Characteristics investigation on heat transfer growth of sonochemically synthesized ZnO-DW based nanofluids inside square heat exchanger

Journal of Thermal Analysis and Calorimetry - In recent decades, the growth of heat transfer using nanomaterials in the conventional base fluid has caught the attention of researchers...     

The effect of rapid rotation on a vertical bridgman furnace at large Rayleigh number

In quasi-steady operation, convection currents in a Bridgmandevice, used for producing a semi-conductor crystal, createinhomogeneities that may make the crystal unusable. It has oftenbeen suggested that additional forces due to rotation or magnetismmight be efficacious in reducing the segregation of the elementsof the alloy. It has been found that, over a wide range of rotationrates, there is no improvement in performance due to rotationabout the vertical axis. However, numerical results that havebeen obtained previously (Lee & Pearlstein, J. Crys. Growth240, 2002) indicate that, when effects of centrifugal buoyancyare introduced, a substantial reduction in segregation is achieved.In the work reported here, by contrast, in which we extend previouslarge-Rayleigh-number asymptotic analysis to include centrifugalbuoyancy, we find no improvement in radial segregation, butrather increasing segregation with increasing rotation rate.     

用^60Co放射源检测油垢厚度的初步实验研究

本文用石蜡模拟油垢，用^60Co放射源的1．25MeV平均能量的γ射线垂直入射，以一定的散射角和不同的探测立体角接收散射γ光子敫．发现散射γ计数与被测石蜡厚度之间存在不同的线性关系．结果发现，放射源与探测器之间屏蔽的好坏和合理的探测距离对提高线性度有很大关系．本实验测得最佳线性相关系数平方值为0．9981，平均测量精度为1．26mm．这对研究散射法检测油垢厚度和选择合适的探测距离提供了实验基础．     

Morin applied in speciation of aluminium in natural waters and biological samples by reversed-phase high-performance liquid chromatography with fluorescence detection

A reversed-phase high-performance liquid chromatographic method with fluorescence detection for the determination of labile monomeric aluminium has been developed through pre-column complexation using morin as the analytical reagent. The highly fluorescent aluminium-morin complex (excitation wavelength 418 nm, emission wavelength 490 nm) was separated on a Spherisorb ODS 2 column with an eluent consisting of 30% methanol and 70% water (pH 1.0 with perchloric acid). The most remarkable point of this protocol was that only the most toxic aluminium species, that is, free aqua-aluminium ion and its monomeric hydroxo complex ions, selectively respond among various aluminium complexes. This strategy has been successfully applied to direct fractionation of the toxic aluminium in natural waters and biological samples without any pretreatment.     

Application of simultaneous excitation/detection to generate real-time excitation profiles in Fourier transform ion cyclotron resonance mass spectrometry

Simultaneous excitation/detection (SED), which permits observation of ion motion during an excitation event, is used to generate real-time Fourier transform ion cyclotron resonance (FTICR) excitation profiles that track the radial extent of ion motion in a trapped-ion cell. The conventional FTICR excitation profile is collected in a series of individual experiments in which peak magnitude is monitored as excitation voltage is increased. In contrast, SED permits the single-scan detection of ion cyclotron motion within the trapped-ion cell and consequently yields the data that produces a real-time excitation profile. Data analysis techniques are presented that facilitate conversion of a time domain SED profile into an excitation profile. An order of magnitude decrease in the amount of time is required to acquire an excitation profile, while the precision of the measurement is improved. To demonstrate the utility of the technique, it is applied to the study of axial and radial ion loss mechanisms for argon, benzene, and acetophenone ions under different conditions. SED excitation profiles are also used to illustrate the facility of quadrupolar excitation for minimizing radial ion loss.     

Comparison of the Parallel Tempering Algorithm and Multicanonical Method as Applied to Coarse-Grained Off-lattice Models for Folding Heteropolymers

We have performed Parallel Tempering simulations of hydrophobic-hydrophilic heteropolymers with a simple effective, coarse-grained off-lattice model with the selected monomers and compare the global energy minimums found with Parallel Tempering algorithm with the lowest energy states identified within the multicanonical algorithm.     

The snowblower problem

We introduce the snowblower problem (SBP), a new optimization problem that is closely related to milling problems and to some material-handling problems. The objective in the SBP is to compute a short tour for the snowblower to follow to remove all the snow from a domain (driveway, sidewalk, etc.). When a snowblower passes over each region along the tour, it displaces snow into a nearby region. The constraint is that if the snow is piled too high, then the snowblower cannot clear the pile.We give an algorithmic study of the SBP. We show that in general, the problem is NP-complete, and we present polynomial-time approximation algorithms for removing snow under various assumptions about the operation of the snowblower. Most commercially available snowblowers allow the user to control the direction in which the snow is thrown. We differentiate between the cases in which the snow can be thrown in any direction, in any direction except backwards, and only to the right. For all cases, we give constant-factor approximation algorithms; the constants increase as the throw direction becomes more restricted. Our results are also applicable to robotic vacuuming (or lawnmowing) with bounded-capacity dust bin.     

Experimental measurement of the strength of a C alpha-H...O bond in a lipid bilayer

Due to the apolar nature of the lipid bilayer, the weak Calpha-H...O H-bond is thought to contribute significantly toward the stability of transmembrane helical bundles such as glycophorin A (GPA). Here for the first time we measured the strength of such a bond, using vibrational frequency shifts of a dimeric and nondimeric variants of GPA containing a Gly CD2 label. Although the resulting estimated bond strength of 0.88 kcal/mol is relatively weak, several such bonds could contribute significantly toward bundle stabilization.     

激光尾场第一周期加速带电粒子模拟

在关于激光尾场加速(LWFA)的很多文献中,都暗示了尾场有周期性结构.可是激光驱动尾场可以不是周期性的,尾场第一周期可以捕获和加速外来电子束.Esirkepov和Bulanov等人提出了带电粒子在激光高斯脉冲驱动尾场第一周期加速的处理方法.本文在此理论基础上进一步讨论电子在尾场第一周期中能获得的最大能量与激光脉冲的强度和脉冲的波长之间的关系.结果显示,捕获电子最大能量与脉冲激光强度成正比.适当的选择脉冲激光波长也直接影响到捕获电子的最大能量值.     

Controlled hydrothermal growth of ZnO nanostructures by sequestering the Zn metal ions with the chelating agent EDTA

In the present work, a controlled growth of ZnO nanostructures by manipulating Zn metal ion concentration by the chelating action of ethylene diaminetetra acetic acid in hydrothermal method is studied. EDTA produces metal–chelate complex by the formation of bidentate ligand with Zn²⁺ in the solution and diminishes the reactivity of Zn metal cations. Concentration of EDTA in the mother solution was varied in different ranges like 3, 5 and 10 mM while retaining the zinc metal salt and the NaOH concentration the same. Three different morphologies of wurtzite structured ZnO nanostructures such as nanorods-bunch, separate/discrete uniformly sized hexagonal nanorods and tapered flower petals like shapes are achieved by 3, 5 and 10 mM strengths of EDTA, respectively. The medium concentration 5 mM of EDTA is found to have moderate control over producing ZnO nanostructures of uniform diameter and a high aspect (length to diameter) ratio. An array of vertically aligned free standing ZnO nanorods with uniform spacing is successfully achieved by the addition of 5 mM of EDTA in the mother solution and the same is studied for its fluorescence property at an excitation of 325 nm and it has exhibited a characteristic UV emission of ZnO around 383 nm.