Formulation–composition map of a lecithin-based emulsion

Formulation–composition map is an interesting tool to predict the nature of an emulsion, stability, viscosity and nevertheless to decide the mixing protocol of its ingredients. Information based on optimum formulation (environmental conditions at which the affinity of an emulsifier for oil and for aqueous phase is same), which is depicted through hydrophilic–lipophilic deviation (HLD) concept, is necessary to make a formulation–composition map of an emulsion. In order to apply this concept in food emulsions, it is necessary to determine characteristic constants of each component of the system, i.e. the aqueous phase, the oil phase and the emulsifier at equilibrium. In this work formulation–composition map of a sunflower oil–water–lecithin system, based on the knowledge of phase behavior of lecithin at equilibrium and emulsification, was made. The shape of inversion line on formulation–composition map was not the classical stair type rather an almost vertical inversion line at water-fraction (f_w) near 0.20 was observed. It was supposed to be linked to the viscosity of oil phase which was 50 times the viscosity of aqueous phase. Additionally, emulsions were of oil-in-water (O/W) type for f_w higher than 0.20, but their viscosity and the drop size behavior with respect to salt concentration as formulation variable did not show the existence of transitional inversion line on formulation–composition map. Such map in advance can certainly facilitate the guidelines for dynamic emulsification.     

Analysis of gamma-ray continuum spectra to determine the chemical composition

Neutron induced -ray spectra from various geological samples were analyzed to evaluate the usefulness of continuum spectra in deriving the chemical composition information. A fast Fourier transform technique has been used to estimate the signal content of selected energy bands of the continuum spectra. Monte Carlo calculations have been performed using the major -ray energy sources (due to Fe, Ca, Si and Al) to generate the corresponding detected -ray spectra. The experimental spectra are compared to the simulated spectra to check the consistency of the signal distribution between the peak and the continuum. The continuum above and below a chosen -ray line is calculated to find what fraction of the lower energy continuum is due to that line. The accuracy of the relative elemental concentrations determined by this method is confirmed through comparison with laboratory elemental analysis of the samples. It is found that using the continuum could greatly increase the sensitivity and precision of the measurement of elemental concentrations determined from -ray spectra of thick target sources, for spectra having peaks of poor statistical significance. However, for thin target sources or spectra with very good statistics in their peaks, this method may not be very advantageous.     

Extraction of ternary complexes of thorium(IV) with 3-phenyl-4-benzoyl-5-isoxazolone and neutral donors from nitric acid medium

The extraction behaviour of thorium(IV) from aqueous nitric acid employing 3-phenyl-4-benzoyl-5-isoxazolone (HPBI) in the presence of tri-n-octyl phosphine oxide (TOPO) as well as tri-n-butyl phosphate (TBP) in xylene medium was investigated. The extraction constant (log k(ex)) for the binary organic phase species Th(PBI)(4) was determined to be 8.26 which is by far the largest amongst the corresponding values known for other beta-diketones. The overall extraction constant (log K) for the ternary species Th(PBI)(4) TBP and Th(PBI)(4).2TOPO were estimated to be 14.96 and 20.96 respectively. An inverse correlation of the adduct formation constant (log K(s)) with the pK(a) of the beta-diketones, 2-thenoyltrifluoroacetone, 1-phenyl-3-methyl-4-benzoyl-5-pyrazolone and HPBI, was observed. The steric as well as the electronic effects of adduct formation have been discussed. Analytical application of HPBI for the separation of (234)Th radiotracer from natural uranium (99.3% (238)U) has been suggested.     

Removal of Cr(VI) from Aqueous Solution Using Activated Cow Dung Carbon

Removal of hexavalent chromium from aqueous medium by using activated cow dung carbon was studied. Cow dung was carbonized and activated by treating with concentrated H(2)SO(4) followed by heating for 24 h at 120 degrees C. The extent of adsorption was studied as a function of pH, contact time, amount of adsorbent, concentration of adsorbate, and temperature. At lower pH (<3.5), the prepared sorbent was capable of removing approximately 90% Cr(VI) at 5 ppm concentration from aqueous synthetic solution. The dynamics of migration of the sorbate ions from the bulk onto the sorbent surface was studied and the results obtained under various experimental conditions were found to follow standard adsorption isotherms. The reaction kinetics was found to be of first order. Copyright 2000 Academic Press.     

