正交各向异性矩形板受迫振动的三维分析

从正交各向异性三维弹性动力学的控制方程出发，在求得四边简支矩形板自由振动频率和位移振型的基础上，构造了受迫振动的位移函数；利用自由振动位移振型的正交性，将控制方程的空间变量和时间变量分离，得到了广义质量、广义力和频率表示的关于时间的2阶常微分方程，从而得到了正交各向异性弹性矩形板在受迫振动下的位移场和应力场．给出了本文方法与薄板理论的算例．     

Fiber-Optic Chemical Sensor for Detection of NO2 Using Poly (3-Octylthiophene)

A fiber-optic chemical sensor (FOCS) for detection of nitrogen dioxide (NO₂) molecules is reported. The FOCS presents an optropode structure because of the transmission properties of the sensitive material. The NO₂ FOCS is activated by using the semiconductor polymer: regioregular head-to-tail poly(3-octylthiophene-2,5-diyl). The operation wavelength of the sensor is 543.5 nm such that a simple LED and detector can be used for the design of this device. The sensor response decreases after each exposure, demonstrating the reduction in sensitivity as well as irreversibility lower than 5%. However, its properties such as rapid response, high selectivity, high sensitivity (0.43 ± 0.01 muW/ppm), hygroscopic properties, and its operation at room temperature make this kind of FOCS a good alternative for NO₂ toxic gas detection.     

Highly enantioselective fluorescent recognition of α-amino acid derivatives

Bisbinaphthyl-based macrocycles are found to carry out enantioselective fluorescent recognition of α-amino acid derivatives. It is observed that one enantiomer of a N-protected phenyl glycine can increase the fluorescence intensity of the binaphthyl fluorophores by over 4-fold but the other enantiomer does not cause much fluorescence enhancement. This highly enantioselective fluorescent response makes the binaphthyl macrocycles practically useful for the enantioselective fluorescent recognition of the amino acid substrate.     

Thermoelastic interactions without energy dissipation in an unbounded body with a spherical cavity subjected to harmonically varying temperature

The present work is concerned with the thermally induced vibration in a homogeneous and isotropic unbounded body with a spherical cavity. The Green and Nagdhi model of thermoelasticity without energy dissipation is employed. The closed form solutions for distributions of displacement, temperature and stresses are obtained. The solutions valid in the case of small frequency are deduced and the results are compared with the corresponding results obtained in other generalized thermoelasticity theories. Numerical results applicable to a copper-like material are also presented graphically and the nature of variations of the physical quantities with radial coordinate and with frequency of vibration is analyzed.     

光纤传感振动检测系统及其实验研究

实际工程结构中的振动检测是十分重要的，也是十分复杂的，常用的结构振动检测传感器易受工程现场恶劣环境的影响．而光纤传感器具有小巧、抗电磁干扰、灵敏度高、适合长期监测等优点。本文建立了基于马赫—曾德(Mech-Zehnder)干涉原理的光纤传感振动检测系统．研制了运用先进的数字信号处理技术采集和处理数据的专用软件，并在典型结构件——钢制悬臂梁结构上进行了外加信号作用下的强迫振动检测和冲击载荷作用下的自由衰减振动检测，测量了该结构件的频率及振幅，其结果与同时进行的成熟的电测结果相近，说明光纤传感器用于结构件的振动测量是可靠的。本文为光纤传感器应用于实际工程的振动检测提供了新的技术装置，具有工程应用前景。     

精密镗削头振动模态的实验研究

通过对国产与进Ｄ的同类型精密镗削头振动模态实验研究，找出了这两种精密镗削头的固有振动频率，给出了它们的各阶动画振型图．从这一侧面解释了国产精密镗削头回转精度偏低的原因。     

等腰三角形Mindlin板的自由振动分析

提出了一种新方法来对基于 Mindlin剪切变形理论的等腰三角形板进行自由振动分析 .此方法采用了一种新的基函数并利用 pb-2 Rayleigh-Ritz边界函数得到了一种新型的 Ritz方法 .这种方法的有效性通过收敛性和对比性分析得到了证实 .数值结果表明此方法相当精确有效 .     

Simulation and fabrication of carbon nanotubes field emission pressure sensors

A novel field emission pressure sensor has been achieved utilizing carbon nanotubes (CNTs) as the electron source. The sensor consists of the anode sensing film fabricated by wet etching process and multi-wall carbon nanotubes (MWNTs) cathode in the micro-vacuum chamber. MWNTs on the silicon substrate were grown by thermal CVD. The prototype pressure sensor has a measured sensitivity of about 0.17-0.77 nA/Pa (101-550 KPa). The work shows the potential use of CNTs-based field-emitter in microsensors, such as accelerometers and tactile sensors.     

The effect of construction material, contents and room geometry on the sound field in dwellings at low frequencies

An experimentally validated finite element method is used to model the sound level in rooms at low frequencies. It is demonstrated that the dimensions of rectangular rooms strongly influence the sound pressure level difference. Additional factors were investigated which are not normally considered in the frequency range where diffuse sound field conditions can be assumed. Three effects were investigated: room damping due to wall vibrations, furniture, the effect of small deviations from simple rectangular shapes. It is confirmed by field measurements that the vibrations of masonry walls and floors introduce less damping than surfaces of lightweight construction. Assigning to the FE model a damping equivalent to a surface absorption of 0.02 reproduces the effect of walls of heavyweight construction. Damping equivalent to a surface absorption of 0.15 reproduces the effects of plastered timber-frame walls, floors and ceilings. The work was briefly extended to a room pair built with heavyweight and lightweight material of construction. The modification of the shape of the room frequency response highlights well the effect of material of construction. In-situ and laboratory measurements show that furniture has little effect on steady-state room response below 100 Hz. Modelling a wall recess smaller than 0.5 m improved the agreement between prediction and measurements but the assumption of a simple rectangular room remains appropriate.     

Three methods for analyzing forced vibration of a fluid-filled cylindrical shell

The forced vibration of an infinite elastic circular cylindrical shell filled with fluid is studied. Three methods are employed to analyze the forced vibration problem of this shell-fluid coupled system, that is, wave propagation approach (wave mode superposition), theorem of residues and a numerical integral method. In order to explain these methods more explicitly, before being used to investigate the vibration of an infinite fluid-filled elastic circular cylindrical shell, all these three methods are employed firstly to analyze the forced vibration problem of an infinite beam and an infinite elastic circular cylindrical shell in vacuo. Advantage and disadvantage of these three methods are discussed and their interesting relationship is revealed. That is, to any circumferential wavenumber and frequency of the external force, there is an unchangeable relationship between the general coordinates of various waves in the wave propagation approach and the residuals in the theorem of residues.