Temperature effects on surface activity and application in oxidation of toluene derivatives of CTAB-SDS with KMnO4

The γ_cmc values of CTAB-SDS decrease from 63.67 mN/m at 10‡C to 36.38 mN/m at 90‡C, slightly lower than those of either CTAB or SDS. Correspondingly, the CMC of CTAB-SDS decreases almost by half. The increase of surface activity of CTAB-SDS can be attributed to the relatively weak electrostatic interaction at high temperature, which is supported by the increase of solubility of CTAB-SDS with rise in temperature. Catalytic effect on oxidation of toluene derivatives with potassium permanganate follows the order CTAB-SDS > SDS > CTAB. This is not caused by the dissociative effect of CTAB-SDS with low surface activity at low temperature, as seen from the fact that almost all oxidative products can be retrieved for different toluene derivatives and surfactants by mimicking the conditions of reaction. In the emulsifications of toluene derivatives at 90‡C, the time that turbid water layers of surfactant solutions take to become clear is the same as that of the catalytic effect on oxidation of toluene derivatives. Thus, it can be inferred that surfactants can improve the oxidation yields of toluene derivatives by increasing the contact between two reacting phases.     

Synthesis and refractive‐index control of fluoropolymers by the polyaddition of bis(epoxide)s and triazine di(aryl ether)s

The polyaddition of fluorine‐containing bis(epoxide)s and fluorine‐containing triazine di(aryl ether)s were examined to give the corresponding fluorine‐containing poly(cyanurate)s. It was observed that the synthesized fluoropolymers had good thermal stabilities and good film‐forming properties. The glass transition temperatures (T_g's) and refractive‐indices (n_D's) of synthesized polymers were determined by differential scanning calorimetry and ellipsometry, respectively, and it was found that the values of T_g's and n_D's were supported by their fluorine containing ratios and skeletons. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 4421–4429, 2007     

An experimental study of dynamic tensile properties of glass fiber at low-temperatures

Tensile impact experiments of EC8.0−24×7 glass fiber bundles at different low temperaturesT(14°C, −40°C and −10°C) and strain rates ɛ were carried out, and complete stress-strain curves were obtained. Within the range of the experiment temperatures and strain rates, it is found that the initial modulusE, the ultimate strength σ_max and the unstable strain ɛ _b of the glass fiber bundles all increase with ɛ at an identicalT. At an identical ɛ, with the decrease ofT, E and σ_max increase; but ɛ _b increases when 10°C>T>−40°C and decreases when −40°C>T>−100°C. The strain-rate- and temperature-dependent bimodal Weibull statistical constitutive theory was adopted for the statistical analysis of the experimental results, and the Weibull parameters of single fiber were obtained. The results show that the bimodal Weibull distribution function is suitable to represent the strength distribution of the glass fiber at low temperature and different strain rates. The differences in the mechanical properties between EC8.0−24×7 and EC5.5−12 ×14 glass fiber bundles were also discussed. Project supported by the National Natural Science Foundation of China (No. 19772058).     

Growth transition and morphology change in polypropylene

The growth rate of isotactic polypropylene is deduced from microscopic observations during isothermal crystallizations. A change in the growth regime is observed at 138 C and interpreted as a Regime III Regime II transition, according to Hoffman's kinetic theory of polymer crystallization. A Regime II Regime I transition is also theoretically predicted at 155 C, i. e. at a temperature outside the investigated temperature range. The Regime III Regime II transition is related to the positive to negative change in the spherulite birefringence, which is generally attributed to a change in the organization of crystalline lamellae: quadritic arrays of intercrossing lamellae atT _c < 138 C (Regime III) and preferentially radiating lamellae atT _c > 138 C (Regime II). It is suggested that such a morphological change could be interpreted using the concept of non-adjacent re-entry introduced in Hoffman's kinetic theory. This interpretation could also explain the interspherulitic ruptures observed in negative spherulites.     

