Non‐empirical calculations of NMR indirect carbon–carbon coupling constants. Part 4: Bicycloalkanes

A systematic study of the one‐bond and long‐range J(C,C), J(C,H) and J(H,H) in the series of nine bicycloalkanes was performed at the SOPPA level with special emphasis on the coupling transmission mechanisms at bridgeheads. Many unknown couplings were predicted with high reliability. Further refinement of SOPPA computational scheme adjusted for better performance was carried out using bicyclo[1.1.1]pentane as a benchmark to investigate the influence of geometry, basis set and electronic correlation. The calculations performed demonstrated that classical ab initio SOPPA applied with the locally dense Dunning's sets augmented with inner core s‐functions used for coupled carbons and Sauer's sets augmented with tight s‐functions used for coupled hydrogens performs perfectly well in reproducing experimental values of different types of coupling constants (the estimated reliability is ca 1–2 Hz) in relatively large organic molecules of up to 11 carbon atoms. Additive coupling increments were derived for J(C,C), J(C,H) and J(H,H) based on the calculated values of coupling constants within SOPPA in the model bicycloalkanes, in reasonably good agreement with the known values obtained earlier on pure empirical grounds. Most of the bridgehead couplings in all but one bicycloalkane appeared to be essentially additive within ca 2–3 Hz while bicyclo[1.1.1]pentane demonstrated dramatic non‐additivity of ?14.5 Hz for J(C,C), +16.6 Hz for J(H,H) and ?5.5 Hz for J(C,H), in line with previous findings. Non‐additivity effects in the latter compound established at the SOPPA level should be attributed to the through‐space non‐bonded interactions at bridgeheads due to the essential overlapping of the bridgehead rear lobes which provides an additional and effective non‐bonding coupling path for the bridgehead carbons and their protons in the bicyclopentane framework. Copyright © 2003 John Wiley & Sons, Ltd.     

(NH4)2MoS4在活性炭上浸渍过程的研究:Ⅱ.干燥机理及模型

（ＮＨ＿４）＿２ＭｏＳ＿４在活性炭上浸渍过程的研究Ⅱ．干燥机理及模型秦慧芳，张成芳，陆岗，俞丰，朱子彬（华东理工大学无机化工研究所，上海２００２３７）２３７）关键词硫代钼酸铵，活性炭，干燥，钼分布，干燥模型负载型催化剂的活性组分在载体上的分布，受浸渍...     

Gradient‐enhanced one‐dimensional pulse schemes for quaternary and methylene carbon detection

Gradient‐enhanced pulse schemes are presented for the detection of quaternary and methylene carbons. The new pulse schemes permit the detection of quaternary and methylene (—CH₂) carbons or CH₂ carbons alone from a single experiment. Efficient suppression of CH and CH₃ carbons in all the pulse schemes is achieved by creating their antiphase magnetization and then dephasing using gradients. In the pulse schemes for detection of only CH₂ carbons, the quaternary carbons are also suppressed either by dephasing using gradients or by rendering them unobservable by retaining in longitudinal order. The experimental results of the gradient pulse schemes are demonstrated on cholesteryl acetate and cyclosporin A. These one‐dimensional techniques, because of their simplicity and the ease of performing the experiments, can be important for routine chemical applications. Copyright © 2003 John Wiley & Sons, Ltd.     

Electrooxidation of carbo/thiocarbohydrazide and their hydrazone derivatives at a glassy carbon electrode

Electrochemical oxidation of thio/carbohydrazide and their hydrazone derivatives Benzaldehyde thiocarbohydrazone [BTCH] diacetylene thiocarbohydrazone [DATCH] have been studied in Brit-ton Robinson buffer in aqueous and nonaqueous media at a glassy carbon electrode. The effects of pH, sweep rate, concentration, temperature and surfactants have been studied. The complex bis (carbo/thiocabohydrazide) Zn(II) chloride was also subjected to voltammetric analysis in order to understand the reactivity both in free and metal bound states. The reaction conditions were optimized for the determination of above compounds in micrograms quantities by differential pulse voltammetry, analytical utility of this investigation is also highlighted.     

