用于焊缝跟踪的调制式红外光学传感器

叙述了一种以脉冲调制的红外光束为信号光源的焊缝跟踪传感器。通过对接 收信号的滤波及“自适应消噪”处理,可以有效地克服电弧光的干扰;利用光源的脉冲 驱动特性,加大了瞬时信号功率,改善了光学传感器对工件表面的适应性。传感器结构简 单、体积小、灵敏度高、能同时实现对焊缝在水平及高度两个方向的自动跟踪在埋弧 及明弧自动焊中均能准确地跟踪。     

无源传感器引导AESA雷达目标搜索

无源传感器引导有源电扫阵列(AESA)雷达完成目标搜索是机载多传感器协同探测的重要应用形式。综合了引导传感器的测角误差以及目标运动产生的偏差2种因素,建立目标指示成功概率模型。提出了一种满足时效性、指示成功率和误交接概率要求的最优搜索策略。采用分步优化的方法在多种场景下对搜索策略和性能指标进行了计算。仿真结果表明:提出的搜索策略与传统搜索策略相比在满足指示成功率要求的前提下,通过增加较少的搜索波位,较大幅度地降低了误交接概率,保证了引导条件下目标搜索的准确性。     

无线多媒体传感器网络自适应拥塞控制算法

针对无线多媒体传感器网络(WMSN)中多对一通信时产生的网络拥塞问题,提出了一种自适应的WSMN网络拥塞控制算法ACCP。通过结合速率控制和资源调度,并采用分簇的网络结构,根据簇首及簇内的拥塞指标,来分别启动对应的拥塞控制机制:当簇首发生短时间拥塞时,就启动属于资源调度的网络内存储管理机制,来暂时减缓网络内过多数据包;但当簇中的存储节点也无法容纳过量的数据包时,速率控制就启动,让流量减缓下来,并且只调整数据实时性要求较低的数据流的速率,以达到控制流量、减缓甚至消除网络拥塞的目的。仿真结果显示:ACCP在传送速率不同下,可以比InS、HCCP更有效的控制网络拥塞的情况,而在比较缓存容量不同的情况下,虽然ACCP只比HCCP能够稍微改善网络拥塞的情况,但却能够大幅度改善InS的数据包丢失率。     

传感器测温实验装置的研制

本文介绍了一个新型物理实验装置,把传感器引入了实验教学。此项实验物理方法丰富且具有设计性质。     

平面型无参比电极二氧化硫传感器

制备了一种新型无参比电极由ＮＡＳＩＣＯＮ和ＹＳＺ两种固体电解质及Ｎａ２ＳＯ４辅助电极构成的二氧化硫传感器。实验结果表明,该传感器对二氧化硫产生Ｎｅｒｎｓｔ响应。由于这种传感器采用了平面结构,对比电极和工作电极处于同样气氛中,消除了氧的影响和密封问题,同时有利于传感器的微型化和多元复合。     

The Relation between the Sensitivity and HeatingVoltage of ZnSnO 3 Gas Sensor

对ＺｎＳｎＯ３气敏元件特性的测试结果表明,元件灵敏度随加热电压的变化而变化．当加热电压小于某一特定值ＶＨ０时,灵敏度不变;当加热电压大于３倍ＶＨ０时,灵敏度降低,元件失效。通过Ｘ射线衍射和ＳＥＭ二次电子能谱等检测实验,找出了气敏元件灵敏度降低的原因．     

苦味酸荧光光化学传感器在药物分析中的应用

苦味酸水浴液对固定在增塑的聚氯乙烯（ＰＶＣ）膜中的蒽有可逆荧光熄灭作用，据此研制了测定苦味酸的荧光光化学传感器。该传感器的敏感膜的最佳组成为６～８ｍｇ蒽、５０ｍｇＰｖＣ粉、１００ｍｇ邻苯二甲酸二异辛酯。测定苦味酸的浓度范围为３．０４×１０￣（－６）～６．１６×１０￣（－３）ｍｏｌ／Ｌ，重现性良好，响应时间为５～４０秒，该传感器选择性好，许多常见亲脂明离子不干扰测定，可用于药物奎宁及辛可宁的间接测定。     

A Novel Proton Sensor with Luminescence and Color Signaling Based on Platinum(II) Terpyridyl Acetylide Complex

Molecular switches that are controllable, reversible and readable at molecular level are an essential compo-nent of molecular electronics1 and chemical sensors.2-6 Of particular interest are the molecules which show dramatic and reversible changes in color and/or lumi-nescence in visible spectral region upon exposure to specific substrates. A number of chromophore- spacer-receptor systems that can selectively recognize specific guest molecules at their receptor site and pro-duce measurable col…     

Organopolysiloxanes as Chemically Sensitive Coatings for Optical Fibers

Various types of UV-curable organically modified siloxanes have been synthesized by the sol-gel method with the aim of fabricating chemically sensitive coatings for silica optical fibers. The refractive index of the coating material can be tailored in the range from 1.46 to 1.56 and sensitivity towards CO2 is achieved by incorporation of amino groups. The interaction of the cured layers with CO2 or with hydrocarbons has been studied in immersion experiments. Both the reaction of CO2 with incorporated amino groups and the penetration of hydrocarbons into the layer induce changes of the light absorption coefficient and the refractive index of the coating which are detected by measuring the output light intensity from the fiber.     

In situ prepared polypyrrole for low humidity QCM sensor and related theoretical calculation

In situ preparation of polypyrrole (Ppy) by photo-polymerization coated on a quartz crystal microbalance (QCM) as a low humidity sensor was reported. Different concentrations of Ppy films say 0 wt.% (as blank), 0.1, 1, and 10 wt.% were investigated to measure humidity concentrations between 14.7 and 5412.5 ppm_v. The adsorption/desorption behavior was also examined at humidity concentration 510.2 ppm_v. The sensitivities of 0, 0.1 and 1 wt.% Ppy films at 51.5 ppm_v were 0.143, 0.219 and 0.427, respectively. For 1 wt.% Ppy, the highest sensitivity was obtained. The slope and correlation coefficients (R²) for 1 wt.% Ppy at the ranges of 14.7–898.6 ppm_v were 0.0646 and 0.9909, respectively. A series of molecular simulations have been carried out to calculate bond energy for the water molecule interaction with Ppy, which was found to be 3 kcal/mol indicating the existence of hydrogen bonding during the sorption process. Based on Langmuir isotherm adsorption assumption, for 0.1 and 1 wt.% Ppy films, the association constants were 2606.30 and 5792.98, respectively. This larger association constant for 1 wt.% Ppy film explains higher sensitivity.