Magnetic properties of mechanically alloyed Co–Ti powder

An amorphous phase containing traces of non-transformed Co and Ti powders was obtained by mechanical alloying nominal compositions of Co₆₇Ti₃₃ and Co₅₀Ti₅₀ in a high-energy ball-mill. These alloys were prepared from elemental powders of Co and Ti. The heat treatment of Co₆₇Ti₃₃ at 573, 873 and 1173 K crystallized nanoparticles of Co₂Ti and Co₃Ti compounds, while the same treatments conducted on Co₅₀Ti₅₀ resulted in the formation of Co₂Ti and CoTi nanoparticles. The saturation magnetizations reached a maximum value in the amorphous state and they decreased when the temperatures of the heat treatment rose. Demagnetizing interparticle interaction effects were estimated through hysteresis loops and initial magnetization curves using the Fourier technique.     

La5Al3Ni2 – an Intermetallic Phase Observed upon Crystallization of La50Al25Ni25 Metallic Glass

The yet unknown intermetallic phase La₅Al₃Ni₂ was obtained by partially crystallizing amorphous La₅₀Al₂₅Ni₂₅ at 550 K (further heating above 600 K leads to irreversible disappearance of this phase), and its crystal structure was determined from X‐ray powder diffraction data. The crystal structure of the La₅Al₃Ni₂ phase constitutes a new structure type (Cmcm, a = 14.231Å, b = 6.914Å, c = 10.460Å, oC40) and is built from [Al₃Ni₂] chains surrounded by La atoms. In the ternary system La‐Al‐Ni La₅Al₃Ni₂ is located on the section La₅₀Al_50−nNi_n (0 ≤ n ≤ 50) with the binary compounds LaAl and LaNi as end members. Strikingly, also the crystal structures of the end members can be conceived as chain structures with Al and Ni chains surrounded by La, respectively.     

Mössbauer and X-ray diffraction characterization of Fe60Al40 coatings prepared by thermal spraying

Microstructured (atomized) and nanostructured (milled) Fe₆₀Al₄₀ powders together with their corresponding coatings synthesized by High Velocity Oxy-fuel (HVOF) or Atmospheric Plasma Spray (APS) thermal spraying techniques have been characterized by Mössbauer Spectroscopy (MS) and X-ray Diffraction (XRD). The evolution of the microstructure and the atomic ordering degree in the powders and coatings are discussed at the light of the various processing conditions. The operational correlation between the parameters of the duplex morphology of coatings and the processing parameters is discussed.     

Energy of formation for and liquid binary alloys

We have investigated the free energy of formation for Ag_xIn_1-x and Ag_xSn_1-x liquid binary alloys at temperatures 1173 and 1250 K, respectively. A microscopic theory based on the first order perturbation has been applied. The interionic interaction and a reference liquid are the fundamental components of the theory. The interionic interaction is described by a local pseudopotential. A liquid of hard spheres (HS) of two different effective diametres and charges is used to describe the reference system. The results of the calculations for energy of formation agree very well with the available experimental data. Our calculations also reveal that a simple perturbative approach along with appropriate effective pair potentials can produce nearly quantitative results for the concerned alloys.     

Solid phase extraction for analysis of biogenic carbonates by electrothermal vaporization inductively coupled plasma mass spectrometry (ETV-ICP-MS): an investigation of rare earth element signatures in otolith microchemistry

