蛋白质变性机理与变性时的热力学参数研究进展

生物大分子是近年来生命科学的研究热点和难点之一,而对蛋白质变性的研究有助于深刻揭示生命现象的机理.利用光谱学和热力学可以分别从微观和宏观角度对蛋白质变性进行研究,并由此得到表征蛋白质变性的热力学参数.这对深入了解蛋白质的折叠与伸展、变性机理、结构稳定性及生命体的新陈代谢等问题具有很大意义.近年来,国内外学者在此方面做了大量的工作,主要涉及蛋白质在水溶液中的变性机理、在有变性剂存在下水溶液中的变性机理及在含有其它物质水溶液中的变性机理.用来表征蛋白质变性的热力学参数有热容、变性自由能、变性焓和变性熵等.本文对这些研究进行了概述.     

Adsorption parameters of cyclobutane carboxylic acid at the interface of a mercury electrode with aqueous solutions of 0.4 M Na2SO4 + 0.1 M H2SO4

Based on the results of the regression analysis of differential capacitance curves of a mercury electrode in solutions of cyclobutane carboxylic acid (CBCA) at 25, 50, and 75°C, the adsorption parameters that enter into both the Frumkin isotherm and the model of two parallel capacitors are estimated. The free energies of adsorption found from the analysis of the temperature dependence of these parameters are incorrect due to the partial blowing out of CBCA during the deaeration of the solutions. The corresponding adsorption parameters are corrected under the assumption that the hydrophobic effect associated with the increase in the liquid-water entropy at the removal from it of CBCA molecules is the same as for n-valeric acid. The physical meaning of the squeezing-out effect is revised.     

固相微萃取参数选择及其对有机锡分析的影响

固相微萃取是一种新型的、不断发展和完善的样品前处理方法，它与其它技术联用可对多种样品基体中挥发、半挥发性有机化合物进行测定。目前，该技术在毒性金属有机化合物中的应用很少。本文分析参数选择对固相微萃取的影响的同时，还对其在有机锡化合物分析中的应用作了综述。     

Analysis of First-Order Reactions with Distributed Parameters

Simple methods of analysis of first-order kinetic processes controlled by distributions of parameters (activation energies and/or frequency factors) are presented. Both the isothermal and nonisothermal regimes are considered. The procedures make use of numerically calculated time derivatives of the concentrations of decaying species (reactants in the case of chemical reactions). They do not require any adjustable initial or boundary values of parameters (like concentration at the infinite time) being thus more accurate and reliable than earlier methods in which kinetic parameters were determined from the concentration, and not from its time derivative. The methods were successfully employed in analysis of the thermally driven cis–trans isomerization of a photochromic crown ether containing the azobenzene moiety incorporated in the crown.     

Probing the surface polarity of native celluloses using genuine solvatochromic dyes

The surface polarity of native celluloses has been investigated by the following solvatochromic dyes: dicyano-bis (1,10)-phenanthroline iron (II) Fe(phen)2 (CN)2 (1), bis(4-N,N-dimethylamino)-benzophenone (2), and cou-marine 153 (3). Linear Solvation Energy (LSE) relationships and the UV/Vis data have been used to characterize the surface polarity of different native cellulose batches in terms of the empirical Kamlet–Taft polarity parameters (hydrogen bond acidity), (hydrogen bond basicity), and * (dipolarity/polarizability). , , *and calculated Reichardt's E T (30) values are reported for various native and regenerated cellulose samples with different degrees of crystallinity. The degree of crystallinity of the cellulose samples has been determined by X-ray. The microcrystalline environment of cellulose can be exactly parameterized in terms of the , and *values. It shows a fairly strong acidity and a low dipolarity/polarizability. For the amorphous sections smaller and larger * values are observed. The correspondence of the empirical polarity parameters determined has been discussed in relation to results from pyrene fluorescence and zetapotential measurements.     

