多粘类芽孢杆菌同步糖化发酵玉米粉生产(R,R)-2,3-丁二醇

【目的】对多粘类芽孢杆菌Paenibacillus polymyxa的玉米粉同步糖化发酵工艺进行优化,以获得低成本、高效的(R,R)-2,3-丁二醇生产技术。【方法】研究玉米粉浓度、氮源种类和氮源浓度对菌体生长、耗糖能力以及(R,R)-2,3-丁二醇产量、产率、得率和转化率的影响,并在此基础上进一步考察培养基中其它成分对(R,R)-2,3-丁二醇发酵的影响。【结果】优化后的培养基组分为玉米干粉140g/L,酵母粉30g/L,Na_2HPO_4 3g/L,KH_2PO_43g/L,(NH_4)2SO_42g/L,MgSO_40.8g/L,微量元素溶液2mL/L。使用优化后的培养基进行同步糖化发酵,发酵50h后(R,R)-2,3-丁二醇产量达到56.28g/L(光学纯度为98.3%),对葡萄糖的得率为0.44g/g,产率为1.13g/(L·h)。【结论】(R,R)-2,3-丁二醇生产技术低价高效,可为其工业化生产提供参考。     

镇江长江征润州水源地综合风险评价

以镇江长江征润州水源地为例,在考虑水源地风险类型、水源地风险控制能力的基础上构建了水源地综合风险定量评价指标体系和评价方法,并确定各指标特征值的计算方法和风险等级划分标准,特征值计算中提出以风险累积指数反映风险源数量和集聚程度对水源地风险的影响程度,应用空间自相关分析方法确定风险累积指数。评价结果表明:征润州水源地风险等级为中风险;水源地安全威胁主要为上游20 km岸线内的沿江码头,废水直排企业和污水处理厂对水源地供水安全影响较小。     

基于波动负荷功率分析的闪变源判别方法

通过建立多闪变源电路等效模型,分析了闪变功率闪变源判别原理,构建了改进能量算子提取电压和电流闪变包络,采用改进FFT谱分析获得闪变包络参数计算闪变功率,基于闪变功率方向和幅值特性实现闪变源定位及其污染评估,提出并建立了基于波动负荷功率分析的闪变源判别方法.仿真分析和实验表明,提出方法能快速有效定位闪变源,准确评估多闪变源的污染程度,判别结果快速准确、误判率低.     

以离子液体为铝源和模板合成氧化铝纳米纤维

以咪唑类氯铝酸盐离子液体(x Al Cl_3-[C_(10)mim]Cl)为模板和铝源,采用溶胶-凝胶法合成了氧化铝纳米纤维.考察了氯铝酸盐离子液体中Al Cl_3的摩尔分数以及焙烧温度对纤维状氧化铝合成的影响,通过X射线衍射仪(XRD)、场发射透射电子显微镜(TEM)和物理吸附仪对样品进行了表征.研究结果表明,氯铝酸盐离子液体可以同时作为模板剂和铝源合成具有一定形貌的氧化铝.当Al Cl_3的摩尔分数x(Al Cl_3)=0.5时,可以合成出纳米纤维状氧化铝,纳米纤维直径约为2 nm,长度约为200 nm,比表面积为238.38 m~2/g,孔容为0.54 cm~3/g,平均孔径为8.43 nm.合成的氧化铝具有高的热稳定性,在900℃下焙烧依然能够很好地保持其形貌结构和γ晶型.此外,提出了氢键共π-π键堆积机理来解释超细纤维氧化铝的合成过程.     

微波等离子炬质谱负模式检测水中常见过渡金属离子

研究了负离子模式下锰、铁、钴、镍、铜和锌等常见过渡金属的微波等离子体炬(MPT)质谱特征,阐明了这些金属元素在MPT中形成阴离子的规律;初步得出饮用水中这些金属元素的最低检出限(LOD)均在约20μg/L量级,为实际检测这些金属元素奠定了基础.     

Source identification of nitrate by means of stable nitrogen isotopes in the river Daugava and loads of nitrogen to the Gulf of Riga

Nitrogen isotope ratio of nitrate provides a powerful tool to investigate nitrate sources and cycling mechanisms. Although the use of an isotope ratio method for ¹⁵N/¹⁴N allows identifying the nitrate sources in rivers by estimating a seasonal variation of N-NO₃ concentration, however, there are some restrictions. Nitrification, the conversion of NH₄⁺ to NO₃-, can proceed with significant nitrogen isotope fractionation, preferentially accumulating ¹⁴N in the produced NO₃-, and can make it difficult to identify the nitrate source with a high proportion of the isotope δ¹⁵N. However, the uptake and assimilation of NH₄⁺ and NO₃- have the capability of affecting isotopic compositions of riverine nitrogen compounds, and this may hinder the determination of whether the impact of the nitrate source with a high proportion of the isotope δ¹⁵N reduces. In addition, this study demonstrates that nitrate nitrogen concentration may correlate with δ¹⁵N_NO3 values both positively and negatively. Such correlations are the result of isotope effects during nitrogen transformation processes (e.g. nitrification and assimilation) and isotopic variability in the various nitrate sources. A comparison of NO₃- concentration and δ¹⁵N_NO3 can be used to further distinguish mixing from biological processing. However, in order to get a more precise answer regarding the nitrate sources, it would be useful to take both the data of nitrogen isotopes and data of oxygen isotopes present in nitrates.     

