Structural Changes of Cellulose Crystallites Induced by Mercerisation in Different Solvent Systems; Determined by Powder X-ray Diffraction Method

The completeness of mercerisation can be evaluated by investigating the changes in the crystalline regions of cellulose from cellulose I (C-I) to cellulose II (C-II) by the X-ray powder diffraction method. Mercerisation experiments in four different solution systems: ethanol/water, acetone, DMSO and xylene, are reported. Also the effect of some additives, external pressure, treatment time and alkalisation temperature were studied. In two-phase solvent systems, structural changes of cellulose crystallites depended primarily on the distribution and solubility of sodium hydroxide in the solvent phases. The sodium hydroxide concentration in the hydrophilic phase must exceed 7–8 w/w-% before complete crystal change from C-I to C-II can occur. The precipitation of sodium hydroxide due to high concentration prevents the successful use of one-phase ethanol/water system in slurry process. On the contrary, the 2-propanol/water/sodium hydroxide system separates into two layers; to the water-rich lower layer and the 2-propanol-rich upper layer, where the sodium hydroxide remains mainly in the water-rich lower layer. This prevents the precipitation of sodium hydroxide and promotes the alkalisation of cellulose. Ammonium chloride and ammonium hydroxide clearly had a positive effect by promoting the crystal changes, however, the urea concentration used in this study was obviously too small. In the advantageous two-phase 2-propanol/water systems, the alkalisation time was only 15 min when the treatment temperature was kept between 0 and 10 °C. Reduced external pressure was found to have a small but still detectable positive effect on cellulose alkalisation while over-pressure prevented crystal changes.     

Uranocenium: Synthesis,Structure, and Chemical Bonding

Abstraction of iodide from [(η⁵‐C₅ⁱPr₅)₂UI] ( 1 ) produced the cationic uranium(III) metallocene [(η⁵‐C₅ⁱPr₅)₂U]⁺ ( 2 ) as a salt of [B(C₆F₅)₄]^?. The structure of 2 consists of unsymmetrically bonded cyclopentadienyl ligands and a bending angle of 167.82° at uranium. Analysis of the bonding in 2 showed that the uranium 5f orbitals are strongly split and mixed with the ligand orbitals, thus leading to non‐negligible covalent contributions to the bonding. Investigation of the dynamic magnetic properties of 2 revealed that the 5f covalency leads to partially quenched anisotropy and fast magnetic relaxation in zero applied magnetic field. Application of a magnetic field leads to dominant relaxation by a Raman process.     

Solvent exchange in thermally stable resorcinarene nanotubes

The assembly of C-methyl resorcinarene into a tubular supramolecular solid-state structure, its thermal stability, and its hosting properties are reported. Careful control of the crystallisation conditions of C-methyl resorcinarene and 1,4-dimethyl-1,4-diazoniabicyclo[2.2.2]octane (1,4-dimethyl DABCO) dibromide leads to a formation of two crystallographically different, but structurally very similar, solid-state nanotube structures. These structures undergo a remarkable variety of supramolecular interactions, which lead to the formation of 0.5 nm diameter nonpolar tubes through the crystal lattice. The formation of these tubes is templated by suitably sized small alcohols, namely, n-propanol, 2-propanol, or n-butanol. The self-assembly involves close pi...pi interactions between the adjacent resorcinarenes, and C--H...pi and cation...pi interactions between the resorcinarenes and the guest 1,4-dimethyl DABCO dications. The crystals of these supramolecular tube structures are thermally very stable and the included solvent alcohol can be removed from the tubes without breaking the single-crystalline structure of the assembly. After removal of the solvent molecules the tubes can be filled with other small, less polar solvent molecules such as dichloromethane.     

