雾室温度对ICP-MS分析性能影响的研究

研究了在电感耦合等离子体质谱分析中雾室温度对仪器分析性能的影响情况。在实验中选取半导体对雾室进行制冷,结果表明随着半导体制冷温度升高,进入等离子体水蒸气和分析元素气溶胶的量增加,但水蒸气引入量的增加幅度明显大于气溶胶,温度每增加1℃,等离子体中水的负载量增加2 3%,而气溶胶则只增加0.35%。同时随着半导体制冷温度的升高,分析元素的灵敏度下降,氧化物干扰增强,但氧化物的计数并未增加。根据元素灵敏度和氧化物干扰随半导体制冷温度变化的差异性,对人工模拟高纯Sm2O3中杂质稀土元素Dy、Ho、Er、Yb的量进行了计算,通过与模拟加入量比较,证明使用这种方法可对高纯稀土中某些受基体元素氧化物离子严重干扰的稀土元素进行快速定量分析,分析结果的偏差小于20%。     

中甘11号结球甘蓝高产喷肥模式化初探

依据系统工程理论的原理和方法，研究了Ｓｒ、Ｂ、Ｚｎ、Ｍｏ、Ｃｕ五种微显元素对中甘１１号结球甘蓝产量、品质的影响及各因子间的复合效应。试验结果表明，各因子对中甘１１号产量的作用是：Ｓｒ＞Ｂ＞Ｚｎ＞Ｃｕ＞Ｍｏ。获得了中甘１１号亩产在６０００ｋｇ以上的优化组合方案是：Ｓｒ０．０５４％～０．０６１％，Ｂ０．０３５％～０．０４２％，Ｚｎ０．０４７％～０．０５７％，Ｍｏ０．０３２％～０．０３８％，Ｃｕ０．０５０％～０．０５６％，为微量元素在蔬菜上的应用提供了科学依据．     

Direct monitoring of drug degradation by easy ambient sonic-spray ionization mass spectrometry: the case of enalapril

Using enalapril maleate as a test case, the ability of ambient mass spectrometry, namely, via easy ambient sonic‐spray ionization mass spectrometry (EASI‐MS), to perform direct monitoring of drug degradation has been tested. Two manufacturing processes were investigated (direct compression and wet granulation), and the formation of degradation products was measured via both EASI‐MS and high‐performance liquid chromatography with ultraviolet detection for a total period of 18 months. Both techniques provide comparable results, which indicate that direct analysis by ambient mass spectrometric techniques presents a viable alternative for drug degradation monitoring with superior simplicity, throughput, and reliability (no sample manipulation), and comparable quantitative results. In terms of qualitative monitoring, the full mass spectra with intact species provided by EASI‐MS allow for comprehensive monitoring of known and unknown (or unexpected) degradation products. Copyright © 2011 John Wiley & Sons, Ltd.     

Alleviation of ion suppression effect in sonic spray ionization with induced alternating current voltage

In this study, alleviation of ion suppression effect in sonic spray ionization mass spectrometry (SSI‐MS) was investigated. Ion suppression effect was firstly compared between electrospray ionization (ESI) and conventional SSI, and more severe ion suppression effect was observed with SSI. Ion suppression effect of SSI was also found difficult to be alleviated by simply optimizing major parameters. Alternatively, we found that with the assistance of an alternating current (AC) voltage with low amplitude, the ion suppression effect was greatly alleviated (comparable with conventional ESI). That AC voltage was applied outside the SSI spray tip, and no direct contact between the electrode and spray solution was necessary. Besides the alleviation of the ion suppression effect, this newly‐developed method, termed as induced electrosonic spray ionization (IESSI), appeared to preserve similar charge state distribution with SSI for protonated cytochrome c, hemoglobin, and bradykinin. IESSI could also obtain significantly improved ion intensities (~1000‐fold over conventional SSI). In addition, tolerance of concentrated salts for IESSI‐MS was investigated through the analysis of cytochrome c in the presence of concentrated sodium chloride (NaCl) or ammonium acetate (NH₄OAc). Copyright © 2014 John Wiley & Sons, Ltd.     

Desorption/ionization efficiencies of triacylglycerols and phospholipids via EASI‐MS

Knowledge of the major effects governing desorption/ionization efficiency is required for the development and application of ambient mass spectrometry. Although all triacylglycerols (TAG) have the same favorable protonation and cationization sites, their desorption/ionization efficiencies can vary dramatically during easy ambient sonic‐spray ionization because of structural differences in the carbon chain. To quantify this somewhat surprising and drastic effect, we have performed a systematic investigation of desorption/ionization efficiencies as a function of unsaturation and length for TAG as well as for diacylglycerols, monoacylglycerols and several phospholipids (PL). Affinities for Na⁺ as a function of unsaturation level have also been assayed via comprehensive metadynamics calculations to understand the influence of this phenomenon on the ionization efficiency. The results suggest that dipole–dipole interactions within a carbon chain tuned by unsaturation sites govern ionization efficiency of TAG and PL. Copyright © 2014 John Wiley & Sons, Ltd.     

