Improvement of the properties of polyarylate reinforced with liquid crystalline polymers

Blends of polyarylate of bisphenol A, PAr, with two commercial main chain liquid crystalline polymers, Vectra A950 and Vectra B950, are studied. From dynamic viscoelastic measurements it is deduced that both systems (PAr/Vectra A950 and PAr/Vectra B950) are immiscible and scanning electron microscopy (SEM) micrographs show the presence of spherical domains of the liquid crystalline polymer when PAr constitutes the matrix. Extrusion capillary measurements reveal that, under conditions of temperature and shear rate similar to those of processing, the viscosity is reduced to approximately 10% of its value when the content of liquid crystalline polymer is only 20%. This great improvement of the rheological properties is observed in both PAr/Vectra A950 and PAr/Vectra B950 blends. The effect of draw ratio on Young's modulus for different compositions is also analyzed, pointing out the reinforcing action of both liquid crystalline polymers on polyarylate: for instance, 20% of Vectra B950 in the blend gives rise to a 700% increase of the modulus of fibres prepared at a draw ratio of 50. SEM of the extrudates reveals that the spherical domains are elongated at the entrance of the capillary giving rise to a microfibrillar morphology which is related to the excellent rheological and mechanical properties of the blends.     

Synthesis of perfluoroheptanal by ozonolysis of perfluoro-1-octene

Perfluoro-1-octene was used as a model for developing a method for the preparative ozonolysis of perfluoro-1-alkenes to the corresponding perfluoro-nor-alkenals. Perfluoroheptanal was synthesized.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 6, pp. 1146–1147, June, 1994.     

二层底框混合结构抗震设计概述

在《建筑抗震设计规范（GBJ11－89）》中与底层框架砖房有关的条文规定和大量实际工程设计的基础上，对底部2层框架砖房的抗震设计问题进行探讨。     

含碳铬矿团块高温还原特性研究

在1250～1450℃高温范围内研究内配碳铬矿团块中Cr2O3还原率和总还原率与内配碳比和渣相碱度的关系,并分析了含碳铬矿团块还原过程中金属相和渣相聚集和分离状态的变化。结果表明,Cr2O3还原率主要受还原温度和内配碳比的影响,当还原温度高于1400℃时,控制适宜的渣相组成和内配碳比,可以实现还原产物中金属相和渣相的完全分离。利用实验得到的条件,可望开发一种新的廉价碳素铬铁的生产方法。     

浅析电机节能降耗改进方法

文章介绍了几种对矿山机电设备常用电机进行技术改造的方法，实现了节能降耗，降低成本的目的，对企业具有一定的经济价值。     

冷轧压下率分配对IF钢深冲性能的影响

冷轧压下率对IF钢的深冲性能有重要的影响。采用两次冷轧，在总压下率一定的情况下，两次冷轧压下率的分配是影响IF钢深冲性能的关键。通过冷轧实验，得出在总压下率一定时，两次冷轧比一次冷轧的塑性应变比r值要高；总压下率一定，一次冷轧压下率较小，两次冷轧压下率较大时，可使r值提高；同时，冷轧总压下率提高，也可使r值提高。     

A Diepoxide Belonging to the Rare C1 Point Group

2,6- and 2,7-Dimethylanthracenes were reduced seriatim with lithium in liquid ammonia and lithium in methylamine to their 1,4,5,8,9,10-hexahydro derivatives. Two-fold epoxidation of these tetraenes provided the cis and trans diepoxides resulting from electrophilic attack at the inner double bonds. Trans diepoxide 1 has the very unusual characteristic of lacking a σ plane of symmetry but possessing an inversion center. As a consequence, the ¹H NMR spectrum of C₁-symmetric 1 is simplified relative to those of its isomers 5, 9, and 10.     

钢液定氧测头响应时间和热平衡态

本文分别研究了ＺｒＯ２（ＭｇＯ）固体电解质管头壁厚，参比电极量对定氧测头响应时间的影响，得出了以ＺｒＯ２管头壁厚为０．６０－０．８０ｍｍ，Ｃｒ／Ｃｒ２Ｏ３参比电极加入量为４０－６０ｍｇ所组成的定氧测头响应速度最快，同时采用了“双偶法”对定氧测头在工作过程中的热平衡态进行了研究。结果表明：氧浓差电池中的传热是响应过程的控速步骤，氧电势曲线上峰值的产生是起源于电池中的热平衡态。     

砖混结构砌体工程量的统筹计算法

以砌体结构为例，阐明在工程量计算中应正确应用统筹法，并得出了砌体工程量计算的统筹公式。