Fabrication of isotype (p-p) selenium-polyaniline heterojunction diode by electrochemical method

In the present work, for the first time, heterojunction has been fabricated using electrochemically deposited isotype p-selenium-p-polyaniline from a single solution bath. The structural characterization of selenium and polyaniline thin film was carried out using XRD technique. Polyaniline exhibited amorphous structure while selenium offered monoclinic (β) phase. The junction was formed by electrodepositing polyaniline over selenium film and heating at 423 K. The current density versus voltage (J-V) plot showed the formation of a junction with ideality factor of 1.16. From J-V characteristics at different temperatures, static resistance (R_s), dynamic resistance (R_d), and rectification ratio of diodes were determined. Heat treatment above 448 K caused junction breakdown.     

价格战的运用与应对研究

随着我国市场化改革的不断深入，价格战已经逐渐成为许多企业主动或被动频繁使用的策略。从产品生命周期，产品组合策略，产品边际成本等方面分析了运用价格战应考虑的因素，同时提出了应对价格战的措施和价格战向价值战转变的建议。     

复变函数论教学内容与教学方法的新探

随着高中数学教材内容的不断更新,高师院校复变函数论课程内容和教学方法的调整势在必行。本文在分析现状的前提下,就复变函数论课程内容和教学方法进行了一些有益的探索。     

Electrical properties of polypyrrole/p‐InP structure

The polypyrrole/p‐InP structure has been fabricated by the electrochemical polymerization of the organic polypyrrole onto the p‐InP substrate. The current–voltage (I–V), capacitance–voltage (C–V), and capacitance–frequency (C–f) characteristics of the PPy/p‐InP structure have been determined at room temperature. The structure showed nonideal I–V behavior with the ideality factor and the barrier height 1.48 and 0.69 eV respectively. C–f measurements of the structure have been carried out using the Schottky capacitance spectroscopy technique and it has been seen that there is a good agreement between the experimental and theoretical values. Also, it has been seen that capacitance almost show a plateau up to a certain value of frequency, after which, the capacitance decreases. The higher values of capacitance at low frequencies were attributed to the excess capacitance resulting from the interface states in equilibrium with the p‐InP that can follow the a.c. signal. The interface state density N_ss and relaxation time τ of the structure were determined from C–f characteristics. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 1572–1579, 2006     

横向爆炸载荷下开孔弹性板的应力集中

基于ANSYS 7.0/LS-DYNA程序,对3 m×3 m四边简支、厚度为0.025 m、中心开有0.3 m×0.3 m方孔的弹性板,在下三角爆炸载荷作用下的应力响应进行了分析;利用能量密度时间分布函数(TDFED)确定了动应力集中因子,重点讨论了时间步长和采样时间间隔对计算结果的影响。     

可变分区存储管理方式的模拟

论述了如何用C语言模拟可变分区存储管理方式的过程。形象地展示了操作系统中可变分区存储管理中采用的最佳适应算法的分配与回收过程，达到了理论与实践相联系的目的。     

环境因素对跳远踏板准确性的分析研究

采用实验法、数理统计法对江西省不同等级男子跳远运动员踏板准确性受环境因素影响进行研究.结果表明:塑胶跑道与煤渣跑道,顺风跑,逆风跑,阴天,大量观众,噪音对跳远踏板准确性都具有较明显的影响.跳远运动员踏板的准确性一般不受运动员等级水平的影响.     

Gas transport through homogeneous and asymmetric polyethersulfone membranes

Both homogeneous and asymmetric polyethersulfone (PES) membranes were prepared by solvent casting. The sorption and permeation behavior of CO₂, O₂, and N₂ using these two kinds of cast PES membranes and commercially available homogeneous PES film was investigated to extract the pressure dependence of gas permeability and the permselectivity for CO₂ relative to N₂, and to confirm the validity of the working assumption that a skin layer in an asymmetric membrane can be essentially replaced by a thick homogeneous dense membrane. The pressure dependence of the mean permeability coefficient to CO₂ in homogeneous membranes obeys the dual-mode mobility model. The ideal separation factor for CO₂ relative to N₂ at an upstream pressure of 0.5 MPa attains ca. 40, while the permeability to CO₂ is about 2.7 Barrer at the same upstream pressure. The same separation factor in asymmetric membranes amounts to 35. The diffusion behavior for the skin layer in an asymmetric membrane with a thin skin layer can be simulated approximately by that in a homogeneous dense membrane. © 1993 John Wiley & Sons, Inc.     

成本性态法在分析可比产品成本降低计划完成情况中的应用

本文根据成本性态法的思路．分析了影响可比产品成本降低额和降低率变动的因素，重点从理论上论证了产品品种结构的影响，并且合理地把单纯产量和品种结构对可比产品成本降低额（率）的影响分离开来．     

1．5GHz锯材超导腔的研制

介绍铌材超导腔的研制进展，重点讨论了国产铌腔的材料改性，以及相应的超导腔性能的改进．叙述了１．５ＧＨｚ铌腔的腔形设计，分析了铌材的射频性能和机械性能，制定了铌腔制作与后处理的特定工艺．最后给出了１．５ＧＨｚ铌材超导腔的低温实验结果．