“容球旋转体的共性”再探

文[1]、文[2]、文[3]分别给出以下3个定理： 定理1 在存在内切球的前提下，多面体的体积均等于其表面积与相应内切球半径乘积的三分之一．     

一个与Chebyshev多项式有关的极值

C[-1,1]表示[-1,1]上的连续函数空间,‖·‖_(?)是它的一致范数.又a=(a_0,a_1,…,a_n)∈l~(n 1),a_(i)∈R,记|a|_2=(sum from i=0 to n a_i~2)~(1/2).令和本文的主要目的是证明:     

C40自密实混凝土Ⅱ型断裂韧度的确定

自密实混凝土的Ⅱ型断裂韧度是个很重要的材料参数,而对其Ⅱ型断裂的研究,有助于我们建立复杂裂缝扩展准则并且探索构件断裂失效.为了解自密实混凝土Ⅱ型断裂破坏过程并确定其Ⅱ型断裂韧度,本文制备了7组21个不同缝高比以及不同切口方式的试件,利用半对称加载方式对自密实混凝土做了Ⅱ型断裂实验,并利用ABAQUS有限元建模,模拟计算...     

透射强度比X射线荧光光谱法测定金属镀层组分

本文介绍了X射线荧光光谱透射强度比测定中等可变厚度金属镀层的组分方法。采用镀层元素强度和基片透射强度之比对镀层元素镀布分量制作工作曲线。     

Ψ′→KSKL的首次观测及其物理应用

利用北京谱仪采集的 1400万Ψ′数据,对粲偶素衰变到赝标介子对KSKL进行了寻找,首次观测到信号并测量了其衰变分支比,并首次确定Ψ′衰变中强振幅和电磁振幅之间的相角接近±90°.结合从北京谱仪采集的J/Ψ数据中测得的J/Ψ→KSKL的分支比,确定了Ψ′→KSKL相对于微扰量子色动力学“12%”规则的反常增强,对粲偶素的衰变机制研究提出了新的挑战.     

Nucleon aPF2 Superfluid Pairing Gap in Asymmetry Nuclear Matter

The 3 P F2 superfluidity of neutron and proton is investigated in isospin-asymmetric nuclear matter within the Brueckner-Hartree-Fock approach and the BCS theory by adopting the Argonne V14 and the Argonne V18 nucleonnucleon interactions. We find that pairing gaps in the 3PF2 channel predicted by adopting the AV14 interaction are much larger than those by the AV18 interaction. As the isospin-asymmetry increases, the neutron 3 pF2 superfluidity is found to increase rapidly, whereas the proton one turns out to decrease and may even vanish at high enough asymmetries. As a consequence, the neutron 3pF2 superfluidity is much stronger than the proton one at high asymmetries and it predominates over the proton one in dense neutron-rich matter.     

红外辐射在水雾中衰减计算的修正方法研究

水雾系统对红外光谱有着强烈的衰减作用,因此在军事目标的各种制导对抗中被予以高度的关注。以Mie散射理论为基础,分析了粒子对红外光谱前向散射的聚集特性,定义了近前向散射比,并确定了在应用朗伯比尔定律时需修正的粒子尺度和散射半角的范围。通过大量计算发现,单独将粒子尺度和散射半角的乘积作为独立变量计算的视消光系数不够精确。在中远红外波段,前向散射附近的小角度内散射强度积分与粒子尺度和散射角都成正比,若红外波长为定值,则与粒子半径成正比。最后根据前向散射规律给出了两个不单独以x.θ为变量的经验计算公式,使得对水雾消光的修正计算更加简便精确。     

K_2S-activated carbons developed from coal and their methane adsorption behaviors

The main purpose of this work is to prepare various activated carbons by K2S activation of coal with size fractions of 60-80 meshes, and investigate the microporosity development and corresponding methane storage capacities. Raw coal is mixed with K2S powder, and then heated at 750 ℃-900 ℃ for 30 min-150 min in N2 atmosphere to produce the adsorbents. The texture and surface morphology are characterized by a N2 adsorption/desorption isotherm at 77 K and scanning electron microscopy （SEM）. The chemical properties of carbons are confirmed by ultimate analysis. The crystal structure and degree of graphitization are tested by X-ray diffraction and Raman spectra. The relationship between sulfur content and the specific surface area of the adsorbents is also determined. K2S activation is helps to bring about better development of pore texture. These adsorbents are microporous materials with textural parameters increasing in a range of specific surface area 72.27 m2/g-657.7 m2/g and micropore volume 0.035 cm3/g-0.334 cm3/g. The ability of activated carbons to adsorb methane is measured at 298 K and at pressures up to 5.0 MPa by a volumetric method. The Langmuir model fits the experimental data well. It is concluded that the high specific surface area and micropore volume of activated carbons do determine methane adsorption capacity. The adsorbents obtained at 800 ℃ for 90 min with K2S/raw coal mass ratios of 1.0 and 1.2 show the highest methane adsorption capacities amounting to 106.98 mg/g and 106.17 mg/g, respectively.     

理想斯特林热机循环原理及其效率的计算和实际工作效率的简单讨论

本文首先从热机效率的基本公式出发,阐述理想斯特林热机的工作原理,从中看到斯特林热机独特的工程设计对效率计算的影响,使其效率达到理想卡诺循环效率;其次给出实际斯特林热机工作时的热损耗的来源分析;最后结合有关论文的结论,给出工质为范德瓦耳斯气体时的效率与体积比的关联.