Determination of the boiling point distribution of sulfur compounds in light cycle oil using GC with a flame photometric detector and pyrolyzer

A method has been developed to determine the boiling point distribution of sulfur compounds in light cycle oils (LCO'S). The method chosen for this analysis was GC with a flame photometric detector (FPD) and pyrolyzer. Tests were carried out to evaluate the recovery efficiency, repeatability, and accuracy of the method. Repeatabilities within 2% were obtained. The recovery of benzothiophenes and dibenzothiophenes was close to 100%; this was important because these are the major sulfur components in LCO's. No hydrocarbon or solvent interferences were observed with the use of the pyrolyzer, even for a 95% solvent level. Comparison with results from other techniques showed that the method accurately determined the levels of sulfur compounds in the LCO boiling point range.     

Nitro musks in cosmetic products—determination by headspace solid-phase microextraction and gas chromatography with atomic-emission detection

Summary The combination of headspace solid-phase microextraction with atomic-emission detection enables highly selective and sensitive determination of itro musk compounds in cosmetic products. Sample preparation is considerably simplified; there is no solvent extraction step. Enrichment is influenced by the type and amount of cosmetic product investigated. The lowest amount giving well detectable peaks is 1 mg musk compound per kg sample. Calibration curves obtained from spiked solutions of selected reference cosmetics in water show very good linearity. Relative standard deviations of peak areas from repeated measurements are usually <10%. Presented at the 21^st ISC held in Stuttgart, Germany, 15^th–20^th September, 1996     

一种短波电台频率合成器的研制

该文介绍一种采用Ｍｏｔｏｒｏｌａ公司ＭＣ１４５１４６和ＭＣ１２０１７／１８蕊片构成的短波电台频率合成器的硬件电路实现方案。频率合成器的输出频率范围２～２９．９９９９ＭＨｚ，频率间隔１００Ｈｚ，换频时间小于０．０１ｓ。文中论述了这种多环数字式频率合成器工作原理，各环路之间对应的频率关系和电路参数的选择，给出了频率合成器的试验结果．     

微波等离子体离子化检测器研究

本文采用氢气为载气和等离子体工作气体，以苯和二氧化碳为例，对不同电离电位样品组分经过和不经过等离子体两种样品引入检测器方式进行了详细的对比研究，发现检测器分别具有质量型和浓度型检测器的响应特征．探讨了空气引人等离子体对检测器分析性能的影响．     

高剂量率单次快脉冲辐射参量测量

记述了“强光一号”高剂量率脉冲辐射装置在状态调试过程中对其出射波形和辐射剂量进行监测的基本情况，实际监测的结果与设计方监测的结果进行了比对，双方的剂量监测值基本一致，偏差在20％以内；双方的波形形状十分相似，但测量得到的波形半宽度却相差10～20ns，最后对双方束流监测产生的差异进行了定性分析。     

Basic principles of technological shaping of optical properties and radiation hardness of PWO crystals

Technological conditions ensuring growth of optically homogeneous lead tungstate (PWO) crystals are reported. It is shown that the basic scintillator characteristics of PWO grown from highly purified raw material and properly doped with lanthanides are mainly determined by inclusions of oxides W_1−yL_yO_3−x (L=Y, La, Gd; 0<x<0.3). Moreover, surface-located inclusions with structure close to tungstenite may also be of importance. It is demonstrated that the scintillation properties can be intentionally designed by varying the oxygen content in the inclusions x and the surface structure. The optimal value for x and the most favorable surface structure are achieved by proper thermal regimes and environment content during the crystal annealing. The results enabled low-cost fabrication of PWO scintillators with steady and reproducible characteristics acceptable for the CERN project ALICE and ensured production of PWO on an industrial scale by “North Crystals” company at a rate of 125–135 crystals per year from every growth apparatus.     

InAs/GaAs quantum dot infrared photodetectors with different growth temperatures

InAs/GaAs quantum dot infrared photodetectors were fabricated with quantum dots grown at three different temperatures. Large detection wavelength shift (5–14.5 μm) was demonstrated by changing 40 degrees of the epitaxy temperature. The smaller quantum dots grown at lower temperature generate 14.5 μm responses. The detectivity of the normal incident 15 μm QDIP at 77 K is 3 × 10⁸ cm Hz^1/2/W. A three-color detector was also demonstrated with quantum dots grown at medium temperature. The three-color detection comes from two groups of different sizes of dots within one QD layer. This new type of multicolor detector shows unique temperature tuning behavior that was never reported before.     

μA级低功耗流量检测仪的设计

针对目前的流量检测仪在缺乏供电的场所无法对流量进行连续监测的问题,提出一种以零功耗磁敏传感器为信号采集前端,以低功耗MSP430F413单片机为控制器的流量检测仪的设计方法.介绍其工作原理和关键芯片的选型、硬件电路和软件流程.用此方法设计的流量检测仪功耗只有μA级,采用普通锂电池供电,非常适合在没有通电的地方使用.     

WIDE RANGE DETECTOR USING PARABOLIC CYLINDRICAL MIRROR FOR THz APPLICATIONS

A new, wide-band, high-speed and high-sensitivity THz detector has been developed. The prototype detector consists of a parabolic cylindrical mirror, a long wire antenna and a Schottky barrier diode. Direct detection measurements have shown a stable sensitivity of 150 ± 50 V/W for 1–2 THz without any adjustments. The long wire antenna was fixed at the focus of parabolic cylindrical mirror then it has been realized less operation steps, easy coupling to the external THz signals and a dramatic enhancement in the practicality of this system. The optically polished mirror and frosted surface one showed comparable sensitivities, thus easy polishing and less cost mirror fabrication can be applied for this system. The radiation pattern showed a maximum radiation angle of approximately 23° with its dominant main lobe, which was attributed to the wire antenna character and confirmed good agreements with classical antenna theory.     

工业CT图像均匀性校正

在工业CT图像重建过程中,射束硬化使得图像出现“杯状”伪影,阵列探测器响应不一致使得图像出现环状伪影、带状伪影和点伪影,影响图像均匀性.本文分析了射束硬化的原理和探测器响应不一致的数学模型,并通过实验,对探测器响应进行多挡板定标得到校正系数表.利用查表插值的方法对投影数据进行均匀性校正,消除上述伪影.