Heating rate effect on the DSC kinetics of oil shales

This research was aimed to investigate the combustion and kinetics of oil shale samples (Mengen and Himmetoğlu) by differential scanning calorimetry (DSC). Experiments were performed in air atmosphere up to 600°C at five different heating rates. The DSC curves clearly demonstrate distinct reaction regions in the oil shale samples studied. Reaction intervals, peak and burn-out temperatures of the oil shale samples are also determined. Arrhenius kinetic method was used to analyze the DSC data and it was observed that the activation energies of the samples are varied in the range of 22.4–127.3 kJ mol⁻¹ depending on the oil shale type and heating rate.     

Free and Glycosidically Bound Volatiles of Mentha longifolia Growing in Croatia

The glycosides of volatile compounds and the essential oil were isolated from wild Mentha longifolia. After the enzymatic hydrolysis of glycosides, fourteen volatile aglycones were identified by GC/MS. The main aglycones were eugenol, 2-phenylethanol, benzyl alcohol, lavandulol, trans- and cis-carveol, 3-octanol, and 3-hexen-1-ol. The content of aglycones was 40.85 mg kg^-1 of dried plant material. The main components of the essential oil (yield 0.93 w/w) were carvone, piperitenone oxide, limonene, and -caryophyllene. Eugenol, carveol, 3-octanol, and -terpineol were identified in the aglycones and in the essential oil.     

两组份互穿网络聚合物的合成研究

以蓖麻油聚氨酯和聚醚聚氨酯的不同重量比与光敏剂、催化剂、稀释剂、促进剂所组成的多相体系为反应物,分别在紫外光照射和加热的条件下合成网络Ⅰ和网络Ⅱ的互穿网络聚合物(IPN)。改变网络Ⅱ聚醚聚氨酯中各组份的摩尔比制得系列样品。红外光谱,应力-应变曲线和动态力学性能测定发现,样品的力学性能与两组份重量比和网络Ⅱ中不同组成都存在着一定关系。这些结果,为该体系IPN的合成和应用提供了一定依据。     

实验室废液的回收及效果评价——以“铬废液回收及评价”为例

This paper introduces an experiment about waste liquid recovery and effect evaluation in laboratory. Through this experiment, the basic operations of crystal preparation, chemical analysis and instrumental analysis are further consolidated. At the same time, it allows students to experience a series of possible problems of condition selection and control in the process of waste liquid treatment. We hope to improve the students' ability to analyze and solve problems, enhance their interest in learning, and strengthen their humanistic education.     

Setting up of recovery profiles: A tool to perform the compliance with recovery requirements for residue analysis

The use of the recovery term has presented some confusion in Analytical Chemistry. Recent IUPAC recommendations propose to distinguish between two terms: recovery or recovery factor, ℜ, and apparent recovery, ℜ*. Apparent recovery includes recovery factor and a new recovery term proposed in this paper, named calibration recovery, ℜ^C, which depends of the type of systematic error due to the matrix effect (constant and/or proportional) and is related to the applied calibration methodology. This paper highlights the dependence of the calibration recovery on the sample analyte concentration and, for extension, of the apparent recovery, defines the recovery profile, and makes evident the need to determine a “fit for purpose” analyte concentration interval to comply with a regulated recovery requirements. An approach to estimate the calibration recovery and its associated uncertainty in relation to the above-mentioned dependence is presented. The usefulness of the proposed methodology has been shown in the quantification of a pesticide by GC-ECD for assessing dermal exposure.     

原油三维荧光分析中猝灭现象辨析

研究了原油的三维荧光猝灭现象，指出浓度过高是原油产生荧光猝灭的主要原因，将会造成三维荧光等值线图畸变，致使定量分析数据失真，谱图特征变异，难以获取原油特征三维指纹图。提出了避免荧光猝灭的预试方法，并列出了不同类型原油的最佳测试浓度。     

Volatile constituents of flowers and leaves of Anthemis hyalina

The chemical composition of the essential oils of the flowers and leaves of Anthemis hyalina were analyzed by GC and GC-MS for the first time. The oils were found to contain seventy-two components. cis-Chrysanthenyl acetate (14.9% and 17.8%), camphor (11.6% and 1.7%), terpinen-4-ol (8.3% and 1.2%), germacrene-D (5.1% and 2.1%), β-caryophyllene (4.1% and 5.4%), myrcene (3.6% and 16.9%), bicyclogermacrene (3.5% and 0.9%), α-pinene (2.3% and 4.1%), cis-β-ocimene (2.1% and 4.3%) and isospathulenol (0.4% and 4.3%) were found to be the major constituents of the oils of flowers and leaves respectively. Published in Khimiya Prirodnykh Soedinenii, No. 5, pp. 428–429, September–October, 2006.     

Oxidation kinetics of timahdit and tarfaya moroccan oil shales

Organic matter evolution and kinetics of combustion of Tarfaya and Timahdit oil shales have been examined by thermogravimetry (TG) and by differential thermal analysis (DTA). An agreement is observed between both techniques where it was found that combustion of organic matter occurs in two steps. Kissinger's method applied on experimental results gives an activation energy of the same magnitude for the first step of both oil shales (103 kJ mol^–1) whereas the second is 148 kJ mol^–1 for Timahdit and 118 kJ mol^–1 for Tarfaya.The changes in specific surface area during thermal combustion of Timahdit and Tarfaya oil shales have been studied by thermogravimetric gas sorption balance and correlated with experimental results obtained on TG/DTA in air. For Timahdit oil shale oxidation products, specific surface areas calculated from nitrogen adsorption data shows a slight increase during the temperature domain of 280 to 430°C and after this temperature, they increase sharply. However, data obtained with Tarfaya oil shales shows a significant increase at the temperature of maximum oxidation of the first stage of combustion of organic matter.This revised version was published online in November 2005 with corrections to the Cover Date.     

COMPOSITION OF THE ESSENTIAL OIL OF Haplophyllum myrtifolium

The chemical composition of the essential oil ofHaplophyllum myrtifoliumBoiss., endemic to Turkey, was examined by GC/MS. Ninety-seven compounds were characterized with linalool (12.8%), -caryophyllene (10.3 %), and methyleugenol (5.9 %) as the main constituents.     

以催化油浆窄馏分为添加剂的Al－MCM－41分子筛的合成

 采用阳离子表面活性剂十六烷基三甲基溴化铵为模板剂，以正硅酸乙酯为硅源，以硫酸铝为铝源，水热合成了以催化油浆窄馏分为添加剂的高比表面积Al－MCM－41介孔分子筛，并利用XRD，HREM，TG－DTA及N2吸附－脱附等测试手段对合成样品进行了表征．合成的Al－MCM－41分子筛的比表面积和孔体积分别达到1295m2／g和1．5cm3／g，其平均孔径为4．3nm．重点研究了Al－MCM－41分子筛结晶度、晶胞参数、比表面积、孔体积及平均孔径等结构性质随催化油浆窄馏分添加量及其组成的变化规律，并从合成机理上进行了解释．