环形线电荷的电场分布

给出了圆环形线电荷电场分布的理论公式，并利用计算机计算出其具体分布规律。     

螺纹联接动载荷强度计算公式的探讨

该文以柴油机的连杆螺栓联接(非标准件)为例,在微机上用动力有限元方法对螺栓各圈螺牙的载荷分布,螺栓的静、动应力分布进行了计算与研究。提出了较材料力学经验公式精确的既简单又实用的螺纹联接的动载荷强度计算公式。     

碱改性γ－Al_2O_3催化剂表面碱强度分布与COS水解活性的研究

用非水滴定法和Ｈａｍｍｅｔｔ系列指示剂测定了ＣＯＳ水解碱改性γ－Ａｌ_２Ｏ_３催化剂的表面碱强度分布．发现表面碱强度分布不均匀与表面能量分布不均匀相呼应．采用零点酸碱强度（Ｈ_（０，ｍａｘ））及碱中心区域分析法，Ｂｒｏｎｓｔｅｄ催化定律，进一步证实ＣＯＳ水解反应具有明显碱催化特征，较高活性催化剂的Ｈ_（０，ｍａｘ）一般为１０左右，对ＣＯＳ水解反应起主要作用的碱性中心的碱强度（Ｈ_０）为４．８≤Ｈ_０≤９．８．对碱金属氧化物改性后的γ－Ａｌ_２Ｏ_３催化剂，Ｂｒｏｎｓｔｅｄ规律在每个碱强度分区域内是适用的．     

羟丙基甲基纤维素作为水泥添加剂研究(四)

以萘磺酸甲醛缩合物为分散剂，水溶性羟丙基甲基纤维素衍生物为粘稠剂，研究了它们的混合物对混凝土材料的分散性与粘稠性及其它性能的影响，并探索了其作用机理。     

JD树脂刻蚀及涂层的XPS研究

ＪＤ光学树脂表面刻蚀过程的ＸＰＳ研究表明，引进树脂遥ＣＯＨ，Ｃ＝Ｏ，Ｃ－ＳＯ３Ｈ，ＣＯＯＨ等基因随刻蚀温度的提高或时间的延长而增加，对其相对含量进行了计算，固化后的耐磨涂层具有ＳｉＯ２结构，ＪＤ板材的最佳刻蚀条件为２０℃，２０ｍｉｎ。     

Potentiometric measurements of the first hydrolysis quotient of magnesium(II) to 250°C and 5 molal ionic strength (NaCl)

The first molal hydrolysis quotient, Q_1.1, of Mg²⁺ was measured potentiometrically from 1 to 250°C at ionic strengths of 0.11, 0.31, 1.01, and 5.0 mol-kg^-1 in an aqueous NaCl medium using a hydrogen-electrode, concentration cell. Only hydrolysis of the first four percent of the magnesium in solution could be followed before precipitation of brucite, Mg(OH)₂(cr), occurred. The log Q_1.1 values were fitted as a function of temperature and ionic strength using four adjustable parameters. The resulting constants are compared with the limited existing low temperature data. At infinite dilution and 25°C the following quantities are reported: logK _1.1 = -11.68±0.05, †H_so = 70.1±1.2 kJ-mol^-1, †S^o = 11±4 J-K^-1-mol^-1, and †C _p ^o = 0 J-K^-1-mor^-1. At each ionic strength, including the values extrapolated to infinite dilution, the heat capacity change for the hydrolysis reaction was zero,i.e., logQ _1.1 was found to be a linear function of the reciprocal temperature in Kelvin, at least over the measured range of l-250°C. The hydrolysis constants at infinite dilution were modeled to 550°C and two kbar pressure with a function incorporating solvent density using published results obtained at these extreme conditions.     

Effect of ionic strength on the formal potential of the glass electrode in various saline media

We examined the variation with ionic strength (I, adjusted with KCl, KNO₃, KBr, NaCl or NaClO₄) of the formal potential (E_const) for glass electrodes exhibiting a Nernstian response (i.e. E_cell=E_const−s log [H⁺]). For this purpose, we investigated the different factors included in the formal potential, so we obtained reported values for the liquid junction potential as a function of ionic strength and determined the logarithm of the activity coefficient for the proton in various saline media, using Pitzer equations.     

Crosslinked polystyrene with improved mechanical properties

The synthesis of some divinyl monomers—bis(vinylphenyl)ethane ( 2 ), bis(vinylbenzyloxy)hexane ( 3a ), and bis(vinylbenzyloxy)dodecane ( 3b ) is reported. Copolymers of the new monomers and styrene were evaluated as an alternative to divinylbenzene-crosslinked polymers for use as matrices and absorbents. The mechanical properties and the amount of residual double bonds in the copolymers were compared. It was found that the new copolymers, unlike the divinylbenzene-crosslinked polymers, retained their mechanical strength even at high crosslinking degrees. Stress at break values of 79, 68, and 18 N/mm² were found for the polymers crosslinked with 20 mol % of 3a, 2 , and divinylbenzene; 5, 25 and 45% of the divinyl units in these polymers were left as pendant double bonds. Porous styrene– 2 copolymers were synthesized and shown to have lower surface areas than the corresponding divinylbenzene-crosslinked polymers. The pore size distribution showed that this was due to the absence of the smallest pores which are found in the divinylbenzene-crosslinked polymers in between heavily crosslinked nodules. © 1993 John Wiley & Sons, Inc.     

The ion product of H2O,dissociation constants of H2CO3 and pitzer parameters in the system Na+/H+/OH−/HCO 3 − /CO 3 2- /ClO 4 − /H2O at 25°C

The ion product of water and the dissociation constants of carbonic acid have been determined in 0.1, 1.0, 3.0, and 5.0M NaClO₄ at 25°C. The ion product of water K _w ^' has been evaluated by emf measurements with a combined glass electrode in NaClO₄ solutions containing 0.001–0.1M HCLO₄ or NaOH. The product K _H ^' K _l ^' K ₂ ^' of the Henry constant for CO₂ and the dissociation constants for H₂CO₃ have been determined by titration of carbonate solutions equilibrated with pCO₂ =10^–3.52 atm, and K ₂ ^' has been evaluated by potentiometric titration and by measuring the H⁺ concentration at fixed HCO ₃ ^– and CO ₃ ^2- concentrations. The ion interaction (Pitzer) equations are applied to describe the constants K _w ^' , K ₂ ^' and K _H ^' H ₁ ^' K ₂ ^' as a function of the NaClO₄ concentration. The experimental data are used to evaluate the mixing parameters _{i/ClO 4} and _{i/ClO 4} ^-/Na⁺ fori = OH ^-,HCO ₃ ^- andCO ₃ ^2-