滤片-XRD探测系统响应时间测量

 研究了软X射线能谱仪探测道系统(系统包括X射线二极管（XRD）、SUJ-50-10电缆和不同频带示波器)的响应时间。实验利用上海激光联合实验室的20TW激光器激光(激光能量约20J，脉冲宽度约1ps)打金箔靶产生的X光，用XRD探测系统测量，记录示波器有TK684C，TK694C和WM8500等。将实验数据进行了线性拟合和比对分析。滤片XRD探测系统的响应时间随偏压升高而加快，随传输电缆长度的增加而变慢，因此测量快信号过程时，应提高探测器偏压，缩短传输电缆，选择宽频带高采样率示波器，以便减少系统的响应时间，减小信号失真程度。     

步进扫描时间分辨光谱及其在太阳电池光电导上的应用

建立傅里叶变换步进扫描时间分辨光电导光谱，并研究太阳电池中与转换效率密切相关的少数载流子寿命.实验选取三种典型的硅太阳电池(单晶硅样品1、多晶硅样品2和多晶硅样品3 )，发现其瞬态光电导的上升和衰退曲线可以分别用两个简单的指数函数描述.由于有复合中心的参与，复合过程中少数载流子的寿命比产生过程中的寿命短.为验证实验结果的可靠性，采用了提取样品少数载流子的体寿命和计算其有效扩散长度两种方法.通过与太阳电池暗伏安特性和负载特性研究相结合，进一步分析和讨论了少数载流子寿命与短路电流、开路电压和转换效率的关系.同时探讨了步进扫描时间分辨光谱实验的其他用途. 关键词： 步进扫描 时间分辨 硅太阳电池 瞬态光电导     

切伦柯夫相互作用中分段式慢波结构与均匀慢波结构的比较研究

 分析了切伦柯夫束波相互作用中使用单段慢波结构的缺点。指出在分段式慢波结构中，漂移段及其两端的慢波结构组成一Bragg谐振腔，当漂移段长度合适时，根据渡越时间效应理论，这种结构能减小调制束中电子的速度分散，提高束波转化效率。通过粒子模拟方法，比较了均匀慢波结构与分段式慢波结构中束波相互作用的物理图像，验证了理论分析结果，并说明了后者有束密度群聚充分，束电子速度分散小，产生微波功率高、频谱质量好，最佳工作电流大，输入电功率高等优点。     

X波段六腔渡越管振荡器的高频特性研究

 从麦克斯韦方程出发，采用时域有限差分法（FDTD）和离散傅里叶变换（DFFT）相结合的方法，通过数值计算得出了六腔开放式谐振腔中前四个谐振频率和场分布，计算出的谐振频率与实验测量结果基本相同。比较了开放腔和封闭腔谐振频率，验证了TEM波吸收边界条件，并在实际编程计算中得以应用。计算结果为六腔渡越管振荡器的机理研究提供了依据。     

分散剂对RF凝胶掺钛过程的影响

 以间苯二酚、甲醛和经分散的纳米钛粉为反应前体，利用物理掺杂方法研究了掺钛RF凝胶的制备工艺，并在凝胶过程中以zeta电位 粒径分布测试仪对溶液的粒径分布进行分析测试。实验发现六偏磷酸钠对纳米钛粉的分散性最好，掺杂后凝胶时间明显缩短；分散剂种类和用量对凝胶时间有较大影响，其用量为纳米钛粉量的50~100倍为宜。     

纳米KMn8O16粉体的室温固相合成与表征

室温或近室温固相反应要求绿色化、清洁化[1,2]。我们以KMnO4和MnCl2·4H2O为原料,用室温固相氧化还原反应制备氧化锰粉体时,得到了一种对H2O2分解具有较高催化活性的纳米KMn8O16粉体,用XRD、SEM、IR等技术对其进行了表征,发现研磨时间对粉体性能有显著影响。1　实验部分1 1　粉体的制备按摩尔比(2∶3)准确称取一定量的分析纯KMnO4和MnCl2·4H2O,分别置于玛瑙研钵中充分研细,再混合研磨,固相反应立即发生,体系颜色逐渐加深,并有刺激性气体产生,充分研磨后70℃恒温12h,固相产物依次经水洗至中性、醇洗、抽滤,真空干燥得黑色粉…     

Synthesis of Cationic PEM Emulsion and Application in Waste Water Treatment

Cationic polymer as a kind of flocculant is widely applied in purification treatment of waste water. Because it has positive charge group, it is able to connect strongly the suspended matters, short cellulose and other microparticles. The research on synthesis of cationic polymer and application in treatment of waste water is very universal abroad. But domestic research on those is not general. The technology of synthesis of PEM is simple, and the production cost is low. It is easy to apply in treatment of waste water.Synthesis of PEM Emulsion FlocculantSome distilled water, PVA(poly(vinyl alcohol)), EA(ethyl acrylate), and K2S2O8(potassium persulfate) were put into reaction vessel. Kept stirring up under nitrogen. When heated the solution to 40℃, dropped the water solution of MTA[(2-methacryloxylethyl)trimethyl ammonium].Maintained the temperature at 70℃, reacted about 7-8 hours. Then got the PEM emulsion. Changed the ratio of EA and MTA. Obtained a series of PEM emulsions.Stability and Convertibility of PEM EmulsionThe test results showed that when the EA/MTA was 85/15, the PEM emulsion was most stable.When the total monomer quantity was 35%, the convertibility of PEM emulsion was the highest,i.e.98.6%.The MTA Copolymerization Ratio and Morphology of PEM EmulsionWhen the monomers EA/MTA=85/15 and total monomer quantity was 35%, the MTA copolymerization ratio of PEM emulsion was 95.15%(the highest), and the PEM emulsion was some microspheres with 100-180nm of diameter.The Test Results of PEM Emulsion in Treatment of Waste Water The PEM emulsion flocculant was applied in treatment of waste water of paper mill, and measured the precipitation time(t) and transmittancy(T). The test results were showed in table 1. The optimum value of PEM which was able to make the waste water of paper mill into clear water was 0.008%.     

Nickel Chloride Promoted Glaser Coupling Reaction in Hot Water

A Glaser coupling reaction of terminal alkynes in the presence of nickel chloride withoutany organics and bases in hot water has been developed, which produces the correspondinghomo-coupling products in good yields.     

铁基添加剂增强细水雾灭火性能的实验研究

采用实验模拟的方法,研究了添加氯化亚铁的细水雾在不同添加剂浓度、不同喷头压力下,熄灭不同性质的液体池火的性能。实验结果表明:添加有氯化亚铁的细水雾,其灭火性能发生了显著变化。存在一个最佳的灭火浓度,其对应的灭火时间最短,耗水量最少,灭火效率最高。细水雾喷头的工作压力和燃料的性质也对细水雾的灭火性能有影响:工作压力越大,细水雾的平均灭火时间越短。在相同的实验条件下,细水雾扑灭煤油池火的时间要短于扑灭酒精池火的时间。