三氯化钛存在下碘酸钾滴定法测定锡

提出了采用铝加铁混合还原剂还原,三氯化钛存在下碘酸钾滴定法测定锡的绝对测量方法,研究了三氯化钛抑制氧的作用效果及作用机理。应用于巴氏合金中锡含量的测定,方法简便、快速,结果准确可靠。     

Properties of ITO films prepared by reactive magnetron sputtering

Indium tin oxide (ITO) thin films were deposited by mid frequency pulsed dual magnetron sputtering using a metallic alloy target with 10 wt.% tin in an atmosphere of argon and oxygen. The aim of the work was to study the interdependence of structural, electrical and optical properties of ITO films deposited in the reactive and transition target mode, respectively. The deposition rate in the transition mode exceeds the deposition rate in the reactive mode by a factor of six, a maximum value of 100 nm·m min⁻¹ could be achieved. This corresponds to a static deposition rate of 200 nm min⁻¹. The lowest electrical resistivity of 1.1·10⁻³ Ω cm was measured at samples deposited in the high oxygen flow range in the transition mode. The samples show a good transparency in the visible range corresponding to extinction coefficients being below 10⁻². X-ray diffraction was used to characterise crystalline structure as well as film stress. ITO films prepared in the transition mode show a slightly preferred orientation in (211) direction, whereas films deposited in the reactive mode are strongly (222) oriented. Compared to undoped In₂O₃ all samples have an enlarged lattice. The lattice strain perpendicular to the surface is about 0.8% and 2.0% for films grown in the transition and the reactive mode, respectively. Deposition in the transition mode introduces a biaxial film stress in the range of −300 MPa, while stress in reactive mode samples is −1500 MPa.     

Magnetic phase transitions in nanostructures induced by shear stress under high pressure

Magnetic phase transitions of the first and second order were revealed by Mössbauer spectroscopy in nanosystems of - and -ferric oxides and metallic europium subjected to shear stress (240°) under high pressure (20 kbar). For - and -ferric oxide nanoclusters, the Curie (Neel) points decreased to 300 K, whereas for nanostructured europium the Neel point increased from 90 to 100 K. The thermodynamic model of magnetic phase transitions predicting a change in the character of magnetic phase transitions and a decrease (increase) in the critical Neel (Curie) points in nanoclusters was developed. The type of magnetic phase transitions and the change in the critical points were caused by defects in nanoclusters, whose maximum concentration was observed for the clusters with the 20—50 nm size range.     

Characterization of the Nanoscale Microstructure of an Immersion Silver on Sputtered Copper

1 INTRODUCTION Silver and its compounds have received much attention due to their current and potential applica- tions in many areas[1, 2]. As a metal with the highest electrical and thermal conductivities, silver was one of the most important noble metals used in electrical industries in the last century. Several decades ago, however, the development of silver application in electronic area seemed not so quick. The fear for some undesirable phenomena involving silver, like “electrochemi…     

Residual stress and deformation during rapid cooling process in an epoxy plate

Residual stress in the epoxy plate during a rapid cooling process was measured by the layer removal method and calculated by the linear thermoviscoelastic theory considering specific volume relaxation. The relaxations of the tensile modulus and specific volume were measured by an Instron thermomechanical analyzer. When the starting temperature of the cooling process was near the glass transition temperature of the cured epoxy, the residual stress in the epoxy plate was smaller than when the starting temperature was higher than the glass transition temperature. However, the transient stress in the cured epoxy plate was higher when the starting temperature was near the glass transition temperature than when the starting temperature was higher than the glass transition temperature. The quenched epoxy plate was compressed in the direction parallel to the surface and expanded in the thickness direction.     

Mechanical properties of SBR-networks: I. Determination of crosslink densities by stress-strain-measurements

The tube model is applied for the treatment of stress-strain measurements on SBR networks. It is shown that this theory allows the separation of crosslink and constraint contributions to the stress-strain behavior and, also, a reliable determination of crosslink densities. The consideration of dynamical contributions is discussed and a special numerical method is developed.     

