A charge-transfer challenge: combining fullerenes and metalloporphyrins in aqueous environments

A series of truly water-soluble C(60)/porphyrin electron donor-acceptor conjugates has been synthesized to serve as powerful mimics of photosynthetic reaction centers. To this end, the overall water-solubility of the conjugates was achieved by adding hydrophilic dendrimers of different generations to the porphyrin moiety. An important variable is the metal center of the porphyrin; we examined zinc(II), copper(II), cobalt(II), nickel(II), iron(III), and manganese(III). The first insights into electronic communication between the electron donors and the electron acceptors came from electrochemical assays, which clearly indicate that the redox processes centered either on C(60) or the porphyrins are mutually affected. Absorption measurements, however, revealed that the electronic communication in terms of, for example, charge-transfer features, remains spectroscopically invisible. The polar environment that water provides is likely to be a cause of the lack of detection. Despite this, transient absorption measurements confirm that intramolecular charge separation processes in the excited state lead to rapid deactivation of the excited states and, in turn, afford the formation of radical ion pair states in all of the investigated cases. Most importantly, the lifetimes of the radical ion pairs were found to depend strongly on several aspects. The nature of the coordinated metal center and the type of dendrimer have a profound impact on the lifetime. It has been revealed that the nature/electronic configuration of the metal centers is decisive in powering a charge recombination that either reinstates the ground state or any given multiplet excited state. Conversely, the equilibrium of two opposing forces in the dendrimers, that is, the interactions between their hydrophilic regions and the solvent and the electronic communication between their hydrophobic regions and the porphyrin and/or fullerene, is the key to tuning the lifetimes.     

高效液相色谱法同时测定稻田中苄嘧磺隆和苯噻酰草胺残留

建立了同时测定稻田(稻田土壤、水和植株)中苄嘧磺隆和苯噻酰草胺残留量的高效液相色谱(HPLC)分析方法。稻田水样品用二氯甲烷直接萃取;稻田土壤样品用碱性乙腈-二氯甲烷(1:1, v/v)混合液直接提取;水稻植株样品用碱性二氯甲烷提取后,二氯甲烷提取液经弗罗里硅土柱净化。上述样品溶液采用C18不锈钢色谱柱(150 mm×4.6 mm, 5 μm)分离,流动相为水-甲醇(30:70, v/v),流速为0.5 mL/min,柱温为30 ℃,紫外检测波长为238 nm,外标法定量。苄嘧磺隆和苯噻酰草胺在0.05～5.00 mg/L范围内的线性关系均很好(r＞0.9999)。在稻田水、土壤和水稻植株中添加3个水平(0.05, 0.10, 1.00 mg/kg)的苄嘧磺隆和苯噻酰草胺,两者的回收率均在85.39%～113.33%之间,相对标准偏差为0.91%～10.24%。这表明该方法的灵敏度、准确度和精密度均符合农药残留测定的技术要求。     

离子交换色谱法分离纯化鸡卵黄免疫球蛋白

建立了高效、经济、大规模获得鸡卵黄免疫球蛋白(IgY)的生产方法。在对传统的水稀释法改良的基础上,结合聚乙二醇沉淀与离子交换色谱进行IgY的分离纯化。结果显示,用8倍无菌水稀释蛋黄液,用0.1 mol/L HCl调节pH为5.2,在4 ℃下静置8 h,于5000×g力离心可得上清粗IgY液,经测定回收率可达93.47%。然后用6%聚乙二醇沉淀后经DEAE-Toyopearl 650 M离子交换纯化,最佳的纯化条件: 0.05 mol/L磷酸盐缓冲液(PBS, pH 7)平衡上样,0.075 mol/L PBS(pH 7)洗脱。十二烷基硫酸钠-聚丙烯酰胺凝胶电泳(SDS-PAGE)分析结果显示所得的IgY的纯度为95.02%,活性保持率高达73.77%。本研究弥补了传统分离方法不能同时达到高纯度和高回收率的缺点,且可用于大规模生产。     

