Enantioselective enzymatic resolution of racemic alcohols by lipases in green organic solvents

The effects of two eco-friendly solvents, 2-methyltetrahydrofuran (MeTHF) and cyclopentyl methyl ether (CPME), on the enzyme activity and enantioselectivity of Novozym 435, Candida rugosa lipase (CRL), Porcine pancreas lipase (PPL), Lipase AK, Lipase PS, and Lipozyme, a series of commercial lipases, in the enantioselective transesterfications of racemic menthol, racemic sulcatol and racemic α-cyclogeraniol were studied. Vinyl acetate was chosen as the acyl donor and the reactions were carried out at water activity 0.06. The activity of lipases in CPME was similar to that observed in other largely employed organic solvents [toluene and tert-butyl methyl ether (MTBE)], and was slightly lower in MeTHF. However, for most of the lipases tested, the enantioselectivity was higher in the eco-friendly solvents. Lipase AK exhibited a high enantioselectivity (E = 232) for the resolution of racemic menthol but the reaction rate was low. Lipase formulation (the enzyme was frozen and lyophilized in potassium phosphate buffer without and with 5% (w/v) of sucrose, d-mannitol, or methoxy poly(ethylene glycol)) was tested with this lipase in order to improve its activity, which increased up to 4.5 times, compared to the untreated enzyme. CALB was found to be a useful biocatalyst for the resolution of racemic sulcatol, where high activity and enantioselectivity were obtained (E ≥ 1000). For the resolution of the racemic primary alcohol α-cyclogeraniol, most of the lipases tested were active but not enantioselective, except lipase PS which displayed a moderate enantioselectivity (E = 19). The effect of the presence of a low percentage of two ionic liquids (ILs) 1-Butyl-3-methylimidazolium bis(trifluoromethylsulfonyl)imide ([BMIM][TFSI]) (5% (v/v)) and 1-Butyl-3-methylimidazoliumtetrafluoroborate ([BMIM][BF4]) (1% (v/v)) in the medium was also investigated. Only in the case of CRL the ILs slightly increased the enantioselectivity from E = 91 to E = 103 and E = 120 for [BMIM][TFSI] and [BMIM][BF4], respectively. However, in all cases ILs caused a decrease of enzyme activity.     

Efficient <Emphasis Type="Italic">Candida rugosa</Emphasis> lipase immobilization on Maghnite clay and application for the production of (<Emphasis Type="Italic">1R</Emphasis>)-(−)-Menthyl acetate

This work focused on the identification of natural, economical, and efficient supports for immobilization of Candida rugosa lipase (CRL) to catalyze the resolution of (±)-menthol. To this purpose, CRL has been immobilized on natural montmorillonite from Algeria (Maghnite-H), ion-exchange resins (Amberjet^®1200-H and Amberjet^®4200-Cl), and diatomaceous earth (Celite^®545). After a preliminary screening of supports, the immobilization of CRL led to a markedly improved enantioselectivity. Excellent enantioselectivity (E ≥ 134) was achieved by the four supported lipases (E = 68 for free enzyme). Compared to the three other supports tested, higher enantioselectivity was observed with Maghnite-H used as immobilization matrix. In this work, the effects of solvent, reaction time, and temperature, on the conversion as well as on enantioselectivity were investigated. The maximum of conversion (% C = 43%) with high enantiomeric excess of products (eep > 99) was obtained when the reaction is catalyzed by CRL immobilized on Maghnite-H at 30 °C for 24 h, and using toluene as selected solvent. Immobilized CRL on Maghnite-H exhibited good thermostability over a wide temperature range (30–90 °C) compared to the free one. These results suggest that CRL immobilized on Maghnite-H has good potential as biocatalyst for the production of (1R)-(?)-menthyl acetate.     

Cellulose Acetate-g-Polycaprolactone Copolymerization Using Diisocyanate Intermediates and the Effect of Polymer Chain Length on Surface,Thermal, and Antibacterial Properties

