtain carboxyl-functionized nanocellulose(MA-NCCs). The presence of .OH and .SO3H on the surface of rod-like MA-NCC was confirmed by Fourier transfonn infrared spectrometry(FTIR). Sulfonated poly(aryl ether ether ketone ketone)(Ph-SPEEKK) was synthesized with bis(4-fluorophenyl-methanone) and 2-phenylhydroquinone as monomer. MA-NCC/Ph-SPEEKK nanocomposite membranes with different MA-NCCs content were prepared, and their properties were characterized. Compared with Ph-SPEEKK, MA-NCC/Ph-SPEEKK nanocomposite membrane showed better mechanical and thermal properties and higher proton conductivity. The proton conductivity of the composite membrane with 4%(mass fraction) MA-NCCs under 80℃ was 0.095 S/cm. And its tensile strength reached 30.3 MPa, which was 21.2% higher than that of Ph-SPEEKK pure polymer membrane.     

Preparation and Properties of Hybrid Silane-crosslinked Sulfonated Poly(aryl ether ketone)s as Proton Exchange Membranes

A series of novel organic-inorganic hybrid proton-conducting electrolyte membranes with silane-crosslinked sulfonated poly(aryl ether ketone)(SC-SPAEK) networks was prepared via a simple procedure that includes solution casting and acid treatment. The organosilicon pendants of the silane-grafted SPAEK, which were expected to serve as coupling and crosslinking agents, were found to play a key role in the homogenous dispersion of inorganic particles and improved the performance of hybrid membranes. The hybrid membranes exhibited enhanced proton conductivity, and SC-SPAEK/TiO2-4 showed an extremely high proton conductivity of 0.1472 S/cm at 100℃. The crosslinked hybrid membranes also demonstrated good chemical resistance, oxidative stability, and mechanical properties. The crosslinked hybrid membranes with excellent comprehensive performance may be a promising material for proton exchange membrane fuel cells.     

Co/TiO2催化剂上肉桂醛的选择加氢

研究了超细TiO2负载的Co/TiO2催化剂上肉桂醛的选择加氢反应,讨论了Co负载量对肉桂醛加氢反应活性和选择性的影响.结果表明,随着Co负载量的增加,催化剂的活性和选择性提高.以CoCl2为前驱物的Co/TiO2催化剂的选择性要高于以Co(NO3)2为前驱物的Co/TiO2催化剂,而催化剂的活性正好相反.以CoCl2为前驱物的Co/TiO2催化剂上,Co负载量为10%和20%时,两者的选择性没有差别,只是前者的活性略低.TPR结果表明,两种前驱物的Co/TiO2催化剂在还原性能方面没有差别.XRD结果表明,TiO2表面上的Co均以Co3O4状态存在.两种不同前驱物的Co/TiO2催化剂在活性和选择性方面存在的差别是由于KCl的存在.     

弱M-可补子群对合成因子的影响

设G是有限群,P是G的一个Sylow p-子群,1<≤P。考虑|G|的素因子5和7,利用P的每一个阶为|D|的子群H在G中的弱M-可补性质,进一步探究了G的合成因子的结构。