The Pharmacophore Hypothesis of Novel Inhibitors for Aurora A Kinase

A three-dimensional pharmacophore model was developed from a series of inhibitors of Aurora A kinase to discover new potent anti-cancer agents using the HypoGen module in the Catalyst software. The pharmacophore model was developed based on the structure of 20 currently available inhibitors, which were carefully selected from the literature. The best hypothesis （Hypo 1） was defined by four features： one hydrogen-bond donor and three hy- drophobic points, with the best correlation coefficient of 0.909, the lowest rms deviation of 1.563, and the highest cost difference of 99.075. The Hypo 1 was then validated by a test set consisting of 24 compounds and by a cross-validation of 95% confidence level through randomizing the data using the CatScramble program, which suggested that a predictive pharmacophore model had been successfully obtained.     

龋病人牙釉质表面硬度及抗磨损性能测试

采用人工方法制成人牙釉质浅龋及使用抗龋措施的龋损釉质样本，分别测量各组釉质表面显微硬度，并以微动摩擦磨损试验机测试其抗磨性能，试验结果表明：各组实验组釉质较对照组表面硬度都有不同程度下降，氟化钠前处理会使釉质表达硬度显著下降，人工浅龋牙釉质的抗磨损性能不如正常釉质，使用两种抗龋措施对其抗磨性能没有明显改善。     

6291型热变形温度和维卡软化温度测试仪的校准及故障排除

介绍6291型热变形温度和维卡软化温度测试仪的温度校准和位移校准方法，对测试仪的一些常见故障，例如电源故障，主温度传感器故障，电加热系统控制单元故障及测试站的温度偏差较大等进行了分析，并给出了排除故障的方法。     

Voltammetric Detection of Free Sulfhydryl Compounds in Food Flours

Cyclic voltammetry has been applied to the rapid measurement of free SH‐compounds in food flours samples. The protocol is based on the electrochemical adaptation of the Ellman's test, where the DTNB reacts with SH‐compounds present in food flour extracts, resulting in the equimolar production of the electroactive compound TNBA which, in turns, reacts with phenylendiamine. The reaction is found to provide an analytical signal from which to quantify indirectly free sulfhydryl compounds in flours extracts.     

On-line testing of gas chromatographic columns with a programmable computing integrator

Summary A program is described which calculates the number of effective plates and the coating efficiency over the entire range of a test chromatogram. The peak widths at half height are derived by assuming a Gaussian peak shape. The interpolated peak width at k=4 is used for computing a standardized number of effective plates. Plate height, column permeability, overall performance and a novel parameter called sampling efficiency are calculated from 5 other figures — i. e. carrier gas code, pressure drop, column length, column temperature and particle size.Dedicated to Dr. Leslie S. Ettre for his 60th birthday.     

密胺-脲甲醛树脂合成工艺放大研究

以密胺－脲甲醛树脂合成的小试工艺条件为依据，完成了放大试验过程的工艺研究。研究结果与小试研究的工艺条件相吻合。     

An optical surface plasmon resonance biosensor for determination of tetanus toxin

Surface plasmon resonance (SPR) has been successfully applied for the simple, rapid, and label-free assay of various biomolecules. This assay evaluates a novel wavelength modulation SPR biosensor for the detection of tetanus toxin. The wavelength modulation SPR biosensor is designed based on fixing the incident angle of light and measuring the reflected intensities in the resonance wavelength range spanning 400-800 nm simultaneously. Tetanus toxin (TeNT), one of the most potent toxins known, is synthesized as a 150 kDa single polypeptide chain. The SPR biosensor has been shown to be capable of directly detecting concentration of tetanus toxin as low as 0.028 Lf ml⁻¹. Under selected experimental conditions, the SPR biosensor has a good reproducibility, sensitivity and reversibility. The results illustrate how wavelength modulation SPR biosensor can be used to detect biomolecular interactions.     

稀土变质热锻模具铸钢高温磨损性能的研究

研究了稀土（RE）变质热锻模具铸钢的高温磨损性能，并与热锻模具钢H13钢和3Cr2W8V钢进行对比，探讨了稀土元素的作用和热锻模具铸钢的高温磨损机理。结果表明：随着RE加入量的增加，热锻模具铸钢的磨损率先减后增，RE加入量在质量分数为0．05％时热锻模具铸钢具有最佳的高温磨损性能。RE变质热锻模其铸钢的高温耐磨性明最高于H13钢和3Cr2W8V钢。高温磨损机理为氧化磨损和氧化物的疲劳剥落，磨屑为块状的Fe2O3和Fe3O4。     

超临界流体萃取仪器的研制

本文报道了以国产原配件为基础，成功地研制了分析规模的超临界流体萃取仪器、并对仪器性能进行了全面考察，仪器性能稳定，重现性良好（ＲＳＤ＜３．１％），定量线性关系可靠，可满足定量萃取的要求。     

Simultaneous determination of traces of heavy metals by solid-phase spectrophotometry

A coupling sensitive solid phase spectrophotometric (SPS) procedure for determination of traces of heavy metals (Me-SPS) and multicomponent analysis by multiple linear regressions (MA), a simple methodology for simultaneous determination of metals in mixtures was inaugurated. The Me-SPS procedure is based on sorption of heavy metals on PAN-resin and direct absorbance measurements of colour product Me-PAN sorbed on a solid carrier in a 1-mm cell. This methodology (Me-SPS-MA) was checked by simultaneous determination of metals in synthetic mixtures with different compositions and contents of metals important in pharmaceutical practice: Zn, Pb, Cd, Cu, Co, and Ni. Good agreement between experimental and theoretical amounts of heavy metals is obtained from the recovery test (78.3–110.0%). The proposed method enables determination of particular metal ion at the ng mL⁻¹ level and it was successfully applied to the determination impurities from heavy metal traces in pharmaceutical substances (Cu in ascorbic acid, Pb in glucose, and Zn in insulin). The proposed procedure could be possible contribution to the development of pharmacopoeial methodology for a heavy metals test.