Pt-Sn脱氢催化剂浸渍状态的Sn-119和Pt-195的多核NMR研究

测定了Ｐｔ－Ｓｎ型催化剂浸渍状态下的Ｓｎ－１１９、Ｐｔ－１９５的多核核磁共振。当ＳｎＣｌ２／ＤＣｌ溶液体系中加入Ｈ２ＰｔＣｌ６以后，出现了Ｓｎ（Ⅳ）和另外一种Ｓｎ（Ⅱ）的构型，Ｓｎ－１１９峰向高场位移，说明部分Ｓｎ（Ⅱ）被氧化成Ｓｎ（Ⅳ），Ｈ２ＰｔＣｌ６的量对这种氧化性影响较小。而Ｈ２ＰｔＣｌ６／Ｄ２Ｏ溶液体系中加入ＳｎＣｌ２以后部分Ｐｔ（Ⅳ）被还原成Ｐｔ（Ⅱ），随着ＳｎＣｌ２量的增加，Ｐｔ（Ⅱ）     

Study on the Phase Diagram of CsCl-CeCl3-HCl(11%)-H2O System and the Properties of the Compounds

The equilibrium solubility of CsCl-CeCl3-HCl(11%)-H2O qua-ternary system at 25℃ has been determined by the physicchemical analysis method ,and the phase diagram was plotted, Two new double salts 3CsCl.CeCl3.3H2O and CsCl.CeCl3.4H2O obtained from the complicated system were identified and characterized by XRD,TG-DTA ,DSC,UV and fluorescence spectroscopy, Studies on the fluorescence excitation and emission show that 3CsCl.CeCl3.3H2O and CsCl.CeCl3.4H2O have upconversion luminescence of infrared-visible range,and the upconversion emission intensity increases with the increase of ratio of CeCl3 in CsCl.     

Solvent intercalation in cobalt dimethylglyoximato complexes: A miniature host-guest system

When crystallized from appropriate solvents, the complex aqua-bis(dimethylglyoximato)nitrocobalt (III) may incorporate solvent molecules, thus forming a variety of mixed crystals. In the resulting host-guest crystals, the space groupP2_l/m and the packing motif of the pure host compound are retained. Lattice constantsa andb remain essentially unaltered upon intercalation, whereasc and the monoclinic angle depend largely on the clathrated guest. Space filling and intermolecular contacts are discussed.Dedicated to Professor Peter Paetzold at the occasion of his 60th birthday. A preliminary account of this work has been given at the Spring Meeting of the British Crystallographic Association, Newcastle upon Tyne, 1994.     

钾镁氯化物(硫酸盐)与脲、水体系的溶度研究

报导了KCl-MgCl2-CO(NH2)2-H2O和K2SO4-MgSO4-CO（NH2）2-H2O两个四元体系在25℃时的溶度及其饱和溶液的折光率、密度，相应的溶度图和组成-折光率、组成-密度图．前一体系中形成3个三元化合物：MgCl2·4CO（NH2）2·2H2O、MgCl2·CO（NH2）2·4H2O和KCl·MgCl2·6H2O溶度盐份图由9支共饱线、4个四元无变点组成．四元体系的水量图、性质-组成图有类似的变化．后一体系中有2个异成份溶解化合物MgSO4·CO（NH2）2·2H2O和K2SO4·MgSO4·6H2O形成，溶度等温图由7支双饱溶度线、3个四元无变点组成．对两个体系相图的相似性和差异点进行了讨论．     

Effects of type and number of impellers and liquid viscosity on the power characteristics of mechanically agitated gas—liquid systems

Effect of the type and number of high-speed impellers installed on a common shaft on the power characteristics was investigated in water and glucose solutions of different concentration. Different configurations of the Rushton or Smith turbines, pitched blade turbines, propeller, and A 315 impeller were tested. Measurements of power consumption were carried out within the transitional and turbulent regime of the fluid flow using the strain gauge method. Baffled agitated vessels with inner diameter of 0.288 m and 0.634 m were used for the experiments. Liquid height in the vessels was equal to the vessel diameter or it was twice higher. The relative power consumption was compared for different configurations of the impellers. Presented at the 33rd International Conference of the Slovak Society of Chemical Engineering, Tatranské Matliare, 22–26 May 2006.     