The need for biodegradable and biocompatible polymers is growing quickly, particularly in the biomedical and environmental industries. Cellulose acetate, a natural polysaccharide, can be taken from plants and modified with polycaprolactone to improve its characteristics for a number of uses, including biomedical applications and food packaging. Cellulose acetate-g-polycaprolactone was prepared by a three-step reaction: First, polymerization of ε-caprolactone via ring-opening polymerization (ROP) reaction using 2-hydroxyethyl methacrylate (HEMA) and functionalization of polycaprolactone(PCL) by introducing NCO on the hydroxyl end of the HEMA-PCL using hexamethyl lenediisocyanate(HDI) were carried out. Then, the NCO–HEMA-PCL was grafted onto cellulose acetate (using the “grafting to” method). The polycaprolactone grafted cellulose acetate was confirmed by FTIR, the thermal characteristics of the copolymers were investigated by DSC and TGA, and the hydrophobicity was analyzed via water CA measurement. Introducing NCO-PCL to cellulose acetate increased the thermal stability. The contact angle of the unreacted PCL was higher than that of cellulose acetate-g-PCL, and it increased when the chain length increased. The CA-g-PCL50, CA-g-PCL100, and CA-g-PCL200 showed very high inhibition zones for all three bacteria tested (E. coli, S. aureus, and P. aeruginosa).     

Analysis of cypermethrin residues and its main degradation products in soil and formulation samples by gas chromatography-electron impact-mass spectrometry in the selective ion monitoring mode

A fast, simple and inexpensive sample preparation method based on the matrix solid-phase extraction (SPE) technique is proposed for the isolation of cypermethrin and its metabolite residues from soils. Both the extraction and clean-up procedures were carried out in two steps and target compounds were determined by gas chromatography coupled with electron-impact mass spectrometry (GC-EI/MS). The characteristic ions and fragmentation mechanism of cypermethrin were evaluated by electron impact ionization mass spectrometry (EI/MS). After the optimization of different parameters, such as the extraction solvent, the pesticide was extracted from the matrix with methanol/acetone in a Soxhlet extractor, cleaned up on a Florisil column by elution with a mixture of 30% ethyl acetate in n-hexane and analyzed by gas chromatography-electron impact ionization mass spectrometry (GC-EI/MS) in the selected ion-monitoring mode (SIM) with permethrin as internal standard. Recovery was in the range 77–118% with relative standard deviations (RSD) between 2.5% and 10.2%. The limit of detection (LOD) was 6.5?µg/kg for cypermethrin. The developed method was linear in the injection range 6–30?ng, with correlation coefficients greater than 0.9957.     

New models of thermal resistance at the interface of solids connected by random disk contactsNouveaux modèles de résistance thermique à l'interface de solides connectés par des contacts circulaires aléatoires

Some new analytical models are proposed to calculate the thermal contact resistance between solids without heat transfer through the interstitial fluid. The interface is modeled by multiple disk contacts with different radii and random positions. Square and cylindrical semi-infinite solids are studied. Two sorts of models are developed. The first one considers the laterally insulated solids and uses finite integral transforms. The corresponding analytical solutions are exact but need a long computational time to treat an important number of contacts. The second one considers the same solids and uses the linear superposition method after applying an infinite integral transform. The analytical solutions are approximate but accurate and need little computational time. To cite this article: N. Laraqi, A. Bairi, C. R. Mecanique 330 (2002) 39–43     

Synthesis,Structure and Impact of 5-Aminoorotic Acid and Its Complexes with Lanthanum(III) and Gallium(III) on the Activity of Xanthine Oxidase

The superoxide radical ion is involved in numerous physiological processes, associated with both health and pathology. Its participation in cancer onset and progression is well documented. Lanthanum(III) and gallium(III) are cations that are known to possess anticancer properties. Their coordination complexes are being investigated by the scientific community in the search for novel oncological disease remedies. Their complexes with 5-aminoorotic acid suppress superoxide, derived enzymatically from xanthine/xanthine oxidase (X/XO). It seems that they, to differing extents, impact the enzyme, or the substrate, or both. The present study closely examines their chemical structure by way of modern methods—IR, Raman, and ¹H NMR spectroscopy. Their superoxide-scavenging behavior in the presence of a non-enzymatic source (potassium superoxide) is compared to that in the presence of an enzymatic source (X/XO). Enzymatic activity of XO, defined in terms of the production of uric acid, seems to be impacted by both complexes and the pure ligand in a concentration-dependent manner. In order to better relate the compounds’ chemical characteristics to XO inhibition, they were docked in silico to XO. A molecular docking assay provided further proof that 5-aminoorotic acid and its complexes with lanthanum(III) and gallium(III) very probably suppress superoxide production via XO inhibition.     

An accurate model for the thin film flow

This paper deals with the linear stability of a liquid film flowing down an inclined plane. The Navier-Stokes equations were reduced into four evolution equations that describe the development of the film depth, the flow rate, the free surface velocity, and the wall shear stress, using the Karman-Polhausen boundary layer integral method. Thus, we were able to determine the stability threshold and approach well the critical wave number for long waves. The obtained results were found to be in good agreement with the experiments of Liu et al.