高效液相色谱法测定复方盐酸普莫卡因乳膏含量

目的建立高效液相色谱法(HPLC)测定复方盐酸普莫卡因乳膏含量的方法。方法选用CLC-ODS C18色谱柱(150 mm×4.6 mm,5μm),流动相为乙腈-磷酸盐缓冲液(55∶45,体积比)调节pH值为7.5,流速为1.0 mL/min,柱温为40℃,检测波长为224 nm。结果盐酸普莫卡因在0.212 0~0.903 5 mg/mL范围内浓度与峰面积呈良好线性关系(r=0.999 9),平均回收率为99.63%,RSD为0.53%。结论该法简便、快速、可靠,可用于复方盐酸普莫卡因乳膏的质量控制。     

分形集K的不可测性

从自相似集合的性质出发,通过容度研究了一类分形集合K的分形特征:M inkowski不可测性.     

路基工程施工探讨

从路基填筑前原地面的处理、路基填料的选择和填土路基的压实等方面全面总结了路基工程的施工经验。     

Synthesis and characterization of soluble polyimides containing trifluoromethyl groups in their backbone

A series of polyimides were synthesized from 2,2‐Bis(3,4‐dicarboxyphenyl)hexafluoropropane, 2,2‐bis(3‐amino‐4‐hydroxyphenyl)‐hexafluoropropane, and 4,4′‐oxydianiline by chemical imidization. The effects of the diamine ratios on the properties of the films were evaluated through the study of their thermal, electrical, and morphological properties. All the polymers exhibited better solubility in most of the organic solvents and hence were easily processable. Polyimides with more 2,2‐bis(3‐amino‐4‐hydroxyphenyl)‐hexafluoropropane exhibited better solubility and a low refractive index, which is highly desired for microelectronic applications. The dielectric constant and birefringence were strongly dependent on the fluorine content. With an increase in the fluorine substitution, both the dielectric constant and birefringence decreased. All the polymers exhibited high thermal stability (>400 °C). The absence of crystalline melting in differential scanning calorimetry and broad wide‐angle X‐ray diffraction patterns revealed the amorphous nature of the polymers, which was due to the presence of bulky CF₃ groups and hinged ether linkages of the diamine component. The residual stress values decreased with an increase in the 4,4′‐oxydianiline content, and the results were in agreement with the dielectric constant. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 4303–4312, 2004     

Developing a hybrid emulsion polymerization system to synthesize Fe3O4/polystyrene latexes with narrow size distribution and high magnetite content

A hybrid emulsion polymerization was formulated for synthesizing Fe₃O₄/polystyrene composite latex. This system, containing binary droplets that are magnetic (Mag)‐droplets with a diameter of 100–200 nm and styrene (St)‐droplets with a diameter of 3–4 μm, was obtained by mixing Mag‐miniemulsion and St‐macroemulsion. With extremely low surfactants concentration (?critical micelle concentration, CMC), the nucleated loci are selectively controlled in the Mag‐droplets, as the result of smaller droplet size and larger surface ratio. Both water‐soluble potassium persulfate (KPS) and oil‐soluble 2,2′‐azobis(2‐isobutyronitrile) was adopted to initiate the polymerization. In the presence of KPS, magnetic polystyrene latices with particles size of 60–200 nm, narrow size distribution, and high magnetite content (86 wt % measured by TGA) were attained successfully. The synthesized magnetic Fe₃O_4/polystyrene latices assembled into well‐ordered hexagonal structure in the surface of a carbon supported copper grid. The influence of various parameters on various aspects of the as‐synthesized Fe₃O₄/polystyrene was investigated in detail: type of initiator on composite morphology, feed ratio of Mag‐miniemulsion and St‐macroemulsion on magnetite content, and hydrophobic agent or amount of surfactant on size and size distribution. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 5285–5295, 2007     

利用光反射精确测量亚共析碳钢的含碳量

本文从光学角度出发提出了一种经济实用、精度高的测量亚共析碳钢中碳的含量的新方法。阐述了该方法的测量原理，即以金相试样表面对光的反射程度来判定其含碳量，并给出了有关经验公式及数据处理方法。     

空调冷凝器、蒸发器残留水分量检测系统

本文介绍了空调冷凝器、蒸发器残留水分量检测系统的组成和工作原理、技术指标、系统的工艺过程，最后说明了系统的考核和应用情况。     

用可调光锥系统获得卫星照片大尺度空间频谱的初步研究

将可调光锥系统直接应用于获得大尺度空间频谱的研究，得到了较满意的实验结果。     

江汉平原上空QTEC变化特征的统计分析

提出了一种观测台网用多接收机性能一致性的标定方法，并利用江汉平原GPS接收台网的观测数据，分析了该地区上空QTEC的日变化、季节变化、年变化和逐年变化的统计特征．标定结果表明，不同接收机之间的仪器偏差是从双频GPS卫星信标推算QTEC的主要误差来源之一，必须校正．统计分析证实，江汉平原上空QTEC的日变化特征同时受电离层和等离子层控制，其年变化以半年周期为主，峰值和谷值分别出现在两分点和两至点附近，QTEC值的逐年变化从太阳活动峰年到低年逐年下降，与以太阳黑子数为代表的太阳活动密切相关．     

Microwave promoted methylation of plant polysaccharides

O-Methylation is of outstanding importance in structural polysaccharide chemistry. A novel method for the methylation of polysaccharides using microwave (MW) irradiation is described. Seed gum from Cyamopsis tetragonolobus (Guar) was fully methylated with dimethyl sulphate and sodium hydroxide using 100% microwave power for 4 min in 68% yield. The completely methylated seed gum thus obtained was hydrolyzed by 70% formic acid followed by 0.5N H₂SO₄ under full microwave power for 1.16 and 1.66 min, respectively. The partially methylated monosaccharides were separated and identified.