Uptake of trace elements into fish otoliths is governed by several factors such as life histories and environment in addition to stock and species differences. In an attempt to elucidate the elemental signatures of rare earth elements (REEs) in otoliths, a solid phase extraction (SPE) protocol was used in combination with electrothermal vaporization (ETV) as a sample introduction procedure for the determinations by inductively coupled plasma quadrupole mass spectrometry (ICP-MS). Effects of various parameters, such as carrier gas flow rate, atomization temperature and chemical modification, were examined for optimization of the conditions by ETV-ICP-MS. Atomization was achieved at 2800 °C. Lower temperatures (i.e. 2600 °C) resulted in severe memory problems due to incomplete atomization. Palladium was used as a chemical modifier. It was found that an increase in Pd concentration up to 0.5 μg in the injection volume (70 μl) led up to four-fold enhancement in the integrated signals. This phenomenon is attributed to the carrier effect of Pd rather than the stabilization since no significant losses were observed for high temperature drying around 700 °C even in the absence of Pd. Preconcentration was performed on-line at pH 5 by using a mini-column of Toyopearl AF-Chelate 650M chelating resin, which also eliminated the calcium matrix of otolith solutions. After preconcentration of 6.4 ml of solution, the concentrate was collected in 0.65 ml of 0.5% (v/v) HNO₃ in autosampler cups, and then analyzed by ETV-ICP-MS. The method was validated with the analysis of a fish otolith certified reference material (CRM) of emperor snapper, and then applied to samples. Results obtained from otoliths of fish captured in the same habitat indicated that otolith rare earth element concentrations are more dependent on environmental conditions of the habitat than on species differences.     

稀土配合物Eu(asprin)_3phen发光特性的研究

将稀土配合物Eu(asprin)_3phen掺杂到导电聚合物PVK中,制成结构分别为ITO/PVK:RE配合物/LiF/AI(1),ITO/PVK:RE配合物/PBD/LiF/AI(2)的电致发光(EL)器件。发现二者的电致发光谱存在着较大的差别:在器件(1)中,来自Eu~(3 )的位于594nm(~5D_0→~7F_1)和614nm(~5D_0→~7F_2)处的发光强度大致相当,而在器件(2)中,EL主要来自Eu~(3 )位于614nm的发光,594nm处的发光很弱,与薄膜状态下的光致发光谱(PL)一致。并针对此现象进行了初步讨论。     

Comparison of the Kerr effect and X-ray pole figure methods for determining crystallographic texture in PrFeB magnets

In this study, magnetic domains in Pr₁₆Fe₇₆B₈ sintered magnets have been observed by Kerr effect and a histogram of the angular distribution of domain orientations has been used to determine the magnetic texture (cos Φ). The degree of easy-axis alignment of Pr₂Fe₁₄B matrix grains in these magnets has been also determined by X-ray pole figure analysis using the (0 0 4) reflection. The (0 0 4) pole figure measurements were carried out by the Schultz's reflection method. The (0 0 4) normalized intensity data has been fitted for a Gaussian distribution and the degree of crystal alignment, cos Θ, has been calculated using the Stoner–Wohlfarth model. Comparison of these methods has been carried out. It has been shown that in magnets with medium and high degrees of crystallographic alignment, the pole figure values are higher than that obtained by the Kerr effect method. Conversely, in magnets with low degrees of alignment, cos Θ is lower than cos Φ.     

Magnetic behaviour of TbMnFe

Neutron diffraction and M?ssbauer measurements have been carried out on the cubic Laves phase intermetallic TbMnFe. The magnetic moment on the transition metal atom is found to be low, 0.2μ _B, at room temperature. This moment is temperature independent down to 10 K. Magnetic moment on the rare earth atom varies from 2.5μ _B at 296 K to 7.27μ _B at 10 K. M?ssbauer spectra recorded at 298 K and 78 K have magnetic character but there is a large distribution of hyperfine field values. Both these features arise due to magnetic frustration created in the sample due to the competing ferro and antiferromagnetic interactions between the transition metal atoms.     

铝合金变形抗力的实验研究

采用恒应变速率凸轮式形变压缩试验机试验了四种铝合金材料的变形抗力 ,分析了应变率和应变速率对变形抗力的影响 ,结果表明随应变的增加 ,变形抗力以近似幂函数关系增加 ,在此基础上建立了简单、适用的变形抗力计算模型     

耐火砖模具的稀土高浓度渗碳

在煤油渗剂中添加微量稀土元素对A3钢耐火砖模具进行稀土高浓度渗碳 ,可使渗速加快 ,渗层碳浓度增高 ,层深尤其是过共析 共析层深度增加 ;渗层硬度较高且硬度梯度较缓 ;渗层组织中的碳化物数量增多 ,且呈细小颗粒状弥散分布。生产实践表明 ,经该工艺处理的耐火砖模具 ,使用寿命可比常规气体渗碳处理的提高2— 3倍。