ON THE OPTIIMAL REACTIONS ASSEMBLAGE OF COMPLEX REACTION SYSTEMS

In this paper, the author analyzes distinguishing features of complex reaction systems and single reversible reaction, and optimizes complex reaction systems starting from set theory.The method of constructing the optimal reactions assemblage and calculating the potential maximum equilibrium yield (PMEY) of objective products is proposed here. This paper points out clearly that the euqilibrium yield of objective products calculated by means of conventional method is the global equilibrium yield (GEY).It is not the thermodynamic constraint, and could be exceeded by observed yield of objective products; only PMEY is the thermodynamic constraint. It gives information on potential and possible optimal yield and thereby improving production. This paper also points out the way in which the real complex reaction system approached the optimal reactions assemblage. The new concept of PMEY and optimal reaction assemblage proposed by this Paper is universally applicable for the important complex reaction systems, such as the pyrolysis of alkane to produce ethylene, steam reforming of methane to produce syngas, production of formaldehyde from methanol, epoxidation of ethylene to produce ethylene oxide, hydrogenation of benzene to produce cyclohexane.     

新型含氧亚甲基和亚胺桥键液晶化合物分子结构与光谱的密度泛函理论研究

采用密度泛函理论方法在B3LYP/6-31G*水平上对6个新型含氧亚甲基和亚胺桥键液晶化合物分子的几何结构进行优化计算,讨论了取代基H,CH3,CH3O,C2H5O,NO2,Cl对分子电荷、前线轨道能量和电子吸收光谱等性质的影响.在此基础上使用含时密度泛函理论方法计算了分子第一激发态的电子垂直跃迁能,得到最大吸收波长λmax.计算表明,取代基的引入导致最大吸收波长红移.     

煮糖汁汽加热器故障分析及防止措施

本文对糖厂用煮糖汁汽加热器的不锈钢换热管与管板连接焊缝产生的裂纹和换热管横向断裂问题,进行全面的理论分析,並结合具体情况,提出一些可行的防止焊缝裂纹和管子横向断裂的主要措施。     

Contractibility of Efficient Frontier of Simply Shaded Sets

In finite dimensional Euclidean space, we prove the contractibility of the efficient frontier of simply shaded sets. This work extends the result of Peleg [7], which confirms the contractibility of the efficient frontier in the convex case.     

应用确定性前沿模型测定我国生物科技企业技术效率

利用前沿模型和技术效率理论测定了我国生物科技企业的技术效率，结果表明，我国生物科技企业资本投入对产出的贡献率远大于劳动力投入，生物科技企业的技术效率普遍较低且企业间差异极大，我国东、中、西部生物科技企业平均技术效率无显著差异．     

稀土添加剂对烃类水蒸汽重整镍催化剂性能的影响——水蒸汽吸附的TPD研究

用程序升温脱附技术,研究了添加稀土的烃类水蒸汽重整催化剂(Ni/α-Al_2O_3)对水蒸汽的吸附性能,同未加稀土的镍催化剂作了对比。结果表明,加有稀土的镍催化剂对水蒸汽的吸附能力主要是稀土的贡献。还原态催化剂对水蒸汽的吸附量比相应的氧化态多1.4倍。发现催化剂对水蒸汽的吸附能力不仅取决于浸渍方式,而且同稀土含量有关。当稀土含量较多时,催化剂表面上呈现出三个能量不同的吸附位。稀土含量少于1.3%时。对提高催化剂吸附水蒸汽的能力已作用不大。含稀土的镍催化剂吸附水蒸汽的能力大,正是其抗结炭性能耐硫性能好的原因。     

Vapor pressure,speciation, and chemical activities in highly concentrated sodium borate solutions at 277 and 317°C

The system H₂O-B₂O₃-Na₂O has been studied experimentally at 277 and 317°C. The activities of water and boric acid have been determined at mole ratios Na/B from 0 to 1.5, and total dissolved solids 3 to 80 weight percent. The activity of boric acid has been fitted to within experimental error using a speciation model with eight complex species. This model is consistent with the model previously published by Mesmer et al. The electrolyte properties of the liquid are modeled using the Pitzer-Simonson model of very concentrated electrolyte solutions. The calculated values of water activity agree with experiment, and the activity of NaOH and pOH have also been calculated. The potassium borate system also was briefly studied at 317°C, and is adequately described by a model with five complex species. The potassium borate liquid is more alkaline at K/B= 1 than a sodium borate liquid at the same mole ratio, but pOH in the two systems is the same at lower mole ratios.     

CuZnAl水滑石衍生催化剂上甲醇水蒸气重整制氢Ⅲ.合成水滑石用金属盐的影响

采用共沉淀法,用不同金属盐为Cu源和Zn源合成了一系列CuZnAl水滑石,以此为前体经600℃焙烧后制得相应催化剂.用硝酸盐和醋酸盐合成的水滑石结晶度高,其衍生催化剂比表面积大、Cu的分散性好且易于还原;而用硫酸盐和盐酸盐合成的水滑石结晶度差,其衍生催化剂比表面积小、Cu的分散性差且不易还原.反应评价结果显示,用硝酸盐和醋酸盐制得的催化剂活性高、反应稳定性好;而用硫酸盐和盐酸盐制得的催化剂由于低的Cu表面积以及S和Cl的毒化作用而几乎无催化活性.在醋酸盐制备的催化剂上,产物干气中CO的浓度明显较低,在250℃和WHSV=3.28 h-1的条件下约为0.03%~0.04%,仅为硝酸盐所制催化剂上CO浓度的1/5;在210℃和WHSV=0.5 h-1的条件下,该催化剂上甲醇几乎完全转化,同时CO浓度降至约0.005%.N2O滴定、CO2程序升温脱附和程序升温还原结果显示,用醋酸盐和硝酸盐制备的催化剂具有极相近的Cu表面积和表面碱性,但前者CuO的还原峰温较后者低近70℃,归因于ZnO与CuO间的强相互作用,这是催化剂具有良好选择性的可能原因.     

Effect of the composition of nickel-containing composites based on stabilised zirconia on catalytic activity in methane steam conversion

A study was carried out on the composition and nature of the stabilizing additive on the activity of nickel-containing composites based on zirconia in the methane steam conversion. The methane conversions were 91–99% on Ni/ZrO₂(Y, Sc, Ce) at 700–800 °C.     

Properties and Characterization of Modified HZSM—5 Zeolites

Physicochemical and catalytic properties of phosphorus and boron modified HZSM-5 zeolites treated with 100% steam at 673K were investigated.The acidity and distribution of acidic sites were studied by infrared spectroscopy using pyridine as probe molecule and temperature programmed desortion (TPD) of ammonia.The structure of the samples was characterized by XRD,and the textural properties of the catalysts were determined by nitrogen isothermal adsorption-desorption measurements and scanning electron microscopy(SEM).The XRD results show that the modified samples have no novel crystalline phase,indicating a high dispersion of phosphorus and boron species.After treatment,the microporous volume and surface area of the samples markedly decrease,implying the bolockage of the channel.The nitrogen adsorption-desorption measurements suggest that the isothermal type of all samples is a combination of isothermal type Ⅰ and Ⅳ，and all hysteresis loops resemble the H4-type in the IUPAC classification.The total acidity of the modified samples,determined by pyrldine adsorption IR and TPD of ammonia,decreases in contrast to that of the parent HZSM-5.The conversion of n-heptane over P and B steammodified HZSM-5 is higher than that of P and B-modified HZSM-5 zeolites but lower than that of the parent HZSM-5.