Thallium-205, carbon-13 and proton NMR parameters for some monomethylthallium(III) derivatives

Thallium-205, carbon-13 and proton NMR spectra have been determined for some monomethylthallium(III) derivatives CH₃TlX₂ (X  anion) permitting comparison of NMR parameters in the series CH₃TlX₂, (CH₃)₂TlX, (CH₃)₃Tl.     

Colorimetric method for the determination of captafol (difolatan) in commercial formulations and residues on grains and apples.

A simple and rapid colorimetric method for the microdetermination of captafol (difolatan), based on its reaction with a dithiocarbamate, has been developed. The bright yellow colour which develops instantaneously on mixing the fungicide with the reagent is stable for at least 12 h. The method has been successfully adapted to the determination of captafol in its formulated products and residues on grains and apples.     

Regulation of cell cycle drivers by Cullin-RING ubiquitin ligases

The last decade has revealed new roles for Cullin-RING ubiquitin ligases (CRLs) in a myriad of cellular processes, including cell cycle progression. In addition to CRL1, also named SCF (SKP1-Cullin 1-F box protein), which has been known for decades as an important factor in the regulation of the cell cycle, it is now evident that all eight CRL family members are involved in the intricate cellular pathways driving cell cycle progression. In this review, we summarize the structure of CRLs and their functions in driving the cell cycle. We focus on how CRLs target key proteins for degradation or otherwise alter their functions to control the progression over the various cell cycle phases leading to cell division. We also summarize how CRLs and the anaphase-promoting complex/cyclosome (APC/C) ligase complex closely cooperate to govern efficient cell cycle progression.Subject terms: Drug development, Targeted therapies, Origin firing, Chromatin remodelling, Post-translational modifications     

Ab initio simulation of benzene Raman intensities

C₆H₆ Raman scattering activities calculated from harmonic model ab initio Hartree–Fock 6–311 ++ G(d, p) polarizability derivatives (and harmonic force fields calculated at the same level) accurately simulate experiment (to within 1% for the a_1g modes). Accurate predictions are also made for the e_2g modes (to within 5% for ν₇ and ν₉, and more poorly for ν₆ and ν₈ [in Fermi resonance with ν₆ + ν₁]) and for the e_1g out-of-plane mode, ν₁₀. Only the ν₆ in-plane CCC bending mode scattering activity is found to be anomalous. Systematic variation of the basis set indicates that the benzene scattering activities and depolarization ratios are strongly dependent on inclusion of both carbon and hydrogen atom diffuse functions in the basis set. Predictions are also made for ¹²C₆D₆ and for unmeasured intensities in ¹³C₆H₆. Measurements of a_1g mode scattering activities in the latter molecule are predicted to be useful in testing the harmonic Hartree–Fock Raman intensity model.     

Determination of plutonium by secondary coulometric titration with internally generated iron(II)

The method for plutonium determination based on secondary controlled-potential coulometry, as described by SHULTS, is applied for analysis in the range of 0.1–5 mg plutonium. The method involves the oxidation of plutonium to Pu(VI) with perchloric acid followed by its reduction by an internally generated ferrous mediator. This is a two step procedure, involving the reduction of Pu(VI) and Fe(III) to a mixture of Pu(III) and Fe(II), followed by the oxidation of Pu(III) and Fe(II) to Pu(IV) and Fe(III), respectively. The net results is the reduction of Pu(VI) to Pu(IV), measured as the difference between the currents consumed during the reduction and oxidation steps. The original method of SHULTS involves 10–25 mg plutonium for each determination. Since the present method is intended for the analysis of smaller amounts of plutonium, the oxidation procedure described in the original version had to be modified. The method is found to work satisfactorily with a precision better than 0.1% at 5 mg level and 1.2% for 0.1 mg plutonium.