硅钼杂多阴离子薄膜修饰电极的研究和应用——线性扫描伏安法测定水中可溶性硅酸盐

本文研究了以玻碳电极为基体的1:12硅钼杂多酸根(SiMo_(12)O_(40)~(4-)简称12-MSA)修饰电极的制备及其电化学行为,将12-MSA电极应用于线性扫描伏安法测定天然水中可溶性硅酸盐,结果满意.硅浓度在8.0×10~(-7)～1.7×10~(-3)mol/L,相对标准偏差(n=7)为1.85％,加标回收率为98.2％～103.6％,SiMo_(12)电极具有优良的选择性和稳定性。     

催化褪色光度法测定微量锰（Ⅱ）的研究

本文研究在硫酸介质中，锰（Ⅱ）催化ＥＤＴＡ还原重铬酸银，而使之褪色的新指示反应。确定了催化褪色反应动力学条件，锰（Ⅱ）的浓度在０－０．４μｇ／ｍｌ范围内，工作曲线呈良好的线性关系，检测限为０．０１１μｇ／ｍＬ，该方法用于天然水及污水中锰的测定，获得满意结果。     

茶汤及河水中铬的形态分析

本文采用７１７型强碱性阴离子交换树脂、活性炭分离富集与偶氮胂Ⅲ光度法结合，研究了铬形态的分离及测定，提出了铬的形态分析方法，有此法测定了茶汤及河水中铬的总量，悬浮态．溶解态、无机态、有机态、Ｃｒ（Ⅲ）和Ｃｒ（Ⅵ）。茶汤中铬主要以有机态存在，而河水中铬则主要以悬浮态存在。     

原子吸收光谱法测定气样中一氧化碳的研究

本文研究了用自制Ｎｉ（ＣＯ）４发生管和电加热石英管原子化器间接测定一氧化碳的条件，探讨了Ｎｉ（ＣＯ）４的产生和在石英管中原子化效率及干扰消除。     

银（Ⅰ）－硫脲－四正丁基溴化铵体系电致化学发光法测定水中痕量银

本文研究了银（Ⅰ）－硫脲－四正丁基溴化铵体系的电致化学发光（ＥＣＬ）。发现在正矩形脉冲下，银对含有硫脲的ＴＢＡＢｒ溶液的ＥＣＬ有明显催化作用，银（Ⅰ）的浓度在１．４×１０￣（－８）～３．５×１０￣（－６）ｍｏｌ／Ｌ范围内与ＥＣＬ强度呈良好线性关系。检出限为９．０×１０￣（－９）ｍｏｌ／Ｌ相对标准偏差为５％。用于天然水中银的测定，获得较满意的结果。     

Determination of hydroxycarbamates in aqueous matrices by direct derivatization and GC-MS analysis in chemical ionization mode

A rapid and effective procedure, developed for the determination of polar compounds in water, has been applied to hydroxycarbamates. In few minutes, it is possible to perform a catalyzed derivatization of such compounds directly in the aqueous medium, using n-hexyl chloroformate. Extraction with n-hexane and injection into a benchtop GC-MS system are the only two further steps to complete the analysis. Chemical ionization proved to be more effective than electron impact to produce valuable mass spectra in terms of selectivity and sensitivity. Linear quantitative responses were demonstrated over a two-order-of-magnitude range. The minimum detectable concentration was 3 ppb for acetohydroxamic acid and 10 ppb for hydroxyurethane, obtained from Po river water samples spiked with the two hydroxycarbamate standards.     

Demonstration of methylene-ether bridge formation in melamine-formaldehyde resins

¹H and ¹³C NMR have been used for the quantitative determination of methylene-ether bridges in melamine-formaldehyde (MF) resins. The amount of methylene-ether bridges was determined by ¹³C NMR from the number of monomethylolated amino groups consumed in the condensation reactions and is in agreement with that calculated from the condensation water contents. This latter method, which involves a combination of ¹H and ¹³C NMR, is based on the amount of condensation water released during the formation of both methylene and methylene-ether bridges. © 1995 John Wiley & Sons, Inc.