全文获取类型
收费全文 | 1507篇 |
免费 | 398篇 |
国内免费 | 2407篇 |
专业分类
化学 | 3519篇 |
晶体学 | 386篇 |
力学 | 11篇 |
综合类 | 56篇 |
物理学 | 340篇 |
出版年
2025年 | 2篇 |
2024年 | 103篇 |
2023年 | 156篇 |
2022年 | 233篇 |
2021年 | 204篇 |
2020年 | 219篇 |
2019年 | 198篇 |
2018年 | 144篇 |
2017年 | 188篇 |
2016年 | 171篇 |
2015年 | 200篇 |
2014年 | 218篇 |
2013年 | 312篇 |
2012年 | 206篇 |
2011年 | 187篇 |
2010年 | 162篇 |
2009年 | 160篇 |
2008年 | 146篇 |
2007年 | 150篇 |
2006年 | 144篇 |
2005年 | 146篇 |
2004年 | 130篇 |
2003年 | 108篇 |
2002年 | 74篇 |
2001年 | 113篇 |
2000年 | 50篇 |
1999年 | 53篇 |
1998年 | 19篇 |
1997年 | 11篇 |
1996年 | 13篇 |
1995年 | 11篇 |
1994年 | 10篇 |
1993年 | 5篇 |
1992年 | 6篇 |
1991年 | 8篇 |
1990年 | 6篇 |
1989年 | 5篇 |
1988年 | 7篇 |
1987年 | 4篇 |
1986年 | 4篇 |
1985年 | 25篇 |
1984年 | 1篇 |
排序方式: 共有4312条查询结果,搜索用时 15 毫秒
1.
以低浓度甲硝唑为模型污染物,研究TiO2光催化降解甲硝唑废水.以5.0mL 60tmol/L的甲硝唑溶液为降解目标,考察了Cu2+浓度、溶液pH值、光照时间、TiO2用量等对甲硝唑降解率的影响.实验表明,当初始浓度为60μμmol/L的甲硝唑溶液、500mg/L H2O2溶液、225μmol/L的Cu2+溶液均取5.0mL参加反应,用硫酸调节pH约为3.0,当TiO2用量为4.12mg、光照反应时间为75min时,平均降解效果可达91.87%. 相似文献
2.
FTIR-ATR技术考察TiO2膜对油酸的光催化氧化性能 总被引:2,自引:1,他引:2
采用Sol-Gel和PVD法在玻璃、陶瓷、铝片表面制备出TiO2膜,直接将食用油中的主成分油酸用溶剂稀释后均匀涂在膜表面,采用FTIR-ATR技术实现了对膜样品光催化自清洁性能的快速准确评价,并通过测量水的接触角评价了膜的亲水性。结果表明,Sol-Gel法和PVD法制备的TiO2/玻璃膜都具有较好的光致亲水性和光催化降解油酸性能,两者的亲水性没有明显差别,但前者的光催化活性稍优于后者。比较Sol-Gel法制备的TiO2/玻璃、TiO2/陶瓷和TiO2/铝片膜对油酸的光催化降解性能发现,光照3·5h后3个样品的降解率分别为92%,85%和46%,表明基底材料性质对TiO2膜的光催化活性有明显影响,镀在非导电性玻璃和陶瓷表面的TiO2膜比镀在导电性金属铝表面的TiO2膜对油酸有更高的光催化降解能力。 相似文献
3.
Nano-TiO2 thin films are deposited by radio frequency (RF) magnetron sputtering using TiO2 ceramic target and characterized by X-ray diffractometer, atomic force microscope, and ultraviolet-visible spectrophotometer. The photocatalytic activity is evaluated by light-induced degradation of methyl orange solutions (5, 10, and 20 ppm) using a high pressure mercury lamp as the light source. The film is amorphous, and its energy gap is 3.02 eV. The photocatalytic degradation of methyl orange solution is the first-order reaction and the apparent reaction rate constants are 0.00369, 0.0024, and 0.00151 for the methyl orange solution concentrations of 5, 10, and 20 ppm, respectively. 相似文献
4.