高比表面积窄孔分布氧化铝的制备研究 Ⅰ.沉淀条件的影响

 以硫酸铝液为原料，以氨水、氢氧化钠和铝酸钠为碱沉淀剂，采用pH摆动法制备了高比表面积、大孔径、窄孔分布、大孔体积氧化铝，考察了沉淀剂、沉淀温度及沉淀时酸侧pH值对氧化铝物性的影响，并对pH摆动法与等pH沉淀法的结果进行了比较．结果表明，通过改变制备参数可以获得高比表面积、大孔体积的氧化铝，当沉淀温度为70℃，pH摆动3或4次时，氧化铝的孔体积可高达1．0ml／g，比表面积仍大于300m2／g．用pH摆动法制得的样品比用等pH沉淀法制得的样品容易酸溶，对挤压成型有利．不同样品在酸溶液中的分散性表明，用氨水沉淀剂可获得相对较小的沉淀粒子．改变沉淀时酸侧的pH值，可导致沉淀粒子的结构发生变化．     

人类钙营养状况,缺钙后果及其对策

人类缺钙是世界性普遍存在的问题，中国人由于膳食结构缺陷及传统饮食习惯而使食物中钙的吸收受到影响，因而缺钙尤其普遍。     

A new study of the enzymatic hydrolysis of carboxymethyl cellulose with a bulk acoustic wave sensor

A new bulk acoustic wave (BAW) cellulase sensing technique, which is based on the enzymatic hydrolysis process of sodium carboxymethylcellulose (CMC) by cellulase, was established. The frequency shift curves of BAW sensor indicated that the viscosity of the tested solutions decreased during the hydrolysis process. The hydrolysis rate of CMC by cellulase was calculated from the frequency shift curves. The hydrolysis rate of CMC under different pH conditions at 30°C showed that cellulase had high hydrolysis ability approximately at pH 5.0. Kinetic parameters (the Michaelis constant K_m and the maximum rate V_max) of the process were estimated by using a linear method of Lineweaver–Burk plot. K_m is 1.95±0.25 mg ml⁻¹ and V_max is −(4.25±0.58)×10⁻³ g^1/2 cm^−3/2 cP^1/2 min⁻¹. Also the activation energy (E_a) of the enzymatic hydrolysis, with a value of 51.99±1.26 kJ mol⁻¹, was estimated in this work.     

Improvement of the Pd/Al2O3 Catalyst by the Control of the Sol-Gel Preparative Parameters

In this work, the metal dispersion of the Pd/Al₂O₃ catalyst prepared by sol-gel method is improved by an adequate optimisation of the preparative variables. First, the gelation temperature and the ageing time are selected, in order to avoid the reduction of the metal precursor (palladium acetylacetonate, Pd(acac)₂) by the solvent (sec-butanol, sB). The metal sintering effect on the catalysts treated in oxygen at 500°C is then minimized when the alumina pore size is controlled by the variation of the alumium alkoxide (AsB) concentration and the acetic acid amount ([AcA]/[AsB]). The appearance of new palladium particles on the alumina surface and the matching between the particle diameters and the pore sizes were also effective for the metallic surface area improvement on the samples treated in oxygen at 800°C. Compared to the reference catalysts, the higher metal dispersion obtained on the sol-gel ones was the determinant factor for their higher catalytic activity in methane combustion.     

基于量子微粒群优化算法的半透明介质光学参数反演

针对半透明介质光学参数估计问题,建立了脉冲激光辐照下半透明介质光学参数反演模型,采用量子微粒群优化(QPSO)算法反演了折射率和吸收系数,分析了测量误差、热物性参数对反演结果的影响,并利用敏感性分析揭示了反演精度与测量误差的关系.计算结果表明：建立的反演模型和采用的QPSO算法可以精确估计折射率和吸收系数,即使人为添加10%的测量误差,反演结果依然具有较强的鲁棒性和准确度.本研究可为半透明介质物性参数获取提供技术参考.