四元缔合物体系薄层树脂相分离与光度法联用测定痕量钴

提出了在酸性条件下 (pH=5.0),利用阳离子交换树脂-丁二酮肟-碘-钴四元体系,通过薄层树脂相光度法测定钴的新方法。本法灵敏度高 (e454=1.7105L/molcm),比水相光度法提高14倍,精密度理想 (测定2.0礸/ml Co(II) 6次,RSD=1.3%),选择性好。实测药品VB12及天然水中钴,线性范围0.024~2.0礸/ml (定容50ml),检出限10.4ng/ml。     

An efficient procedure for the synthesis of coumarin derivatives using TiCl4 as catalyst under solvent-free conditions

The ability of titanium(IV) chloride as a catalyst to promote the Pechmann condensation reaction with a range of phenols and β-keto esters is described.The reaction was carried out by addition of TiCl₄ to a mixture of the phenol and the β-keto ester with thorough stirring in the absence of a solvent and represents an improvement on the classical Pechmann conditions. The yields of coumarins obtained via this novel protocol were significantly higher than those using the conventional method and the reaction duration was reduced to a few minutes or even a few seconds.     

Frequent analytical/experimental problems in lipase-mediated synthesis in solvent-free systems and how to avoid them

Compared with chemical catalysis, enzymatic catalysis is a relatively new topic. Experimental work involving lipases deserves careful attention and accurate procedures still need to be implemented. A rapid but careful survey of published data immediately demonstrates that experiments performed under similar conditions with similar reagents have led to very different results. The aim of this work is to point out the importance of accurate and systematic procedures in order to ensure the reproducibility of experimental data. We strongly believe that different results found by different labs are due to problems detected in the procedures used. Quantification of the immobilisation efficiency of lipase on several supports through UV/visible methods and sampling methods used to obtain correct enzymatic activity values are specifically analysed. After a brief review which demonstrates the big discrepancies found in the literature, original data from Candida rugosa lipase adsorption on polypropylene powder and its use in the solvent-free synthesis of ethyl oleate are introduced in order to exemplify the difficulties found in these kinds of systems. Several procedures described in the literature are assayed and the accuracy of the results obtained is carefully analysed. The aim of the whole analysis performed is that it would be useful for any powdered solid to be used as a support for a lipase in a solvent-free system for any synthesis reaction, especially for those involving a volatile reagent. Throughout this contribution, special emphasis is placed on how catalytic reaction results using enzymes (free and immobilised) are reported so as to allow comparison between published data, something which is usually difficult since very different units are used and often complementary data are not included.     

Ferroelectric phase transitions in Pb2xSn2(1-x)P2Se6 system

Heat capacities of the Pb_2xSn_2(1-x)P₂Se₆ crystals (x=0, 0.098, 0.251, 0.402 and 1.0) were measured using an adiabatic calorimeter at temperatures between 10 and 350 K. In the crystal of x=0, two heat capacity anomalies corresponding to the ferroelectric commensurate - intermediate incommensurate(C-IC) phase transition temperature T _i, and the incommensurate - paraelectric (IC-N) phase transition temperature T _c, were observed at 193.24±0.10 and 220.07±0.15 K, respectively. The phase transition temperatures decreased with an increase in Pb²⁺ concentration. The anomaly at Ti disappeared at x=0.251 in the mixed systems of the Pb_2xSn_2(1-x)P₂Se₆. In the crystal of Pb₂P₂Se₆ (x=1.0), no phase transition was observed. The normal heat capacities for the mixed crystals were determined by least squares fitting of the Debye and Einstein functions to the experimental data. The anomalous heat capacities gave the phase transition entropies of 8.5 and 1.5 J mol^-1 K^-1 for x=0. The large transition entropies are consistent with an order-disorder mechanism in the ferroelectric-paraelectric phase transitions in x=0. This revised version was published online in August 2006 with corrections to the Cover Date.     

Diagramme de phases du systeme binaire LiNO3-NaNO3

Phase diagram of the binary system LiNO₃-NaNO₃ has been obtained by using direct and differential thermal analysis between 323 and 623 K. This system is characterized by an eutectic plateau at 467 K. The eutectic point is at 0.465 mole NaNO₃. A peritectic appears at 550 K. There is no miscibility in the solid state. These findings associated with some other thermodynamic results have been used to calculate the activities of the constituents along the liquids curve and the excess thermodynamic functions at 618 K. The constituents seem not to have a symmetrical influence on the thermodynamic quantities.