Adsorption Behavior of a Water-soluble Porphyrin at the Glass-water Interface as Studied by Synchronous Total Internal Reflection Fluorescence Spectroscopy

Total imernal reflection fluorescence spectroscopy (TIRF) and synchronous scanning technique were combined to study the adsorption behavior of the meso-tetrakis (4-sulfonatophenyl)porphyrin (TPPS) at the glass-water interface without any surfactant. The pH dependence of synchronous fluorescence signal at the interface was analyzed. Both unprotonated (TPPS^4-) and diprotonated (H2TPPS^2-) forms of TPPS were observed at the interface. But the interface favored the adsorption of. The apparent estimated pKa2 value shifted from 5.00 in the bulk solution to 2.7 at the interface. STIRF provides a good technique to study multi-component systems at the interface.     

Rheology of polystyrene solutions around the coil overlapping concentration: A phenomenological description of stresses in simple shear flow

Linear viscoelasticity behavior is described with the sum of two terms for polystyrene solutions in tricresyl phosphate around the coil overlapping concentration (K. Osaki, T. Inoue, & T. Uematsu, J Polym Sci Part B: Polym Phys 2001, 39, 211). One is a Rouse–Zimm (RZ) term represented by the Zimm theory with arbitrarily chosen values of the hydrodynamic interaction parameter and the longest relaxation time (τ_RZ). The other (the L term) consists of a relaxation mode with a single relaxation time (τ_L > τ_RZ) and a high‐frequency limiting modulus proportional to the square of the concentration. In this study, we describe the viscosity (η) and first normal stress coefficient (Ψ₁) in steady shear with simple formulas. The stress due to the L term is assumed to be given by a Kaye, Bernstein, Kearsley, and Zapas (K‐BKZ) equation with the damping function h(γ) = (1 + 0.2γ²)^?1/2, where γ is the magnitude of shear. Contributions to η and Ψ₁ from the RZ term are derived from the RZ model, in which the relaxation time in steady flow is given by τ_st = τ + (τ_RZ ? τ)/(1 + 0.35τ_RZ γ˙) instead of τ_RZ. Here, γ˙ is the rate of shear, and τ is the τ_RZ value at the infinite dilution limit. η and Ψ₁ at various concentrations for two polystyrene samples (with molecular weights of 2890 and 8420 kg mol^?1) are well described with parameters derived from dynamic viscoelasticity. © 2002 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 40: 1038–1045, 2002     

Nitrotyrosine-modified proteins and oxidative stress induced by diesel exhaust particles

Protein tyrosine nitration is a post-translational modification that occurs under conditions of oxidative stress and may play a role in the pathogenesis of diseases such as asthma. Through their ability to generate reactive oxygen species in macrophages and epithelial cells, particulate pollutants, such as diesel exhaust particles (DEPs), may lead to a worsening of the asthmatic condition. In this study, we looked for evidence of oxidative modification of proteins in RAW 264.7 cell line treated with DEP chemicals. We show that the induction of oxidative stress is accompanied by 53 newly expressed proteins which are suppressed by a thiol antioxidant, N-acetylcysteine. These include antioxidant enzymes, pro-inflammatory components, and products of intermediary metabolism. In addition, inducible nitric oxide synthase (iNOS) was identified as a biologically relevant oxidative stress protein that is induced concurrent with increased NO production and protein tyrosine-nitration in DEP-exposed RAW 264.7 cells. Utilizing two-dimensional gel electrophoresis, anti-nitrotyrosine immunoblotting, and mass spectrometry led to the identification of an additional ten nitrotyrosine modified proteins, including oxidative stress proteins involved in intermediary metabolism (e.g., GAPDH and enolase), antioxidant defense (e.g., MnSOD) and inhibition of proteosomal activity (e.g., Hsp 90alpha). These oxidative proteins may serve as markers for oxidative stress generation in vivo.     

Prepared Low Stress Cubic Boron Nitride Film by Physical Vapor Deposition

We present low stress cubic boron nitride (cBN) films with a transition layer deposited on the metal alloy substrates by tuned substrate radio-frequency magnetron sputtering. The films were characterized by Fourier transform infrared spectroscopy and transmission electron microscopy (TEM). The IR peak position of cubic boron nitride at 1006.3 cm⁻¹, which is close to the stressless state, indicates that the film has very low internal stress. The TEM image shows that pure CBN phase exists on the surface of the film. Several phases of boron nitride were found at the medium implantation dose. It is believed that the transition from the low ordered phases to cBN phase occurred during implantation.