乙醇 /水混合溶剂沉淀制备纳米BaF2及粒径控制

采用水和乙醇混合溶剂沉淀的方法制备了不同粒径的BaF₂纳米粉体。用XRD、TEM和FSEM表征了粉体的粒径和形貌。研究了陈化时间、水和乙醇的体积比对BaF₂纳米粉体的粒径和形貌的影响。结果表明，随混合溶剂中乙醇含量升高，沉淀粒径减小。BaF₂沉淀粒径的倒数和溶剂介电常数的倒数呈线性关系，据此关系可以控制BaF₂纳米粉体的粒径。     

HPLC of synthetic polymers characterization of polystyrenes by high performance precipitation liquid chromatography (HPPLC)

Summary The advantages and disadvantages of high performance precipitation liquid chromatography have been demonstrated for polystyrene homopolymers. Depending on the mobile phase composition at the dissolution point of the polymeric sample and surface properties of the stationary phase, elution is governed either by a solution process or by adsorption. A contribution by adsorption was noticed on silica as well as on reversed phases based on silica with a normal phase gradient of increasing polarity (heptane to dichloromethane). Elution was solely governed by solubility of the polymers on both types of stationary phase for polystyrenes with a molecular weight above 35 000 and reversed phase gradient of decreasing polarity (methanol to dichloromethane). Under these conditions an identical dependence of elution solvent composition on sample size was found as for turbidity titrations. Due to differences in the velocity of the eluent front and the polymeric sample with porous stationary phases the polymers can be eluted as colloidal solutions Non-porous stationary phases are superior in this respect because the velocities of eluent and solutes are identical.     

Improvement of direct determination of Cu and Mn in seawater by GFAAS and total elimination of the saline matrix with the use of hydrofluoric acid

Hydrofluoric acid, added to seawater, can assist in the removal of chloride in the drying step by precipitating fluoride salts, thus suppressing the chloride interference effects induced on the atomization signals of Cu and Mn. By adding HF to seawater before the analysis, MgF₂ and CaF₂ are precipitated at the bottom of the sampling flask, without precipitating Cu and Mn, and are consequently not introduced into the graphite furnace. Because sodium salts are eliminated at the pretreatment step, the whole seawater matrix is eliminated before the atomization of Cu or Mn. Therefore, the analyzed volume of seawater can be increased by using the multi-injection procedure without degradation of the limit of detection and risks of spectral interferences. The limit of detection obtained for Cu and Mn are 0.05 and 0.01 μg L⁻¹, respectively, for a 50 μL analyzed seawater volume.     

碳酸盐前驱物制备Y2O3超细粉及透明陶瓷

以Y(NO3)3和NH4HCO3为原料,通过向Y(NO3)3溶液中滴加NH4HCO3的方式制备了化学组成为Y2(CO3)3·2H2O的先驱沉淀物。研究了先驱沉淀物煅烧过程中的物相变化。先驱沉淀物1100℃煅烧4h后得到了平均粒径为60nm的无团聚Y2O3超细粉体。所得粉体不添加任何添加剂,在1700℃下真空烧结4h得到了透明Y2O3陶瓷。     

Electrochemical characterization of solid materials in volume range I. Chemical effects on the matrix-phase separation

The electrochemical phase isolation (EPI) is described as a preparation method for determining specific precipitations in solid materials in microamounts and microdimensions. Fundamental criteria are examined as a function of the main parameter (polarization current) on the system Fe₃C in a Fe-matrix. The influence of the electrolyte composition on the electrochemical behaviour of the matrix, on the one hand, and of the phase, on the other hand, are investigated and utilized.     

高比表面积窄孔分布氧化铝的制备研究 Ⅰ.沉淀条件的影响

 以硫酸铝液为原料，以氨水、氢氧化钠和铝酸钠为碱沉淀剂，采用pH摆动法制备了高比表面积、大孔径、窄孔分布、大孔体积氧化铝，考察了沉淀剂、沉淀温度及沉淀时酸侧pH值对氧化铝物性的影响，并对pH摆动法与等pH沉淀法的结果进行了比较．结果表明，通过改变制备参数可以获得高比表面积、大孔体积的氧化铝，当沉淀温度为70℃，pH摆动3或4次时，氧化铝的孔体积可高达1．0ml／g，比表面积仍大于300m2／g．用pH摆动法制得的样品比用等pH沉淀法制得的样品容易酸溶，对挤压成型有利．不同样品在酸溶液中的分散性表明，用氨水沉淀剂可获得相对较小的沉淀粒子．改变沉淀时酸侧的pH值，可导致沉淀粒子的结构发生变化．     