Effect of PEG on the crystallization of PPDO/PEG blends

A new biodegradable polymer system, poly(p-dioxanone) (PPDO)/poly(ethylene glycol) (PEG) blend was prepared by a solvent casting method using chloroform as a co-solvent. The PPDO/PEG blends have different weight ratios of 95/5, 90/10, 80/20 and 70/30. Crystallization of homopolymers and blends were investigated by differential scanning calorimetry (DSC) and wide-angle X-ray diffraction (WAXD). When 5% of PEG was blended, the crystallization exothermal peaks (T_c) of PPDO increased sharply and the crystallization exothermal peaks (T_c) of PEG decreased slightly compared with the homopolymers. The crystallization rates of both components increased, and caused greater relative crystallization degree (X_t%). But when the content of PEG was more than 5%, the crystalline behaviors of blends had no more significant changes accordingly. The melting points of each sample varied little over the entire composition range in this study. The nonisothermal crystallization of PPDO homopolymer and blend (PPDO/PEG = 70/30) were also studied by DSC. The crystallization began at a higher temperature when the cooling rates were slower. The nonisothermal crystallization kinetics of blends was analyzed by Ozawa equation. The results showed that the Ozawa equation failed to describe the whole crystallization of the blend, but Mo equation could depict the nonisothermal crystallization perfectly.     

Dipolar relaxations in an epoxy-amine system

Dipolar relaxations in a reactive epoxy-amine system based on diglycidyl ether of bisphenol A with 4,4^′-diaminodiphenylsulfone were studied with the Havriliak-Negami function. The system was cured isothermally at 140 °C using simultaneous kinetic and microdielectric studies.The relaxation time was calculated from the frequency f_max of the peak of the loss factor ε^′′ versus frequency f. A linear relation exists between the logarithm of the relaxation time τ and the glass transition temperature T_g. Then, logτ follows the Di Benedetto equation revisited by Pascault and Williams allowing the prediction of the relaxation time τ during cure.The unrelaxed permittivity at high frequency ε_u, the relaxed or static permittivity ε_s and the skewness parameter β were found independent on the conversion or the curing time. The distribution parameter α decreases as curing time t increases. The difficulty of orientation of dipoles in the electric field due to vitrification is responsible of these behaviours.     

多层绝热材料规模化干燥处理时温度场的测试与分析

对大批量处理多层绝热材料的大型专用干燥箱满负荷运行时工作区域的温度场进行测试,通过温度分布和温度场均匀性的分析,得出了最高温度发生点的位置与成因以及影响温度场均匀性的主要因素,并对温度的控制方法、多层材料的布置方案和干燥设备的改进提出了建议。     

Variable temperature system using vortex tube cooling and fiber optic temperature measurement for low temperature magic angle spinning NMR

We describe the construction and operation of a variable temperature (VT) system for a high field fast magic angle spinning (MAS) probe. The probe is used in NMR investigations of biological macromolecules, where stable setting and continuous measurement of the temperature over periods of several days are required in order to prevent sample overheating and degradation. The VT system described is used at and below room temperature. A vortex tube is used to provide cooling in the temperature range of -20 to 20 degrees C, while a liquid nitrogen-cooled heat exchanger is used below -20 degrees C. Using this arrangement, the lowest temperature that is practically achievable is -140 degrees C. Measurement of the air temperature near the spinning rotor is accomplished using a fiber optic thermometer that utilizes the temperature dependence of the absorption edge of GaAs. The absorption edge of GaAs also has a magnetic field dependence that we have measured and corrected for. This dependence was calibrated at several field strengths using the well-known temperature dependence of the (1)H chemical shift difference of the protons in methanol.     

多波段微量TNT成像探测的数值分析和实验研究

建立了CO2激光器辐照微量爆炸物温升分布三维模型,对激光辐照过程和冷却过程中8~14μm和3~5μm波段内的目标表面辐射温度变化特性分别进行分析.利用设计的探测系统对目标进行初步探测,用8~14μm和3~5μm热像设备对目标进行观察分析.研究表明:在10.6μm激光照射过程中,8~14μm波段内沾有TNT目标的辐射温度分别由TNT、基底在8~14μm波段的发射率和对激光辐照的反射率共同决定;在3~5μm内目标辐射温度主要由TNT、基底在3~5μm波段的自身发射率决定.在探测过程中,8~14μm波段内沾染TNT区域的辐射温度明显高于周围区域,而在3~5μm波段内,目标表面辐射温度整体下降,并且沾染区域的辐射温度变得低于周围.     

具有特大磁电阻效应钙钛矿材料的制备及性能分析

通过固相烧结法制备了具有特大磁电阻效应的钙钛矿材料Pr0.64Ag0.044MnAl0.2O3.利用结构和成分分析,发现此材料只有在1 100℃高温烧结下才能生成完整的钙钛矿结构,且属于立方晶系,晶格常量a≈0.386 nm.在0.4 T的外磁场下,磁电阻值在122 K处达到最大,约为19.2%,为巨磁电阻实验提供了较好的样品.