5.
Photocatalytic TiO2 thin film is prepared by sol–gel technique on microstructured silicon substrate produced by femtosecond laser cumulative irradiation. The photocatalytic activity is evaluated by the degradation of methylene blue (MB) solution under ultraviolet (UV) irradiation. For 6-ml MB solution with initial concentration of 3.0×10~-5 mol/L, the degradation rate caused by TiO2 thin film of 2-cm~2 area is higher than 70% after 10-h UV irradiation. Microstructured silicon substrate is found to enhance photocatalytic activity of the TiO2 thin film remarkably. The femtosecond laser microstructured silicon substrate is suitable to support TiO2 thin film photocatalysts. 相似文献
6.
针对光催化制氢反应器内液固两相流的特点,运用代数滑移模型,对反应器内的催化剂颗粒-水两相流动进行了数值模拟。采用分块的结构化网格,并运用多重网格方法进行求解。通过与前人实验中压力梯度结果的比较,对模型进行了验证,并最终得到了反应器内催化剂颗粒的典型分布及相应的类型图。 相似文献
7.
La-Ce-TiO2纳米光催化剂的溶胶-微波法合成、谱学表征及其活性研究 总被引:3,自引:0,他引:3
以钛酸四丁酯为原料,采用溶胶-微波法(Sol-Microwave Method)合成了镧和铈共掺型纳米TiO2粉体(La-Ce-TiO2),借助XRD、XPS和UV-Vis等测试手段对其进行了表征,并以甲基橙为模型污染物考察了掺杂量对样品光催化活性的影响规律.XRD分析表明,所得粉体均为锐钛矿相纳米TiO2,且稀土元素镧和铈掺杂后纳米TiO2特征衍射峰宽化,强度降低;XPS分析表明,镧和铈掺杂后样品表面存在大量的氧缺位;UV-Vis吸收光谱表明,所得粉体在400 nm以下均有连续宽化的吸收带,且La和Ce掺杂后样品对光的吸收显著增强,这足由于La(Ⅲ)-O荷移跃迁以及Ce(Ⅳ)f→d跃迁和Ce(Ⅳ)-O荷移跃迁所致;光催化实验表明,La和Ce共掺杂能显著提高纳米TiO2的光催化活性,其中当La(Ⅲ)和Ce(Ⅳ)掺杂量分别为2%和0.04%时,纳米TiO2光催化剂具有较高的催化活性,自然光照射下光催化氧化处理卷烟厂蒸叶车间废水,效果较好,废水COD去除率达到86.11%. 相似文献
8.
以氯化锌和硫酸钛为原料,通过湿化学法成功制备了钛掺杂氧化锌微米管. 以粉末X射线衍射仪、场发射扫描电子显微镜、光致发光系统对样品进行了表征. 结果表明,未经掺杂的氧化锌微管具有良好的六方中空结构. 在TiO2/ZnO比率小于5%时,钛掺杂和未掺杂氧化锌管具有相近的尺度,外表光滑,近于圆柱形. 当TiO2/ZnO比率大于5%时,生成一种由ZnO, Ti3O5和TiO组成的多相混合物. 钛掺杂氧化锌在光催化降解甲基橙溶液效果明显. 相似文献
9.
In recent years, some important research indicated that the visible-light activity of photocatalysts could be enhanced via incorporating p-block non-metal elements into the lattice. In this paper, we investigated the electronic structures of pure and different non-metal (C, N, S, F, Cl, and Br) doped α-Bi2O3 using first-principles calculations based on the density functional theory. The band structures, the electronic densities of states, and the effective masses of electrons and holes for doped α-Bi2O3 were obtained and analyzed. The N and S dopings narrowed the band gap and reduced the effective mass of the carriers, which are beneficial for the photocatalytic performance. The theoretical predication was further confirmed by the experimental results. 相似文献
10.