On a category of module bundles

It is shown, that the category ℰ _A (X) ofA-bundles over a topological spaceX is an additive pseudo-Abelian category for each Waelbroeck algebraA. This research was supported by Greek State Scholarship Foundation and Estonian Science Foundation grant 6205.     

Experimental investigation and theoretical modeling of liquid entrainment in a horizontal tee with a vertical-up branch

This article describes a comprehensive literature review of liquid entrainment in horizontal pipes with vertical-up branches. Deficiencies in the available data and correlations were identified. The Air–water Test Loop for Advanced Thermal–hydraulic Studies (ATLATS) was constructed and entrainment onset and steady-state data were collected for a wide range of flow conditions. Using new insights gained from experimental testing, the authors developed a model for predicting the onset of entrainment and steady-state entrainment rate. Previously published correlations, along with the new model, are compared against all available data. The new model shows very good agreement with the onset data, but is not very good at predicting branch quality at high liquid flow rates.     

Concerning seven and eight mutually orthogonal Latin squares

In this paper, three new direct Mutually Orthogonal Latin Squares (MOLS) constructions are presented for 7 MOLS(24), 7 MOLS(75) and 8 MOLS(36); then using recursive methods, several new constructions for 7 and 8 MOLS are obtained. These reduce the largest value for which 7 MOLS are unknown from 780 to 570, and the largest odd value for which 8 MOLS are unknown from 1935 to 419. © 2003 Wiley Periodicals, Inc.     

Surface free energies of electroless Ni–P based composite coatings

Surface free energy of a solid surface gives a direct measure of intermolecular interactions at interfaces and has a strong influence on adsorption and adhesion behaviour. However few data are available for the surface free energies of electroless Ni–P based composition coatings. In this paper, the electroless Ni–P, Ni–P-surfactant, Ni–Cu–P, Ni–P–PTFE and Ni–Cu–P–PTFE composite coatings were prepared under various coating conditions. The chemical compositions, surface morphology and thickness of the coatings were measured using an energy dispersive X-ray microanalysis (EDX), a scanning electron microscope (SEM) and a digital micrometer respectively. The contact angles of water, diiodomethane and ethylene glycol on the coatings were measured automatically using dataphysics OCA-20 contact angle analyser. The surface free energy of the coatings and their components (e.g. dispersion, polar or acid/base portions) were calculated using various methods. The experimental results showed that the incorporation of surfactant or PTFE particles into Ni–P matrixes has a significant influence on the surface free energy of the coatings, while the incorporation of copper into Ni–P matrixes has no significant influence on the surface free energy of the coatings.     

Structural manipulation of pyrochlores: Thermal evolution of metastable Gd2(Ti1−yZry)2O7 powders prepared by mechanical milling

The structural and microstructural characteristics of metastable Gd₂(Ti_1−yZr_y)₂O₇ powders prepared by mechanical milling have been studied by a combination of XRD and Raman spectroscopy. Irrespective of their Zr content, as-prepared powder phases present an anion-deficient fluorite-type of structure as opposed to the pyrochlore equilibrium configuration obtained for the same solid solution by other synthetic routes. These fluorites are stable versus thermal activation, at least up to temperatures of 800 °C. For the Ti-rich compositions, thermal treatments at higher temperatures facilitate the rearrangement of the cation and anion substructures and the relaxation of mechanochemically induced defects whereas for compositions with high Zr content, the fluorite crystal structure is retained even at temperatures as high as 1200 °C. Interestingly enough, transient pyrochlores showing a very unusual cation distribution were observed during the thermally induced defect-recovery process.     

Representations of bornological algebras

Bounded representations of bornological algebras are considered. The left and right bornological radicals in bornological algebras are introduced. It is shown that the left (right) bornological radical of a bornological algebra A is equal to the intersection of all bornologically closed maximal regular left (respectively, right) ideals of A, and both these radicals of A and the Jacobson radical of A coincide if A is an advertive and simplicial bornological algebra (in particular, a bornological Q-algebra). Bibliography: 16 titles. Published in Zapiski Nauchnykh Seminarov POMI, Vol. 326, 2005, pp. 9–22.