Composition of <Emphasis Type="Italic">Carlina acanthifolia</Emphasis> Root Essential Oil

The root of Carlina acanthifolia All. (Asteraceae) contained 1.0% of essential oil (expressed in g per 100 g of dried plant material). Using GC and GC/MS, nine components were identified (100% of total oil). The structure of benzyl 2-furylacetylene (carlina oxide), which is the principal component of the oil (91.5%), was spectrometrically identified. __________ Published in Khimiya Prirodnykh Soedinenii, No. 4, pp. 331–332, July–August, 2005.     

Instantaneous strain recovery elasticity and endothermic heat change in nylon-6 monofilaments and silicone rubbers

The instantaneous elastic moduli for a nylon-6 monofilament were derived on strain recoveries right after creep, stress relaxation, and rapid elongation,E _c ,E _s andE _e , respectively. It was found that during strain recoveryE _s (>E _e ) andE _e increase monotonically with increasing load,m ₁, on the sample. The extrapolated value of E_s atm ₁=0 g is almost equal to Young's modulus, 4.06 GPa. The value ofE _c also increased with increasingm ₁, and atm ₁=600 g (1.93 t cm^–2) reached about 14 GPa. The endothermic heat change right after creep, stress relaxation or rapid elongation,Q, was negligibly small. For comparison,E _s ,E _c andQ were also investigated for silicone rubber. It was found thatE _s (53.8 M Pa at the draw ratioD=1.2) decreased abruptly atD=1.3. In the range ofD=1.4–1.9,E _s was only 22.6 MPa. In the case of stress relaxation,Q increased with increasingD from 4 J mol^–1 (atD=1.2) to 56 J mol^–1 (atD=1.9). FurthermoreE _c (5.58 MPa atm ₁=133.8 g (429.4 kg cm^–2)) increased gradually with increasing m₁ and attained 16.6 MPa atm ₁=548.4 g (1.76 t cm^–2). In the case of creep,Q was in the range of 0–11.5 J mol^–1 and larger when larger loads,m ₂ were removed during the later stages of creep.Dedicated to Professor Bernhard Wunderlich on the occasion of his 65th birthdayThe author wishes to thank Mr. Keizi Igarashi and Mr. Tetsuya Yasui for helping in the experiments.     

Highly sensitive determination of haloperidol in human serum by capillary gas chromatography using a surface ionization detector

A method has been developed for highly sensitive determination of haloperidol in human serum involving a simple extraction procedure followed by gas chromatographic separation. Target components were separated from the extracting solvents with a Van den Berg type solventless sample injector before introduction Into a DB-1 capillary separation column. A surface ionization detector (SID), which has highly selective sensitivity for Substituted amines, was employed for quantitation using bromperidol as an internal standard. Chloroform proved to be the best extracting solvent, yielding a quantitative detection limit of 5 ng/ml (S/N = 2). Comparison of the response to target compounds obtained by the SID, FTD (flame thermionic detector), and FID (flame ionization detector) showed the SID to be superior.     

STUDIES ON TUNG OIL COATED REGENERATED CELLULOSE FILMS WITH WATERRESISTANCE

Regenerated cellulose films with water-resistance were obtained by an improved method ofpreparing cellulose cuoxam solution from pulps of agricultural wastes (linters, wheat straw, reedand Bamao). Experimental results showed that the mechanical properties of both the dry. and wetfilms were excellent. Data from IR, SEM and tensile strength measurements implied that thesignificant improvement of water-resistance of the films was due to the cohesion between the thinTung oil covers with hydrophobicity and the regenerated cellulose films. The films werecompletely biodegraded after being buried in soil for 100 days. The transmittance of the filmsderived from linter and reed in visible band range were 80-90%.     

Addition of secondary phosphines to N-vinylpyrroles

Secondary phosphines 1-3 react readily with N-vinylpyrroles 4 and 5 under radical initiation to give regiospecifically anti-Markovnikov adducts, diorganyl-2-(1-pyrrolyl)ethylphosphines 6a-d, highly reactive building blocks for organic synthesis, in 88-91% yields.     

