Precipitation phenomena in FeCl3-NaH2PO2 aqueous solutions at 245°C

Precipitation phenomena in aqueous solutions containing FeCl₃ and NaH₂PO₂ in varying concentrations have been studied at 245 °C. The composition and the morphology of the resulting particles depended strongly on the concentration ratios of the reacting ions. In the presence of small amounts of NaH₂PO₂ only hematite formed of different particle shapes. An increased addition of hypophosphite ions had two effects: first, anions of phosphorus were incorporated in the solids and, second, ferric ions were reduced to ferrous ions giving a variety of products.Supported by the Electric Power Research Institute, Contract RP-966-2.On leave from Yokohama City University, Japan.     

Dynamic measurements of adsorption of hydrolyzed polyacrylamide (HPAM) onto hematite

The adsorption measurements of hydrolyzed polyacrylamide (HPAM) onto hematite suspension are carried out to study the dynamics of the polymer adsorption onto the suspension particles and to investigate the mode of the polymer adsorption. The polymer is found to show much affinity for the adsorption because of the opposite charges possessed by the polymeric flocculant and the suspension particles. Various adsorption parameters such as adsorption coefficient, the rate constants for the adsorption and desorption, are evaluated with the help of a recently proposed kinetic scheme. It is found that the extent of adsorption and the adsorption rate are adequately affected by increasing the pH of the suspension while, unexpectedly, the adsorption is found to show only a marginal increase on addition of Na₂SO₄. Both the amount of the adsorbed polymer and the adsorption rate are also found to increase with the degree of hydrolysis of the polyelectrolyte.     

Aluminium-doped catalysts for the high temperature shift reaction

The replacement of chromium by aluminium in high temperature shift catalysts was investigated. It was found that aluminium-doped hematite is a convenient candidate as an environmental friendly catalyst.     

化学链燃烧中赤铁矿氧载体的本征反应动力学研究

本文对一种化学链燃烧所用赤铁矿氧载体进行了本征还原反应动力学研究。氧载体颗粒的比表面积及孔径分布测试显示此种氧载体的孔隙率为0.031,表明此种氧载体结构致密,孔隙结构不发达。热重反应器上进行的程序升温还原实验结果显示氧载体的还原反应分阶段进行,并确定第一还原阶段的温度测试窗口为400~650°C。在排除了氧载体颗粒内外扩散的影响后,批次流化床实验分析确定反应的本征活化能为138.55 k J/mol,指前因子为6.8×1013s-1。通过对内外扩散因素的分析,加深了对此种氧载体颗粒与CO的宏观反应特性的认识。本研究结论与前人关于缩核模型、外扩散控制以及较小的表观活化能的研究结论具有良好的相容性。     

高磷赤铁矿采用 CaCl2气化脱磷的试验研究

对高磷赤铁矿在烧结过程中添加CaCl2气化脱磷进行热力学分析,并通过微型烧结试验对影响气化脱磷率的因素进行研究。结果表明,在烧结过程中添加CaCl2可以使高磷赤铁矿中的 P元素以 PCl3气体形式随烧结废气排出;气化脱磷率受配碳量、加热温度、C aC l2加入量、矿石碱度等因素影响;当配碳量为4％、加热温度为900℃、CaCl2加入量为1．36％、通过添加白灰使矿石碱度增加到1．2时,脱磷率可以达到18．3％。     

纺锤形铁黄α－FeOOH微晶合成动力学研究

本文对纺锤形α－ＦｅＯＯＨ微晶合成动力学过程进行了研究．利用复相反应经验动力学方程，考察了初始浓度、反应温度和空气流量对Ｆｅ（ＯＨ）２－ＰｅＣＯ３悬浮液氧化速率的影响，确定了α－ＦｅＯＯＨ成核－生长速率方程，证实了晶粒生长阶段存在溶解－氧化的动态平衡，根据活化能大小，推断相界面氧化反应为该复相反应的控制步骤，还对α－ＦｅＯＯＨ成核生长微观机理作了初步探讨．     

赤铁矿磁铁矿石英和绿泥石的可浮性研究

矿物的电动电位测定和可浮性实验结果表明:十二胺主要以静电力作用吸附在赤铁矿、磁铁矿、石英和绿泥石表面上,但与赤铁矿和绿泥石之间可能存在化学力作用;十二胺对上述矿物的扑收能力的强弱与介质pH值有关,在pH值9—11之间的扑收能力最强;在碱性介质中时矿物可浮性由强至弱的排列顺序为:石英>赤铁矿>磁铁矿>绿泥石;在中性和弱酸性介质中石英的可浮性最好,磁铁矿的可浮性最差;赤铁矿和绿泥石的可浮性居中;通过调整介质pH值和十二胺浓度可能实现石英和磁铁矿的分离。     

纺缍形α-Fe2O3/聚苯乙烯复合高分子微球的制备、表征及等电性研究

以纺缍形α-Fe2O3超微粉为内核，过硫酸钾为引发剂，聚乙二醇为分散剂和稳定剂，乙醇／水为分散介质，苯乙烯为单体，用改进的分散聚合法合成了核／壳型纺锤形的高分子微球，并用XRD、TEM和IR进行了表征。粒子的分散性较好，粒径分布窄。由于亲水性的α-Fe2O3与亲油性的苯乙烯亲合性较差，在实验中采用了超声分散、预先溶胀和预先吸附引发剂、分散剂的方法，增强了粉末表面的亲油性，合成的高分子微球，其长轴平均为0．26μm，短轴平均为0．09μm，轴比为2．9，同时测定了不同pH值时粒子包膜前后的Zeta电位值，并根据粒子等电点的变化计算出包膜厚度，与电镜照片的结果比较吻合。     

不同晶化度γ-FeOOH的合成及其液相转化研究

进行了空气氧化Fe(OH)2悬浮液, EDTA作用下可见光诱导, 不同温度(14～20 ℃)制备不同晶化度γ-FeOOH的研究, 进行了其沸腾回流液相转化历程的探讨. 结果表明: 随温度的升高, γ-FeOOH的晶化程度变差; 而γ-FeOOH的晶化程度越差, 在液相沸腾回流时就越易转化成α-Fe2O3, 反之则易转化为α-FeOOH. 在pH近中性, 微量Fe(II)存在条件下低晶态的γ-FeOOH可以快速转化为均匀球形的α-Fe2O3.