Alloy formation in mechanically activated mixtures

The physical mixtures of hydroxocarbonates of Cu and Ni with aluminium were activated using a laboratory planetary mill. The chemical reactions and alloy formations as the effects of grinding were followed by the phase analysis of solid products based on the thermogravimetry and X-ray diffractometry. Experimental evidence indicates that the nature of reactions and products of mechanical activation was dependent on the amount of aluminium and time of grinding. This revised version was published online in July 2006 with corrections to the Cover Date.     

黄磷废水处理系统中氰降解菌的筛选

首次对含有氰化物的黄磷废水进行了氰降解菌筛选优化,共得耐氰菌20株,其中有9株的降氰率在90％以上,且AB2001003菌株降氰率在97.1％以上.该菌能在72 h内使含CN~-50mg·L~(-1)的黄磷废水降至0.5 mg·L~(-1)以下,达到国家一级排放标准.该菌的最佳生长pH7.7,最佳温29℃.     

Dehydration and dehydroxylation of reduced charge montmorillonite

Reduced charge montmorillonites (RCM) were prepared by the thermal treatment of lithiumsaturated montmorillonite. Samples prepared by mild thermal treatment with lithium contained more water sorbed than the original montmorrilonite. When RCMs were prepared, part of the lithium cations reacted with hydroxyl groups in the octahedral sheet and released protons, which reacted with the structure. Acid treatment probably enhanced the surface area. which was reflected in the amount of water sorbed. Deprotonation of hydroxyl groups was proved by the measurements of the ignition loss. The heating of lithium saturated montmorillonite at higher temperatures brough about the collapse of the interlayers and a decrease in the amount of water sorbed.     

用聚砜超滤膜处理含油污水的实验研究

主要研究了处理含油污水用的聚砜超滤膜的分离、透过性能与制膜液配方(聚合物浓度、溶剂及添加剂的种类和配比)之间的关系.确定了最佳的制膜液配比.所制得的膜在操作压力为0.36MPa(绝)时,其纯水通量为750L/(m~2·h).处理含石油类36～100ppm的含油污水时透过液通量达130～355L/(m~2·h).透过液中含油量降至10ppm以下.透过液中的石油类、悬浮物及色度等都基本上达到国家排放标准及油田注水用标准.     

采用热处理方法提高MEH-PPV单层聚合物有机发光二极管发光性能的研究

对以MEH－PPV为发光层的单层聚合物有机发光二极管（OLED）器件在最佳条件下进行真空热处理，并用金相显微镜观察施加电压后器件的阴极表面形貌。发现处理后的器件阴极表面的气泡及黑斑明显减少。器件的发光性能显著提高。与未经处理的器件相比，最大相对发光强度提高了一个数量级、启亮电压降低了2．0V，半寿命提高了12．7倍。初步分析表明热处理方法提高器件发光性能的主要原因在于有效地减少了器件在工作过程中由于焦耳热产生的某些气体，从而减少阴极表面气泡及黑斑的出现，另一方面，热处理方法也增强了有机发光层与阴极接触界面的结合力，提高电子注入水平。     

论GIS模糊不确定性以及处理方法探讨

论述了GIS模糊不确定性的认识，介绍了不确定性的相关概念，阐述了GIS的模糊不确定性，及其处理方法。     

西安城市周边地带的界定

在定义城市周边地带的基础上，分析了城市周边地带城市化特征．根据西安市城市空间结构现状，利用专家打分法确定了西安市各区县隐性城市化调整系数，提出计算其城市化率的公式．根据计算结果初步界定了西安城市周边地带范围．     

A comparative study of the silent discharge treatment of saturated and unsaturated hydrocarbon polymers

Dielectric barrier air discharge treatment of polyethylene, polypropylene, polyisobutylene, polystyrene, and polyisoprene substrates has been characterized by x-ray photoelectron spectroscopy (XPS). The relative reactivities of these polymers towards silent discharge oxidation are rationalized in terms of ozone molecules interacting with an excited surface. © 1994 John Wiley & Sons, Inc.     

Towards understanding the increase in strength of thermotropic polyesters with heat treatment

Thermotropic copolyester fibers of oxynaphthoate and oxybenzoate have been subjected to conditions that promote solid-state polymerization as well as annealing. The annealing process causes the crystals to perfect with a simultaneous increase in heat of fusion and melting temperature. Solid-state polymerization, a reaction rate-controlled process, causes the polymer viscosity average molecular weight to increase by chain extension from about 14,000 g/mole to more than 87,000 g/mole with a simultaneous impressive increase in tenacity from about 10 g/d (1.2 GPa) to almost 30 g/d (3.7 GPa). To understand the changes in mechanical properties, we have modeled the fiber structure as short rod-like molecules poorly bonded to a continuous matrix of parallel molecules. Lengthening of the reinforcing molecules facilitates better transfer of load from matrix to molecules, resulting in higher tenacity fibers. © 1994 John Wiley & Sons, Inc.     

水泥处理的沉积淤泥膨胀试验及其矿物机理分析

为研究经过水泥掺合处理的河道沉积淤泥作为路基填料的膨胀性能，对不同初始含水量（质量分数分别为90％，130％和170％）的淤泥经不同掺合比（按湿质量计分别为9％，11％和13％）的水泥处理后形成的多种不同的水泥土试样进行了为期一个月的初次膨胀试验及试样干燥三个月后重新浸水的二次膨胀试验。试验结果表明试样的初次膨胀值很不显著，但二次浸水膨胀试验表明试样的总膨胀量有增大的趋势。试样的X射线衍射分析从矿物形成方面解释了水泥土膨胀性能的内在机理。