Gas transport through homogeneous and asymmetric polyethersulfone membranes

Both homogeneous and asymmetric polyethersulfone (PES) membranes were prepared by solvent casting. The sorption and permeation behavior of CO₂, O₂, and N₂ using these two kinds of cast PES membranes and commercially available homogeneous PES film was investigated to extract the pressure dependence of gas permeability and the permselectivity for CO₂ relative to N₂, and to confirm the validity of the working assumption that a skin layer in an asymmetric membrane can be essentially replaced by a thick homogeneous dense membrane. The pressure dependence of the mean permeability coefficient to CO₂ in homogeneous membranes obeys the dual-mode mobility model. The ideal separation factor for CO₂ relative to N₂ at an upstream pressure of 0.5 MPa attains ca. 40, while the permeability to CO₂ is about 2.7 Barrer at the same upstream pressure. The same separation factor in asymmetric membranes amounts to 35. The diffusion behavior for the skin layer in an asymmetric membrane with a thin skin layer can be simulated approximately by that in a homogeneous dense membrane. © 1993 John Wiley & Sons, Inc.     

STUDIES ON THE PREPARATION OF ZINC-CONTAINING ACTIVATED CARBON FIBERS AND THEIR ANTIBACTERIAL ACTIVITY

1. INTRODUCTION Microbial pollution will bring about various problems in industry and other vital fields, such as causing decomposing of materials, harming people抯 health. In order to reduce these problems, new antibacterial materials have been demanded. Recently, much attention has been paid to inorganic materials including zinc oxide [1~4]. These inorganic antibacterial materials are now substituting for organic materials to avoid releasing noxious organic molecules harmful to humans;…     

Carbon anode materials from polysiloxanes for lithium ion batteries

Three kinds of silicon-containing disordered carbons have been prepared by pyrolysis of polysiloxanes with different amounts of phenyl side groups. X-ray powder diffraction, X-ray photoelectron spectroscopy and electrochemical capacity measurements were performed to study their behaviors. Graphite crystallites, micropores, and silicon species affect their electrochemical performances. All of them present high reversible capacities, >372 mAh/g. Since the graphite crystallites are very small, they contribute very little to reversible capacity. The number of micropores produced by gas emission during the heat-treatment process decides whether they exhibit reversible capacity. Si mainly exists in the form C–Si–O and influences the irreversible capacity. There is no evident capacity fading in the first ten cycles, indicating promising properties for these disordered carbons.     

XPS C 1s binding energies for fluorocarbon–hydrocarbon microblock copolymers

Fluorocarbon–hydrocarbon microblock copolymers –(CF₂)_n–(CH₂)_m– (n = 4, 6, 8; m = 6, 8, 10) were synthesized. Binding energies of the C 1s and F 1s peaks of these copolymers were measured using x‐ray photoelectron spectroscopy. The binding energy of the C 1s peaks of the carbon atoms of the hydrocarbon segments was set at 285.0 eV as the binding energy reference. Unexpectedly, the binding energy of the C 1s peak corresponding to the CF₂ group of the microblock copolymers was determined to be ～291.4 eV, which is ～0.8 eV lower than that of the CF₂ group of tetrafluoroethylene. Copyright © 2003 John Wiley & Sons, Ltd.     

Füllstandsmessung mit Streustrahlungssonden

Es wird die Abhängigkeit der Impulsdichte vom Füllstand bei Meßanordnungen mit γ-Streustrahlungssonden verschiedener Länge untersucht. Verwendet werden die Nuklide ⁶⁰Co und ¹³⁷Cs. Ein nahezu linearer Anstieg der Impulsdichte mit dem Füllstand wird bei Füllgütern kleiner Ordnungszahl nur bei Sondenlängen L ≥ μ₀ ^?1.erzielt. Der Einfluß des Schüttwinkels und der Dichte des Füllgutes wird diskutiert.