Spectrofluorometric trace determination of cerium(III) in sodium hexametaphosphate solutions

The use of sodium hexametaphosphate in the spectrofluorometric determination of trace amounts of cerium(III) ions is described. Sodium hexametaphosphate acts as a specific reagent for enhancing the fluorescence intensity of cerium(III) in aqueous solutions. The apparent excitation and fluorescence wavelength used are 304 and 344 nm, respectively. Maximum fluorescence intensity is obtained by irradiating Ce(III) dissolved in 5.346 g/l sodium hexametaphosphate solution at room temperature. The fluorescence varies linearly with the concentration of cerium(III) in the range of 0.001-60 microg/ml. The coefficient of variation for 45 microg/ml Ce(III) in 5.346 g/l sodium hexametaphosphate solution is 1. The quenching effects of other lanthanides and some inorganic anions are given. This technique permits a direct and rapid determination of cerium(III) in rare earth mixtures and cerium concentrates.     

Nickel as a Lewis Base in a T‐Shaped Nickel(0) Germylene Complex Incorporating a Flexible Bis(NHC) Ligand

Flexible, chelating bis(NHC) ligand 2 , able to accommodate both cis‐ and trans‐coordination modes, was used to synthesize ( 2 )Ni(η²‐cod), 3 . In reaction with GeCl₂, it produced ( 2 )NiGeCl₂, 4 , featuring a T‐shaped Ni⁰ and a pyramidal Ge center. Complex 4 could also be prepared from [( 2 )GeCl]Cl, 5 , and Ni(cod)₂, in a reaction that formally involved Ni–Ge transmetalation, followed by coordination of the extruded GeCl₂ moiety to Ni. A computational analysis showed that 4 possesses considerable multiconfigurational character and the Ni→Ge bond is formed through σ‐donation from the Ni 4s, 4p, and 3d orbitals to Ge. (NHC)₂Ni(cod) complexes 9 and 10 , as well as (NHC)₂GeCl₂ derivative 11 , incorporating ligands that cannot accommodate a wide bite angle, failed to produce isolable Ni–Ge complexes. The isolation of ( 2 )Ni(η²‐Py), 12 , provides further evidence for the reluctance of the ( 2 )Ni⁰ fragment to act as a σ‐Lewis acid.     

Discovery of a novel one-step RuO4-catalysed tandem oxidative polycyclization/double spiroketalization process. Access to a new type of polyether bis-spiroketal compound displaying antitumour activity

Four novel C₃₀ polyether bis-spiroketals, displaying selective inhibition of the BT474 breast-derived cancer cell line, have been obtained from squalene through an unprecedented one-step, RuO₄-catalysed, cascade process characterised by a tandem oxidative pentacyclization/double oxidative spiroketalization sequence. Preliminary studies indicate that the Ru-mediated spiroketalization steps proceed with retention of configuration at the forming spirocentres. A similarity with the oxidative behaviour of PCC has been disclosed.     

Fluorimetric trace determination of cerium(III) with sodium triphosphate

Sodium triphosphate acts as a specific reagent for enhancing the fluorescence intensity of cerium(III). The purpose of this study was to investigate the spectrofluorimetric determination of trace amounts of Ce(III) in sodium triphosphate solution. The excitation and emission wavelengths are 303.5 nm and 353 nm respectively. Optimum sodium triphosphate concentration is found to be 0.074 g l(-1) at room temperature. The fluorescence varies linearly with the concentration of cerium(III) in the range 0.001-45 mug ml(-1). The detection limit is 9.4 x 10(-4)mug ml(-1). The relative standard deviations for 30 mug ml(-1) and 0.05 mug ml(-1) Ce(III) in 0.074 g l(-1) sodium triphosphate solution are 1.1% and 0.72% respectively. Quenching effects of other lanthanides and some inorganic anions are described. This method is a direct and rapid analytical method for the determination of Ce(III) in rare earth mixtures and cerium concentrates.     

Structurally diverse second-generation [2.2]paracyclophane ketimines with planar and central chirality: syntheses, structural determination, and evaluation for asymmetric catalysis

A set of 20 novel [2.2]paracyclophane ketimines with planar and central chirality has been synthesized from enantiomerically pure and racemic 5-acyl-4-hydroxy[2.2]paracyclophane and alpha-branched chiral amines. Their X-ray structures were determined to elucidate the three-dimensional structures and the absolute configuration. The ketimines were used as catalysts in the asymmetric 1,2-addition reactions of diethylzinc with substituted benzaldehydes to furnish chiral alcohols in up to 95 % ee.