GC-MS Analysis of the Essential Oil from the Oleoresin of Pistacia atlantica var. mutica

The oleoresin of Pistacia atlantica var. mutica, growing in different regions of Iran, is a popular naturally occurring chewing gum and has been used traditionally in the treatment of peptic ulcer. The GC-MS analysis of the essential oil, obtained from steam distillation of the oleoresin of P. Atlantica var. mutica, has led to the identification and quantification of eleven terpenoids, -pinene (70%), -pinene (1.94%), 3-carene (0.2%), carveol (2.18%), epoxypinene (2.15%), limonene oxide (9%), myrtenol (5.31%), limonene (0.62%), citral (5.72%), -phellandrene (0.2%), and -myrcene (0.3%). The total amount of essential oil obtained was 22% v/w which is higher than any other species of the genus Pestacia.     

Recovery of pyridine from aqueous solution by membrane pervaporation

Three different membranes, based on poly(dimethylsiloxane) (PDMS), cation-exchange material and poly(vinyl alcohol) (PVA) respectively, were tudied for the separation of pyridine-water mixtures by pervaporation. The PDMS membrane was preferentially permeable to pyridine and the other two were selective towards water. Three membranes showed different permeation performance, allowing the application of the technique to the separation of feeds of different composition. The temperature profile of the permeability suggests that it is possible to carry out the operation at an elevated temperature in order to achieve high productivity. A combination of the three types of membranes was designed for the production of anhydrous pyridine from dilute pyridine aqueous solution by pervaporation.     

Carbonyl and hydridocarbonyl complexes of ruthenium (II) and osmium (II) with tertiary arsines

Ruthenium halides (Cl and Br) react with monotertiary arsines-Ph₂RAs (R=Me, Et, Pr ⁿ ) in methoxyethanol, in the presence of aq. formaldehyde to give monocarbonyl complexes of ruthenium(II) of the type RuX₂(CO) (Ph₂RAs)₃. Carbonylation of an ethanolic solution containing ruthenium trichloride and the arsine at room temperature yieldtrans dicarbonyl compounds of the formula RuCl₂(CO)₂ (Ph₂RAs)₂. The osmium monocarbonyls OsX₂(CO) (Ph₂RAs)₃ (X=Cl, Br; R=Me, Et) react with NaBH₄ in methanol to yield complexes of the composition OsHX(CO) (Ph₂RAs)₃. The ruthenium analogues RuHCl(CO) (Ph₂RAs)₃ have also been made. Structures have been assigned to all these compounds on the basis of IR and NMR spectral results.     

Determining the wax content of crude oils by using differential scanning calorimetry

By the use of differential scanning calorimetry (DSC), a new method to measure the wax content of crude oil has been developed. In this paper, the wax content of a crude oil is proposed and proved to be the Q (total thermal effect of wax precipitation in sample) ratio of the crude oil and its corresponding wax obtained by using standard acetone method, i.e. Q_oil/Q_wax. For the 14 studied crude oils with the wax content ranging from 1 to 27 wt.%, the wax contents determined by the presented method are in good agreement with those determined by standard acetone method, with an absolute average deviation of only 0.82 wt.%. This method has an advantage over reported DSC methods in which the exact dissolution or precipitation enthalpy of wax is a must. It is also found that the wax contents determined by either of the two methods show good linear relationship with the total thermal effect Q_oil, with the correlation coefficients over 0.96. According to the empirical correlations, the wax content of a crude oil can be easily determined by using the DSC total thermal effect Q_oil. In addition and more significantly, the new method can be applied to improve the accuracy in determining the amount of precipitated wax in a waxy crude oil at different temperatures.     

Ultra-fast essential oil characterization by capillary GC on a 50 microm ID column

A 5 m x 50 microm capillary column with 0.05 microm stationary phase film thickness, with a calculated efficiency of almost 20,000 plates per metre (under optimum conditions), was used for very fasthigh resolution GC analysis of lime essential oil. The total analysis time of this volatile essential oil was less than 90 s. Fast GC is shown to be appropriate for essential oil quality assurance analysis, and quantitative results of key components are comparable with those obtained by using conventional GC analysis. The fast GC analysis is approximately 33 times faster than the conventional GC method.