不同结晶速率的PET薄膜在拉伸过程中的结晶与取向

用多种方法对两个结晶速率不同的PET样品在拉伸过程中的结晶和取向进行了研究。结果表明在同样的拉伸条件下,结晶速率较快的样品的结晶度和取向程度均比另一样品要高得多,这种结构变化上的差别说明把拉伸行为的差别归因于结晶速率的不同是合理的。     

序列结构对苯乙烯/丁二烯共聚物热释电流峰的影响

本文研究聚合方式对苯乙烯/丁二烯共聚物热释电流峰(TSC)的影响。共聚物试样有三个电流峰(β、α和ρ峰)。实验结果表明:聚合方式对β峰(丁二烯局部运动)基本没有影响,但对α峰(丁二烯相的T_g转变)的位置有明显的影响,而且两步法试样有两个α峰;嵌段共聚物试样在高温还有一肩部(苯乙烯相的T_g转变),无规共聚试样没有肩部。由共聚物的序列结构能圆满解释TSC结果,而序列结构决定于聚合方式。因此,本工作将苯乙烯/丁二烯共聚物的序列结构与性能联系起来。     

高聚物热释电流的极化温度扫描法

本工作将热释蠕变(TSCr)的技巧应用于TSC,并作了一些简化,把聚甲基丙烯酸甲酯(PMMA)用通常TSC法得到宽TSC谱解析成许多单元松弛谱。由于利用改变极化温度区间的办法,将连续松弛谱解析为许多单元松弛谱,因此称为极化温度扫描法。     

非晶态聚对苯二甲酸乙二酯等温结晶的介电研究

非晶态PET的介电性质温度谱除α_a松弛和β松弛外,在120—130℃之间由于在升温过程中试样的结晶出现一个损耗峰。比较非晶态试样与结晶后试样介电常数ε′和介电损耗ε″的差别,可在97—113℃温度下用ε′和ε″来表征非晶态PET的等温结晶过程。在结晶的初期,ε′随时间的变化符合Avrami方程,即(ε′(t)-ε′(∞))/(ε′(0)-ε′(∞))=exp(-Kt~n)。在结晶的后期,由介电性质的频率谱Cole-Cole图观察介电松弛强度△ε和β参数在结晶过程的变化。     

用偏振红外光谱表征经单轴和双轴拉伸的PET薄膜

用偏振红外光谱方法研究了拉伸速率和不同拉伸方式,包括单轴拉伸、双轴同时拉伸和双轴依次拉伸等,对PET薄膜取向的影响。对由不同拉伸方式制得的反式结构含量和密度均基本相同的试样进行比较得出:单轴拉伸试样中分子链相对拉伸方向的轴取向程度最高,分子链在薄膜平面内的取向分布亦最不均匀;双轴拉伸试样中分子平面(苯环面)相对薄膜平面有明显的平面取向,而单轴拉伸试样中分子平面和薄膜平面基本上无共平面趋势。在所用的实验条件下,拉伸速率对取向程度几乎没有影响。     

GAS PERMEATION OF SEGMENTED POLYURETHANES AND THEIR BLENDS WITH PVC

Film specimens of four segmented polyurethanes with different soft segments, namely polycaprolactone, polytetramethylene adipate, polytetramethylene oxide and polypropylene oxide, and their blends with PVC of different compositions were obtained by solution cast. The permeability of these films to O_2, N_2 and H_2 and their density were measured by using gas chromatography and technique of density gradient column. The polyether polyurethanes were found to have higher permeability than the polyester ones due to their low glass transition temperature and /or the low density value. The blends of PVC and polyether polyurethanes, especially the PPO-based polyurethane, are incompatible, and their permeability coefficient-composition dependence has the typical S-shaped curves. PVC is well compatible with the soft segments in its blends with polyester polyurethanes. For these blends the composition dependence of permeability is characterized by a negative deviation from the semilogarithmic additivity rule, and it is possible to prepare blends having T_g 20℃lower than that of PVC, but retaining its low permeability almost unchanged, results were discussed in according with the different approaches for the permeation behavior of compatible and incompatible blends.