介孔材料-酸性红12染料分子体系动力学模型的建立和模拟

以酸性红12作为多苯环长链发色有机物的代表,通过对有效扩散系数的测定,确定其在介孔材料颗粒体上的吸附等温式和平衡接近率随时间变化的关系.利用非稳态扩散传质与非稳态热传导过程类比速率方程相似的特点,应用Peterson的热传导近似公式,用计算机求解超越方程,得到了酸性红12在介孔复合材料颗粒内的有效扩散系数并进行了拟合验证,得出该传质过程的主要作用力类型.     

多维非定常中子迁移方程Galerkin有限元法近似解的收敛性和广义解的存在性

使用Galerkin有限元法研究了多维非定常中子迁移方程，证明了Galerkin有限元法近似解的收敛性和广义解的存在性．     

Wavelet method for solving the unsteady porous-medium flow problem with discontinuous coefficients

A method is proposed for constructing stable approximate wavelet decompositions of weak solutions to boundary value problems for the unsteady porous-medium flow equation with discontinuous coefficients and inexact data. The method is based on the general scheme for finite-dimensional approximation in Tikhonov regularization and on multiresolution analysis with basis functions defined as the product of one-dimensional Daubechies wavelets.     

室内环境参数对室外气象参数瞬时变化的动态响应研究

为研究空调房间室内环境参数对室外气象参数瞬时变化的动态响应,采用CFD中的标准k-ε模型对兰州地区某办公室在考虑非稳定传热情况下的室内气流组织和污染物浓度场进行数值分析,获得了顶送风/下回风和侧送风/下回风两种通风模式下室内流场、温度场及污染物浓度场的分布。结果表明:不同时刻的太阳辐射通过激励室内自然对流换热过程对室内污染物的空间分布及迁移特性产生了显著影响。同一送风模式下,16:00时室内的污染物浓度较8:00时均匀,而8:00时的污染物浓度平均水平较高;在同一送风参数下,采用顶送风方式时更有利于降低室内污染物浓度。     

Transition to chaos in lid-driven square cavity flow

To date, there are very few studies on the transition beyond second Hopf bifurcation in a lid-driven square cavity, due to the difficulties in theoretical analysis and numerical simulations. In this paper, we study the characteristics of the third Hopf bifurcation in a driven square cavity by applying a consistent fourth-order compact finite difference scheme rectently developed by us. We numerically identify the critical Reynolds number of the third Hopf bifurcation located in the interval of (13944.7021,13946.5333) by the method of bisection. Through Fourier analysis, it is discovered that the flow becomes chaotic with a characteristic of period-doubling bifurcation when the Reynolds number is beyond the third bifurcation critical interval. Nonlinear time series analysis further ascertains the flow chaotic behaviors via the phase diagram, Kolmogorov entropy and maximal Lyapunov exponent. The phase diagram changes interestingly from a closed curve with self-intersection to an unclosed curve and the attractor eventually becomes strange when the flow becomes chaotic.     

明渠非定常水流的垂向结构实验研究

本文报告了明渠非定常水流垂向结构的实验研究,通过 LDV 激光测速,我们给出了非定常水流的速度削面,湍流度,Eulerian质量输运速度的垂向分布。实验结果表明:在非定常周期很长时非定常流动的速度剖面,湍流强度及其粗糙度的影响基本上与定常流动相一致,当非定常流动为纯往复流动时,存在一个逆时针方向的环流,这种环流有利于底部的质量输运。     

Measurements in the vaneless diffuser of a radial flow compressor

Results from an experimental study of flow behaviour at the inlet of a vaneless diffuser of a centrifugal compressor are presented. Measurements from a crossed hot-wire probe are given for operating points having inlet flow coefficients ranging from 0.006 to 0.019 at different Reynolds numbers. Instantaneous, time-averaged, and phase-averaged absolute velocity and flow angle at the diffuser inlet are deduced from the hot-wire signals after correction for mean density variations. These results show how flow behaviour varies in stable, rotating stall and surge regimes of compressor operation     

Characteristic Regimes of Transitional Separation Bubbles in Unsteady Flow

This experimental investigation deals with transition phenomena of a separated boundary layer under unsteady inlet flow conditions. The main purpose of this investigation is to understand the influence of the rotor-stator interaction in turbomachinery on the subsequent, highly loaded boundary layer. The research project is divided into two phases. In the first phase, which has been completed recently, only the variation of mean velocity caused by upstream blades was simulated in the experiments while the free-stream turbulence intensity was retained at a constant low level. The experiments are carried out in an Eifel-type wind tunnel to investigate the laminar separated boundary layer of a flat plate under oscillating inlet conditions. The adverse pressure gradient, similar to that of turbomachines, is generated by the contoured upper wall. The unsteadiness is produced by a rotating flap located downstream of the test section. The reduced frequency, the amplitude and the mean Reynolds number are varied to simulate the conditions prevailing in turbomachines. In addition to the Kelvin–Helmholtz instability of the separated shear layer, a lower frequency instability was observed. This is frequently referred to as `free shear layer flapping' and results in two distinctly different ways of re-attachment, depending primarily on the Reynolds number. For low momentum thickness Reynolds numbers at the separation point, large-scale vortices locked to the frequency of the unsteady main flow are identified. They originate nearly at the top of the separation bubble and are ejected downstream. A fully turbulent boundary layer develops after these vortices mix out. For higher Reynolds numbers, transition is completed within a short length of the free shear layer and there-attachment region. The characteristic momentum thickness Reynolds number separating these two regimes in unsteady flow is about 125. The Strouhal number (reduced frequency) does not appear to have any significant effect. Based on the experimental results, this behaviour is discussed in some detail. This revised version was published online in July 2006 with corrections to the Cover Date.     

Maxwell流体管内起动流的研究

对Maxwell流体流体管内起动流的振荡特性进行研究，得到了描述振荡特性的解析解。研究了黏弹性参数对各时刻速度剖面的影响，获得了轴心速度，平均速度和壁面摩擦力随时间的变化规律以及它们的频率特征。结果表明振荡的基频成分决定了流动的主要特性，给出了并分析了基频频率与振幅和黏弹性参数之间的关系。