Thermodynamic excess quantities in the adsorption of sodium alkylsulfonates at the air-solution interface

Colloid and Polymer Science - Data on the surface tension of sodium alkylsulfonate solutions at different temperatures and surfactant concentrations are presented. By applying the thermodynamic...     

The C(2)1pi(u) state of Na2 molecule studied by polarization labelling spectroscopy method

The C1pi(u) <-- X1sigma(g)+ system of Na2 is studied by the polarization labelling spectroscopy technique. Accurate molecular constants are derived for the observed levels nu = 0-12, J = 12-100 in the C1pi(u) state.     

Electron beam crosslinking of non-lead PVC formulations

PVC samples with lead-free and lead-base stabilizer, containing TMPTMA (trimethylolpropane trimethacrylate) as a crosslinker and DOP (2-ethylhexyl phthalate) as a plasticizer, were electron beam treated at different doses (2–200 kGy) and characterized to evaluate crosslinking and other several properties, as a continuation of our previously reported paper, where these PVC formulations, typical for wire and cable applications, underwent gamma irradiation. The PVC was formulated with two different stabilizing systems: Ca/Zn and dibasic lead phthalate for comparison, to use them as jackets for a 22 wire gage (AWG). Small samples of the jacketed wires were irradiated in an industrial Dynamitron electron accelerator for the corresponding doses, along with two dosimetric systems: radiochromic thin film and alanine pellets dosimeters. The maximum dose applied was decided as the crosslinking increased, until the gel content was stable. The dose of 200 kGy was the condition for the highest crosslinking, so most of the wire was irradiated at such dose. Chemical and mechanical evaluations were carried out to the irradiated wire. The results show that 200 kGy was too high dose for the materials, since an important degradation is observed for the Ca/Zn systems. Unfortunately, such dose affects basically to CaZn formulations, which showed much poorer performance than classical lead-containing compositions. The results also indicate that gel content is not the best way of deciding the optimum condition for irradiation.     

Synthesis of fluorinated drimanes. Preparation of 9αF-drimenin

A stereoselective approach to the 9α-fluorinated analogue of the natural drimane sesquiterpene drimenin starting from β-ionone is described. β-Ionone is transformed into a bicyclic β-cetoester from which 9αF-drimenin is prepared through stereoselective electrophilic fluorination at the C-9 with N-fluorobenzenesulfonimide followed by Wittig methylenation, allylic bromination, bromine-hydroxyl exchange and γ-lactonization.     

The molecular structure of 2-methylbenzotriazole (2MeBzTr) in connection with the x-ray structure of 2MeBzTr.HBF4.H2O

The fluoroborate of 1H-2-methylbenzotriazolium monohydrate crystallizes in the Pbca space group [Z = 8, a = 16.734(3), b = 19.153(9), c = 6.937(1) Å], The hydrogen bond network between the three molecules, 2MeBzTr, HBF₄ and H₂O, corresponds to a situation intermediate between the fluoroborate of a protonated benzotriazole (BF4^?.2MeBzTrH⁺) and a neutral benzotriazole hydrogen-bonded to fluoroboric acid (HBF₄,2MeBzTr). The behaviour of the title compound in solution is also intermediate between these two extreme situations. Thus, the present compound is one of the rare examples of a proton solvated only by very weak hydrogen bond acceptors.     

Spectrophotometric determination of selenium(IV) with 5,5-dimethyl-1,3-cyclohexanedione

5,5-Dimethyl-1,3-cyclohexanedione (dimedone) reacts in acid aqueous solution with selenium(IV) to give a benzoxaselenol which has an absorption maximum at 313 nm with a molar absorptivity of 4.00 x 10(3) l.mole(-1).cm(-1). The compound is extractable into chloroform, to give a solution with an absorption maximum at 300 nm with a molar absorptivity of 3.77 x 10(3) l.mole(-1).cm(-1). The calibration graph is linear up to 30 ppm selenium, with a detection limit of 0.1 ppm in the final solutions. Of the various other ions tested, only iron(III) interferes at all concentrations but the addition of 1000 ppm fluoride will mask 50 ppm Fe(3+). The method has good reproducibility, with a relative standard deviation of 1.0% for pure solutions. The method has been applied to the analysis of fire-refined copper.     

Charge-charge and cation-<Emphasis Type="Italic">π</Emphasis> interactions in ligand binding to G protein-coupled receptors

To study the importance of charge–charge and cation-π interactions for the binding of positively charged amine ligands to their receptors, the energies of interaction between [(CH₃)₄–N]⁺, [(CH₃)₃–NH]⁺, and [(CH₃)₄–NH₃]⁺ and acetate, as a model of Asp and Glu, and with benzene, as a model of aromatic side chains, were obtained at the MP2/aug-cc-pVDZ level of theory. The free energies of solvation in water were also calculated for the different amines. It was found that, although primary amines form stronger charge–charge interactions with acetate than tertiary or quaternary amines, the difference is not large enough to compensate their higher solvation energy. Quaternary amines show the weakest interaction with acetate. However, their alkyl groups can interact with various aromatic groups, enhancing ligand binding to the receptor. The analysis was completed with MD calculations on amine binding to the G protein-coupled receptors β₂AR and CCR5. The calculations on the model systems were found to be in good agreement with the simulations of the ligand-receptor complexes. Contribution to the Serafin Fraga Memorial Issue.     

Photostability of a photochromic naphthopyran dye in different sol-gel prepared ormosil coatings

A photochromic naphthopyran derivative was embedded in sol-gel prepared thin ormosil films. The resulting samples show high transparency and exhibit a strong red colouration upon irradiation with UV light. The photostability of the photochromic molecules is strongly related to the nature of the embedding ormosil matrix. The introduction of organic functional groups into the inner pore surface of the matrix allows tailoring the chemical environment where the dye molecules will be allocated, in terms of the effectiveness of the interaction between the photochromic molecules and the Si-OH groups on the surface of the pores, affecting the stability of the molecules upon prolonged exposition to UV light. The photostability of the molecules was increased in matrices functionalized with larger organic groups, or with larger amount of modifying groups. In this way the photodegradation of the photochromic molecules could be reduced by a factor of 5, as compared with the photodegradation of the molecules in unfunctionalized silica matrix.     

Novel Iron Oxide Nanoparticles Induce Ferroptosis in a Panel of Cancer Cell Lines

The use of nanomaterials rationally engineered to treat cancer is a burgeoning field that has reported great medical achievements. Iron-based polymeric nano-formulations with precisely tuned physicochemical properties are an expanding and versatile therapeutic strategy for tumor treatment. Recently, a peculiar type of regulated necrosis named ferroptosis has gained increased attention as a target for cancer therapy. Here, we show for the first time that novel iron oxide nanoparticles coated with gallic acid and polyacrylic acid (IONP–GA/PAA) possess intrinsic cytotoxic activity on various cancer cell lines. Indeed, IONP–GA/PAA treatment efficiently induces ferroptosis in glioblastoma, neuroblastoma, and fibrosarcoma cells. IONP–GA/PAA-induced ferroptosis was blocked by the canonical ferroptosis inhibitors, including deferoxamine and ciclopirox olamine (iron chelators), and ferrostatin-1, the lipophilic radical trap. These ferroptosis inhibitors also prevented the lipid hydroperoxide generation promoted by the nanoparticles. Altogether, we report on novel ferroptosis-inducing iron encapsulated nanoparticles with potent anti-cancer properties, which has promising potential for further in vivo validation.