Structural characteristics and residual stresses in oxide films produced on Ti by pulsed unipolar plasma electrolytic oxidation

Oxide films, 7–10 µm thick, were produced on commercially pure titanium by plasma electrolytic oxidation in a sodium orthophosphate electrolyte using a pulsed unipolar current with frequency (f) and duty cycle (δ) varying within f = 0.1–10 kHz and δ = 0.8–0.2, respectively. The coatings comprised a mixture of an amorphous phase with nanocrystalline anatase and rutile phases, where the relative rutile content range was 17–25 wt%. Incorporation of phosphorus from the electrolyte into the coating in the form of PO₂ ^–, PO₃ ^2– and PO₄ ^3–, as demonstrated by EDX and FT-IR analyses, contributed to the formation of the amorphous phase. Residual stresses associated with the crystalline coating phase constituents were evaluated using the X-ray diffraction sin² ψ method. It was found that, depending on the treatment parameters, internal direct and shear stresses in anatase ranged from–205 (±17) to–431 (±27) MPa and from–98 (±6) to–145 (±10) MPa, respectively, whereas the rutile structure is comparatively stress-free.     

Effects of initial crystal size of diamond powder on surface residual stress and morphology in polycrystalline diamond (PCD) layer

Polycrystalline diamond compacts (PDC) were synthesized using diamond powder of average crystal size 3-20 μm by the Ni 70 Mn 25 Co 5 alloy infiltration technique at high temperature and high pressure (HPHT).The surface residual stress of polycrystalline diamond (PCD) layer was measured using micro-Raman spectroscopy with hydrostatic stress model and X-ray diffraction (XRD).Measurements of the stress levels of PCDs show that the residual compressive stresses range from 0.12 to 0.22 GPa,which increase with th...     

Atomic short-range order in CuMn alloys

The establishment of atomic short-range order (SRO) has been investigated in CuMn alloys (5, 8,13,16,20 at. % Mn) by measurement of the electrical resistivity during isochronal and isothermal annealing. An increasing degree of SRO is accompanied by a reduction of resistivity; this effect increases with Mn concentration. For 8,13 and 16 at. % Mn SRO kinetics turn out to deviate significantly from single exponential behavior with a maximum at 13 at. % Mn, whereas at 5 and 20 at. % Mn SRO is adjusted in a single exponential process. For data analysis three methods are used: a sum of two and three exponentials as well as a log-normal spectrum of relaxation times. The strong interaction between second-nearest-neighbor atoms in CuMn seems to be essential for SRO kinetics but of minor importance for the value of SRO-induced resistivity change.     

用不同光泽和色差等级的彩色印刷样品检验均匀颜色空间

用不同光泽纸张和不同色差等级彩色印刷样品的目视评价色差数据拟合色度椭圆,研究各均匀颜色空间在评价不同光泽度和色差样本时的表现,检验基于CIELAB,DIN99,OSA和C1ECAM02共7个颜色空间的均匀性.用局部均匀性和全局均匀性因子分别检验不司颜色空间色度椭圆的椭圆度和空间中不同位置椭圆尺寸的一致性.结果表明,其他所有颜色空间的表现均优于CIELAB和OSA颜色空间,OSA-Gp-Eu和DIN99d颜色空间在评价印刷品颜色差异的表现上较为接近,同时优于其他的颜色空间.     

注塑制品残余应力的研究进展

由于实际工艺条件往往与理想值存在一定偏差,制品在成形后通常会存在一些难以避免的缺陷,而残余应力正是最为常见的一种。注塑制品的残余应力是在注塑成形过程中,外界约束去除后,仍存在于塑件内部的应力,在后期使用过程中容易引起塑件的翘曲、变形、乃至断裂破损,多数情况下对制品不利。因此,在塑料制品设计时应充分考虑到残余应力的影响。本文较为全面地介绍了注塑制品残余应力的产生、检测、减小残余应力的措施及残余应力的计算机模拟等内容。     

反相流动注射-分光光度法测定水中痕量余氯的研究

研究并建立了测定水中痕量总余氯和游离余氯的Ｎ,Ｎ－二乙基－１,４－苯二胺（ＤＰＤ）反相流动注射分光光度法。将ＤＰＤ溶液和ＨＰＯ４＾２－－Ｈ２ＰＯ４＾－缓冲溶液（ｐＨ６．７）的混合液注入试样载流中,再与ＫＩ溶液或硫代乙酰胺溶液流混合,在５１０ｎｍ处对反应形成的红色半醌式化合物进行分光光度测定。     

Relative and Absolute Configuration of Vatiparol (1 mg): A Novel Anti‐inflammatory Polyphenol

Bioactive natural products offer multiple opportunities for the discovery of novel chemical entities with potential pharmaceutical, nutraceutical and agrochemical applications. Many new organic compounds with novel scaffolds are isolated in small quantities and established methods often fail to determine the structure and bioactivity of such novel natural products. To meet this challenge, we present here a new methodology combining RDC (residual dipolar coupling)‐based NMR spectroscopy in microtubes, with a motif‐inspired biological assessment strategy. Using only one milligram (ca. 1.5 μmol) of sample, the new protocol established the bioactivity as well as the relative and absolute configuration of vatiparol obtained from Vatica parvifolia. Vatiparol is unique in its unprecedented carbon skeleton and selective inhibitory effect on the expression of monocyte chemo‐attractant protein‐1 (MCP‐1, also known as CCL2). The plausible biosynthetic pathway of vatiparol is briefly discussed. The approach introduced here promises to be widely applicable to the determination of the structure and bioactivity of structurally unknown organic samples available in very limited amounts.