云南两高辐合背景下低涡强降水过程对比分析

基于气象观测和欧洲中期天气预报中心第五代大气再分析资料（ERA5）,选取2018—2020年发生在云南的3次两高压辐合区（以下简称两高辐合）背景下低涡连续性强降水过程进行对比分析,探究其环流形势、动热力因子及水汽辐合的相似性和差异性.结果显示：(1)夏半年西太平洋副热带高压（以下简称西太副高）西伸时,云南常受两高辐合影响,当辐合区中有低涡生成,易发生连续性强降水,且强降水落区并不完全分布在整个狭长的两高辐合区内.(2)两高辐合区低涡降水具有相似的雨带分布和移动特征,但雨带的集中程度、分布范围、小时雨强和总雨量存在差异.强降水开始时,落区偏东,随着西太副高西伸及东北引导气流的引导,低涡向南向西移动,强降水落区也随之向南向西移动.低涡在某一地区徘徊导致降水集中在该区域,且西太副高西伸较强时,两高辐合形势更强,低涡降水大雨及以上量级雨带也更窄.(3)低涡造成的降水主要分布在低涡中心及低涡切变附近,且降水发生在低层暖湿的环境中,低层及中高层有冷空气侵入时,小时雨强的极端性更强,降水落区也相对偏北.两高辐合区低涡降水落区与水汽辐合区对应较好,水汽辐合强度较弱时,对应的总降水量较小.     

42CrMo钢离子氮化—沉淀强化组织结构的研究

研究了42CrMo钢离子氮化—沉淀强化的组织结构,结果表明,离子氮化层的组成为ε、r＇a_N、Fe_3C和少量Cr_2N、Mo_2N、CrMoN_x及a";经时效处理后,ε相和a_N相弥散析出Cr_2N、Mo_2N和a" 。325℃时效,CrMoN_x消失;500℃时效,Mo_2N大大减少。a"、Cr_2N和Mo_2N弥散共格析出,必将使氮化层强化。     

不同降水驱动的SWAT模型参数不确定性研究

以抚河流域与黑河流域为研究区,应用4种降水产品(CMORPH CMA、CMFD、CMADS、MSWEP)驱动SWAT模型模拟日流量,评估4种降水产品在湿润区与干旱区的适用性;使用自适应降维评估法选出流域的敏感参数,并进行一致性检验。结果表明:抚河流域4种降水产品的纳什效率系数(NSE)均在0.70以上,其中CMORPH CMA和CMADS的NSE均能达到0.82;黑河流域CMORPH CMA和CMADS的NSE大于等于0.76,而CMFD和MSWEP的NSE分别为0.72和0.74。抚河流域4种降水产品具有相同的敏感参数;黑河流域CMORPH CMA和CMADS有相同的6个敏感参数,而CMFD和MSWEP则分别有5个和8个敏感参数。4种降水产品在湿润流域和干旱流域都能得到较好的应用效果,但是CMORPH CMA和CMADS的模拟效果要优于CMFD和MSWEP。不同的降水输入也会对模型参数敏感性分析的结果产生影响,当降水表现越接近时,所筛选的敏感性参数也越相似。     

长江中下游地区汛期降水量异常与旱涝趋势

在（25°～35°N．100°～125°E）范围内利用48个测站1950～1991年降水资料和1470～1974年旱涝等级资料对长江中下游地区汛期（6～8）月降水异常和旱涝趋势进行了统计分析和推断,得出：长江中下游地区汛期降水量一般在450～600mm．相对变率为0.25～0．40．历年降水量最大值出现在武汉地区、浙皖赣交界地区以及苏北兴化─东台地区、最小值出现在安徽合肥─霍山地区,20a、30a、50a─遇的异常多降水量的最大值出现在武汉、衢县及兴化─东台地区,异常少降水量的最小值出现在大别山及长江三角洲地区．大范围旱涝连续出现和交替出现的可能性很小,在长江中游地区汛期旱涝具有50a和20a的周期变化,长江下游地区具有100a和20a的周期变化,本世纪80年代以来长江下游地区降水量波动增加．预计下世纪10～30年代将是洪涝多发期．10～20年代长江中游地区将是干旱多发期．