Further revisions on the diterpenoid alkaloids reported in a JNP paper (2012, 75, 1145–1159)

We have corrected (Tetrahedron2013, 69, 5859–5866) the structures of diterpenoid alkaloids reported in the Journal of Natural Products2012, 75, 1145–1159. Our follow-up experiments compel us to present further revisions and clarifications on the diterpenoid alkaloids:     

Preparation of Yolk‐Shell and Filled Co9S8 Microspheres and Comparison of their Electrochemical Properties

In this study, we report the first preparation of phase‐pure Co₉S₈ yolk–shell microspheres in a facile two‐step process and their improved electrochemical properties. Yolk–shell Co₃O₄ precursor microspheres are initially obtained by spray pyrolysis and are subsequently transformed into Co₉S₈ yolk–shell microspheres by simple sulfidation in the presence of thiourea as a sulfur source at 350 °C under a reducing atmosphere. For comparison, filled Co₉S₈ microspheres were also prepared using the same procedure but in the absence of sucrose during the spray pyrolysis. The prepared yolk–shell Co₉S₈ microspheres exhibited a Brunauer–Emmett–Teller (BET) specific surface area of 18 m² g^?1 with a mean pore size of 16 nm. The yolk–shell Co₉S₈ microspheres have initial discharge and charge capacities of 1008 and 767 mA h g^?1 at a current density of 1000 mA g^?1, respectively, while the filled Co₉S₈ microspheres have initial discharge and charge capacities of 838 and 638 mA h g^?1, respectively. After 100 cycles, the discharge capacities of the yolk–shell and filled microspheres are 634 and 434 mA h g^?1, respectively, and the corresponding capacity retentions after the first cycle are 82 % and 66 %.     

Electrochemical Properties of Hollow‐Structured MnS–Carbon Nanocomposite Powders Prepared by a One‐Pot Spray Pyrolysis Process

Spherical, hollow MnS? C composite powders were prepared from a solution of manganese salt, thiourea, and sucrose by one‐pot spray pyrolysis. The MnS? C composite powders were generated by direct sulfidation of MnO with hydrogen sulfide gas generated in situ by decomposition of thiourea during spray pyrolysis. Sucrose, which is used as a carbon source material, plays a key role in the formation of the MnS? C composite powders by improving the reducing atmosphere around the powders. Dot‐mapping images of the composite powders demonstrated uniform distribution of the manganese, sulfur, and carbon components within the MnS? C composite powder. Fine crystals of MnS were uniformly mixed with carbon derived from polymerization and carbonization of sucrose. The carbon content of the MnS? C composite powders was 26 wt %. The discharge capacities of the MnS? C composite powders in the 2nd and 200th cycles were 863 and 967 mA h g^?1, respectively, at a current density of 1000 mA g^?1. The spherical and hollow morphology of the MnS? C composite powders was completely retained, even after 200 cycles. The enhanced cycling and rate performance of the MnS? C composite powders is ascribed to the structural stability of the composite powders.     

Using Simple Spray Pyrolysis to Prepare Yolk–Shell‐Structured ZnO–Mn3O4 Systems with the Optimum Composition for Superior Electrochemical Properties

A spray‐pyrolysis process is introduced as an effective tool for the preparation of yolk–shell‐structured materials with electrochemical properties suitable for anode materials in Li‐ion batteries (LIBs). Yolk–shell‐structured ZnO–Mn₃O₄ systems with various molar ratios of the Zn and Mn components are prepared. The yolk–shell‐structured ZnO–Mn₃O₄ powders with a molar ratio of 1:1 of the Zn and Mn components are shown to have high capacities and good cycling performances.     

Flame Spray Pyrolysis for Finding Multicomponent Nanomaterials with Superior Electrochemical Properties in the CoOx‐FeOx System for Use in Lithium‐Ion Batteries

High‐temperature flame spray pyrolysis is employed for finding highly efficient nanomaterials for use in lithium‐ion batteries. CoO_x‐FeO_x nanopowders with various compositions are prepared by one‐pot high‐temperature flame spray pyrolysis. The Co and Fe components are uniformly distributed over the CoO_x‐FeO_x composite powders, irrespective of the Co/Fe mole ratio. The Co‐rich CoO_x‐FeO_x composite powders with Co/Fe mole ratios of 3:1 and 2:1 have mixed crystal structures with CoFe₂O₄ and Co₃O₄ phases. However, Co‐substituted magnetite composite powders prepared from spray solutions with Co and Fe components in mole ratios of 1:3, 1:2, and 1:1 have a single phase. Multicomponent CoO_x‐FeO_x powders with a Co/Fe mole ratio of 2:1 and a mixed crystal structure with Co₃O₄ and CoFe₂O₄ phases show high initial capacities and good cycling performance. The stable reversible discharge capacities of the composite powders with a Co/Fe mole ratio of 2:1 decrease from 1165 to 820 mA h g^?1 as the current density is increased from 500 to 5000 mA g^?1; however, the discharge capacity again increases to 1310 mA h g^?1 as the current density is restored to 500 mA g^?1.