Temperature Development of Homo- and Hetero-Clustering in Saturated Vapors

Computational findings of temperature increase of clustering degree in saturated vapors are analyzed. A thermodynamic proof is presented and a simple criterion derived. Illustrations are based on saturated steam, magnesium and carbon vapor. The results are applicable to synthesis of fullerenes, metallofullerenes, and heterofullerenes, chemical vapor deposition technique, or atmospheric chemistry.     

ORGANIC CHELATING REAGENT ON REDOX ADSORPTION OF ACTIVATED CARBON FIBER TOWARDS Au^3+

Organic chelating reagent influences upon the redox adsorption of activated carbon fibertowards Au3- were systematically investigated. The experimental results indicated that the presenceof organic chelating reagent on activated carbon fiber strongly affects adsorption capacity ofactivated carbon fiber towards Au3+. The reduction-adsorption amount of Au3+ increased three timesby the presence of 8-quinolinol. Furthermore, The reduction-adsorption amount of Au3+ depended onthe pH value of adsorption and temperature.     

杂多酸的固载化─关于制备负载型酸催化剂的一般原理

杂多酸同时具有酸和氧化－还原的催化特性，有着很广泛的应用前景．这类化合物在一系列精细合成中取代硫酸作为催化剂以满足环保的要求，显示出了很大的潜力．杂多酸固载化后，不仅能在液相氧化和酸催化反应中把催化剂从反应介质中很方便地分离出来，而且还为这类均相催化反应的多相化，甚至利用催化蒸馏新工艺等创造了应有的条件，可以使生产工艺大大简化，获得更广泛的应用．本文以很好表征过的多种孔性材料，包括氧化物，如Ａｌ_２Ｏ_３、ＳｉＯ_２、ＴｉＯ_２、硅藻土、膨润土和来源不同的活性炭为载体，考察了负载杂多酸催化剂的催化活性．在大量前期工作的基础上，通过总结载体对固载杂多酸催化活性的影响等，探讨载体的内在性质在杂多酸固载、吸附和催化反应中的作用本质，为由吸附法制备各种负载型固体酸催化剂在液相中的应用提供可资参考的模型．     

阴极支撑型固体氧化物燃料电池的制备与测试

采用固相反应法合成A缺位的(La_0.8Sr_0.2)_0.95MnO₃(LSM95)作为阴极材料,Zr_0.9Sc_0.1SO_1.95(SSZ)商业粉体作为电解质材料,溶胶-凝胶法合成的La_0.8Sr_0.2Cr_0.5Mn_0.5O₃-(LSCrM)作为阳极电催化材料,利用流延、共烧结及浸渍法得到结构为LSCrM-CeO₂|SSZ|3YSZ-LSM95的阴极支撑型固体氧化物燃料电池,分别在氢气气氛和甲烷气氛中进行电化学性能测试. 结果表明,浸渍0.11 g·cm ^-2 CeO₂的LSCrM-CeO₂|SSZ|3YSZ-LSM95单电池在以CH₄为燃料时,600、650、700、750和800 ^oC下的功率密度分别为1.68、4.70、12.40、28.08和54.78 mW·cm ^-2,表现出一定的电化学性能和较好的稳定性.     

Carbyne — the third allotropic form of carbon

The history of the discovery of carbyne, the chemical and physical methods used to obtain it, the analysis of its structure, and some of its properties are briefly considered. The prospects for its practical applications are discussedThis publication is based on a number of works on carbyne submitted for the Russian State Prize in the field of science and technology in 1993; performed at the A. N. Nesmeyanov Institute of Organoelement Compounds, Russian Academy of Sciences and the M. V. Lomonosov Moscow State University.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 3, pp. 450–463, March, 1993.     

羧基化碳纳米管嵌入石墨修饰电极对多巴胺和抗坏血酸的电催化

采用涂层和嵌入修饰法 ,将羧基化多层碳纳米管制成两种修饰电极。以多巴胺 (DA)和抗坏血酸(AA)为模型化合物 ,研究了两种修饰电极对DA和AA共存时的电催化作用。结果表明 :嵌入的方式比涂层的方式显示了更多的优点。嵌入修饰电极不仅使峰电流增加 ,并且使两者共存时的氧化峰位分离达 16 0mV ,同时 ,该电极对DA的响应灵敏于AA ,这有利于在大量的AA存在下实现对DA的测定。在 1× 10 - 3 mol/L的AA的存在下 ,还原电流的一阶导数与DA浓度在 5× 10 - 7～ 1× 10 - 4 mol/L范围内呈良好的线性关系 ;检测下限达 1× 10 - 7mol L。     

Deposition and characterization of Langmuir‐Blodgett films of cadmium arachidate/SWCNTs composites

The incorporation of single‐wall carbon nanotubes (SWCNTs) in cadmium arachidate film by means of the Langmuir‐Blodgett (LB) technique was investigated as a function of arachidic acid/SWCNT mass ratio at the air/water interface and in Langmuir‐Blodgett films. The behaviour at the air/water interface shows that SWCNTs act as an independent phase with respect to the cadmium arachidate. Deposition conditions are optimized when the weight ratio between the arachidic acid (AA) and SWCNTs is in the range 0.018:1 to 1:1. The general order of the LB multilayered structure was destroyed by the progressive density increase in SWCNT quantity as evidenced by X‐ray reflectivity (XRR) analysis. Scanning electron microscopy images indicated that when a multilayered structure was formed its layers consisted of SWCNT bundles stacked one over the other. Copyright © 2006 John Wiley & Sons, Ltd.     

负载咖啡因-活性炭新吸附材料对钼(VI)的吸附行为的研究

以生物碱（咖啡因）为衍生化试剂，用浸渍法使其负载于活性炭（ＡＣ）上，制成一种新的金属阴离子吸附材料———负载咖啡因－活性炭（ＣＡＣ）。用ＩＣＰ－ＡＥＳ研究了该吸附材料对金属阴离子［Ｍｏ７Ｏ２４］６－的吸附性能；考察了其化学稳定性；还研究了不同浓度硫酸和氨水对待测物吸附率和解脱率的影响及共存离子的干扰影响。