The H2+ molecular ion: Low-lying states

Matching for a wavefunction the WKB expansion at large distances and Taylor expansion at small distances leads to a compact, few-parametric uniform approximation found in Turbiner and Olivares-Pilon (2011). The ten low-lying eigenstates of H₂⁺ of the quantum numbers (n,m,Λ,±)$(n,m,\Lambda ,\pm )$  with n=m=0$n=m=0$ at Λ=0,1,2$\Lambda =0,1,2$, with n=1$n=1$, m=0$m=0$ and n=0$n=0$, m=1$m=1$ at Λ=0$\Lambda =0$ of both parities are explored for all interproton distances R$R$. For all these states this approximation provides the relative accuracy ?10⁻⁵$?10^{-5}$ (not less than 5 s.d.) locally, for any real coordinate x$x$ in eigenfunctions, when for total energy E(R)$E\left(R\right)$ it gives 10-11 s.d. for R∈[0,50]$R\in [0,50]$  a.u. Corrections to the approximation are evaluated in the specially-designed, convergent perturbation theory. Separation constants are found with not less than 8 s.d. The oscillator strength for the electric dipole transitions E1$E1$ is calculated with not less than 6 s.d. A dramatic dip in the E1$E1$ oscillator strength f_{1sσg−3pσu}$f_{1s{\sigma }_g-3p{\sigma }_u}$ at R∼R_eq$R\sim R_{eq}$ is observed. The magnetic dipole and electric quadrupole transitions are calculated for the first time with not less than 6 s.d. in oscillator strength. For two lowest states (0,0,0,±)$(0,0,0,\pm )$ (or, equivalently, 1sσ_g$1s{\sigma }_g$ and 2pσ_u$2p{\sigma }_u$ states) the potential curves are checked and confirmed in the Lagrange mesh method within 12 s.d. Based on them the Energy Gap between 1sσ_g$1s{\sigma }_g$ and 2pσ_u$2p{\sigma }_u$ potential curves is approximated with modified Pade Re^−R[Pade(8/7)](R)$R{e}^{-R}\left[Pade(8/7)\right]\left(R\right)$ with not less than 4-5 figures at R∈[0,40]$R\in [0,40]$ a.u. Sum of potential curves E_1sσg+E_2pσu$E_{1s{\sigma }_g}+E_{2p{\sigma }_u}$ is approximated by Pade 1/R[Pade(5/8)](R)$1/R\left[Pade(5/8)\right]\left(R\right)$ in R∈[0,40]$R\in [0,40]$ a.u. with not less than 3-4 figures.     

Correspondence between two types of rating indices for the heavy weight floor impact sound insulation of residential buildings

Of the two types of rating indices for the heavy weight floor impact sound insulation, the method of utilizing a rubber ball impact source combined with A-weighted sound level and the method utilizing a tire impact source combined with L-rating curve, the advantage of the former has been reported. In order to extend the advantage, the possibility was studied of estimating the rating utilizing the rubber ball impact source, based on the measurement results utilizing the tire impact source, especially for the case of a double leaf wooden floor. The correlation between the indices is not high enough to estimate one of them directly from the other with an accuracy not incorrectly estimating the rating grade of 5 dB step. The use of predictor variables, such as the special specifications of the double leaf wooden floor, for example, the use of sound insulation sheet, and the floor impact sound levels in the 31.5-Hz, 63-Hz and 125-Hz bands, is possibly able to increase the accuracy. Three principal types of multiple regression equation were derived through the analysis of measurement results in existing residential buildings.     

Mechanical Properties and In Vitro Physico‐chemical Reactivity of Gel‐derived SiO2–Na2O–CaO–P2O5 Glass from Sand

In the present report, a bioactive glass was synthesized from silica sand as economic substitute to alkoxy silane reagents. Sodium metasilicate (Na₂SiO₃) obtained from the sand was hydrolyzed and gelled using appropriate reagents before sintering at 950 °C for 3 h to produce glass in the system SiO₂? Na₂O? CaO? P₂O₅. Compression test was conducted to investigate the mechanical strength of the glass, while immersion studies in simulated body fluid (SBF) was used to evaluate reactivity, bioactivity and degradability. Furthermore, the glass samples were characterized by scanning electron microscopy (SEM), X‐ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR) and energy dispersive X‐ray spectroscopy (EDX) to evaluate the microstructure and confirm apatite formation on the glass surface. The glass, dominated by bioactive sodium calcium silicate, Na₂Ca₂Si₃O₉ (combeite) crystals, had mechanical strength of 0.37 MPa and showed potentials for application as scaffold in bone repair.     

城市生活垃圾与煤矸石混烧特性及其HCl排放特性研究

利用热重分析仪对城市生活垃圾与煤矸石单独及混合燃烧特性进行了研究,并采用高温管式炉燃烧装置考察了PVC、NaCl及MSW与煤矸石混烧过程中HCl的排放规律。结果表明,在煤矸石中掺烧部分MSW可有效改善煤矸石的燃烧特性,尤其是脱挥发分和着火特性。综合考虑燃烧特性变化,建议MSW掺混比例为20%。PVC与NaCl掺混比较低时,煤矸石可抑制PVC燃烧过程中HCl的析出,会显著促进NaCl中HCl的析出;当掺混比增大时,上述作用逐渐减弱。MSW与煤矸石混烧时,会促进HCl的析出,增大烟气中HCl的浓度。当掺混比为10%时,HCl排放浓度达到56.22 mg/m~3,已超过中国国家标准,必须采取相应脱氯措施。