Deactivation of silica surfaces with a silanol-terminated polysiloxane; structural sharacterization by inverse gas chromatography and solid-state NMR

Retention gape deactivated with Silicone OV-1701-OH show good chromatographic performance and remarkable stability against water induced stationary phase degradrdation. In an attempt to better understand the findamentals off the deactivation process using silanol terminated polysiloxanes, a fumed silica was deactivated with Silicon OV-1701-OH. In contrast to fused silic capillaries, fumed silica (Aerosil A-200) can be studied by ²⁹Si cross-polarization magic-angle-spinning (CPMAS) NMR, thus serving as a model substrate for fused silica. Retention data from inverse gas chromatography at infinite dilurion and ²⁹Si CP MAS NMR data of five Aerosil phases, differing in residual silanol surface concentration, are correlated with the aim of validating this approach for stationary phase characterization. A comparatively detailed model of the deactivating polymer layer that explains the observed absorption activities is deduced. Surface silanols are shown to play a key role in the polymer layer, the structure of which is of primary importance for the absorption behavior after deactivation. Contrary to common belief, the absolute silanol surface concentration after deativation is only of secondary importance for the overall absorption activity. High silanol surface concentrations enhance degradation of the polysiloxane chains into small cyclic fragments as well as subsequent absorption and immobolization to the silica substrate surface. The mobility of linear polysiloxane chains in the kHz regime (as determined bby NMR cross-polarization dynamics) appears to determine the extent which the residual silanols are accessible for analytes. It is therefore anticipated that there is an optimum silanol surface concentration of fused silica surfaces to be deactivated with silanol terminated polysiloxanes; it should be lazrge enough to adsord polymer fragments, but not large to avoid excessive residual silanol activity.     

含铜MCM—41型分子筛的合成与表征

本文首次合成出一种具有MCM-41型结构的中孔（mesoporous）CuMCM-41分子筛，通过XRD、骨架IR、紫外漫反射、电子自旋共振、固体魔角核磁、TG—DTA等测试结果，表征铜（Ⅱ）在分子筛中四面体配位和八面体配位形式共存。     

CdS/SiO2复合材料的低频Raman散射研究

对用溶胶凝胶法制备的ＣｄＳ／ＳｉＯ２复合材料进行低频Ｒａｍａｎ散射研究，结果表明可从其低频Ｒａｍａｎ散射峰位计算出ＣｄＳ微晶的粒径，两种不同的低频振动模式由激发光的两种偏振方向加以区分，低频Ｒａｍａｎ散射射的二级散射峰根据实验结果加以指认，所得平均粒径结果与透射电镜观察结果有较好的对应关系，复合材料吸收光谱吸收边蓝移与ＣｄＳ纳米子粒径之间存在着密切的关系，实验证明，样品吸收边能量与ＣｄＳ平均粒径的     

硫醇和硫醚的沸点与分子结构之间关系的拓扑化学研究

根据分子拓扑学原理, 用染色因子标识原子性质的差异, 发展了一种适用于含原子分子体系结构性能关系研究的新方法。据此探讨了硫醇和硫醚的沸点与分子结构之间的关系, 提出一个既能合理表征结构性能关系, 又能预测沸点的定量关系式。     

活泼配盐［(μ-RE)(μ-E′)Fe2(CO)6］［Et3NH］［E,E′=S,Se］的亲电反应研究——蝶状Fe2SSe及Fe2Se2簇合物的合成及表征

本文由［(μ-t-BuS)(μ-CO)Fe₂(CO)₆］［Et₃NH］和硒粉形成的［(μ-t-BuS)(μ-Se)Fe₂(CO)₆］［Et₃NH］，分别与溴化苄，二碘甲烷及邻一、间一、对一双(溴甲基)苯反应，合成了蝶状Fe₂SSe单簇物(μ-t-BuS)(μ-PhCH相似文献   

Multiphase Flow Regime Characterization and Liquid Flow Measurement Using Low-Field Magnetic Resonance Imaging

Multiphase flow metering with operationally robust, low-cost real-time systems that provide accuracy across a broad range of produced volumes and fluid properties, is a requirement across a range of process industries, particularly those concerning petroleum. Especially the wide variety of multiphase flow profiles that can be encountered in the field provides challenges in terms of metering accuracy. Recently, low-field magnetic resonance (MR) measurement technology has been introduced as a feasible solution for the petroleum industry. In this work, we study two phase air-water horizontal flows using MR technology. We show that low-field MR technology applied to multiphase flow has the capability to measure the instantaneous liquid holdup and liquid flow velocity using a constant gradient low flip angle CPMG (LFA-CPMG) pulse sequence. LFA-CPMG allows representative sampling of the correlations between liquid holdup and liquid flow velocity, which allows multiphase flow profiles to be characterized. Flow measurements based on this method allow liquid flow rate determination with an accuracy that is independent of the multiphase flow profile observed in horizontal pipe flow for a wide dynamic range in terms of the average gas and liquid flow rates.     

Optimization and Validation of a Headspace Solid-Phase Microextraction with Comprehensive Two-Dimensional Gas Chromatography Time-of-Flight Mass Spectrometric Detection for Quantification of Trace Aroma Compounds in Chinese Liquor (Baijiu)

The detection of trace aroma compounds in samples with complex matrices such as Chinese liquor (Baijiu) requires a combination of several methods, which makes the analysis process very complicated. Therefore, a headspace solid-phase microextraction (HS-SPME) method coupled with two-dimensional gas chromatography time-of-flight mass spectrometry (GC×GC-TOFMS) was developed for the quantitation of a large number of trace compounds in Baijiu. Optimization of extraction conditions via a series of experiments revealed that dilution of the alcohol content of 8 mL of Baijiu to 5%, followed by the addition of 3.0 g of NaCl and subsequent SPME extraction with DVB/CAR/PDMS fiber coating over 45 min at 45 °C was the most suitable. To check the matrix effects, various model Baijiu matrices were investigated in detail. The quantitative method was established through an optimized model synthetic solution, which can identify 119 aroma compounds (esters, alcohols, fatty acids, aldehydes and ketones, furans, pyrazines, sulfur compounds, phenols, terpenes, and lactones) in the Baijiu sample. The developed procedure provided high recovery (86.79–117.94%), good repeatability (relative standard deviation < 9.93%), high linearity (R² > 0.99), and lower detection limits than reported methods. The method was successfully applied to study the composition of volatile compounds in different types of Baijiu. This research indicated that the optimized HS-SPME–GC×GC-TOFMS method was a valid and accurate procedure for the simultaneous determination of different types of trace compounds in Baijiu. This developed method will allow an improved analysis of other samples with complex matrices.     

Electrochemical investigation of the interaction of 2,4-D and double stranded DNA using pencil graphite electrodes

2,4-dichlorophenoxyacetic acid (2,4-D) is an auxinic herbicide used to control broadleaf weeds. It is also a threatening factor for not only aquatic life but also human health due to its genotoxicity and endocrine disruptive property. Herein, the interaction between 2,4-D and double stranded DNA was investigated by using single-use pencil graphite electrodes (PGE) in combination with electrochemical techniques. The detection mechanism was based on the monitoring of the changes at the guanine oxidation signal obtained before/after surface-confined interaction of 2,4-D and DNA at the surface of PGE. The electrochemical characterization of the interaction was studied by using microscopic and electrochemical techniques. The response obtained by interaction in the presence of another herbicide, glyphosate, which is widely used with 2,4-D for weed control, was compared to the one occurred in the presence of 2,4-D. Electrochemical monitoring of the interaction between the herbicide whose active molecule was 2,4-D and DNA was also investigated. The detection (LOD) and quantification limits (LOQ) for 2,4-D and the herbicide could be obtained in the linear concentration ranges of 30–70 µg/mL and 10–30 µg/mL, respectively and LOD and LOQ values were found to be 2.85 and 9.50 µg/mL for both 2,4-D and the herbicide. The sensitivity of the biosensor was calculated as 0.087 µA.mL / µg.cm² .This is the first study in literature by means of not only voltammetric detection of 2,4-D and DNA interaction but also the herbicide-DNA interaction at the surface of PGE based on the changes at the guanine signal.     

Synthesis,Characterization and Evaluation of Peptide Nanostructures for Biomedical Applications

There is a challenging need for the development of new alternative nanostructures that can allow the coupling and/or encapsulation of therapeutic/diagnostic molecules while reducing their toxicity and improving their circulation and in-vivo targeting. Among the new materials using natural building blocks, peptides have attracted significant interest because of their simple structure, relative chemical and physical stability, diversity of sequences and forms, their easy functionalization with (bio)molecules and the possibility of synthesizing them in large quantities. A number of them have the ability to self-assemble into nanotubes, -spheres, -vesicles or -rods under mild conditions, which opens up new applications in biology and nanomedicine due to their intrinsic biocompatibility and biodegradability as well as their surface chemical reactivity via amino- and carboxyl groups. In order to obtain nanostructures suitable for biomedical applications, the structure, size, shape and surface chemistry of these nanoplatforms must be optimized. These properties depend directly on the nature and sequence of the amino acids that constitute them. It is therefore essential to control the order in which the amino acids are introduced during the synthesis of short peptide chains and to evaluate their in-vitro and in-vivo physico-chemical properties before testing them for biomedical applications. This review therefore focuses on the synthesis, functionalization and characterization of peptide sequences that can self-assemble to form nanostructures. The synthesis in batch or with new continuous flow and microflow techniques will be described and compared in terms of amino acids sequence, purification processes, functionalization or encapsulation of targeting ligands, imaging probes as well as therapeutic molecules. Their chemical and biological characterization will be presented to evaluate their purity, toxicity, biocompatibility and biodistribution, and some therapeutic properties in vitro and in vivo. Finally, their main applications in the biomedical field will be presented so as to highlight their importance and advantages over classical nanostructures.