Retardation characteristics and birefringence of a multiple-order crystalline quartz plate

A crystalline quartz plate of thickness 1.070 mm is calibrated between 370 and 794 nm. Throughout this spectral interval, the retardance varied by 32π and the plate introduced quarterwave retardance 16 times at different wavelengths. The birefringence (n_e−n_o) of crystalline quartz was calculated as a single quantity and varied from 0.00971 at 370 nm to 0.00891 at 794 nm. All measurements were carried out at 23°C.     

改性沥青防水卷材的地下室施工

介绍新型防水材料ＳＢＳ改性沥青柔性油毡的性能、施工工艺、操作方法及保证质量的措施，并提出存在的问题及施工中注意事项。     

等腰三角形Mindlin板的自由振动分析

提出了一种新方法来对基于 Mindlin剪切变形理论的等腰三角形板进行自由振动分析 .此方法采用了一种新的基函数并利用 pb-2 Rayleigh-Ritz边界函数得到了一种新型的 Ritz方法 .这种方法的有效性通过收敛性和对比性分析得到了证实 .数值结果表明此方法相当精确有效 .     

微极各向同性弹性板中的Rayleigh-Lamb波

研究了无应力作用条件下，均匀、各向同性、圆柱形微极结构弹性板中波的传播．导出了对称和斜对称模式下波传播的特征方程．对短波这一极端情况，无应力圆板中对称和斜对称模态波的特征方程退化为Pmyle曲表面波频率方程．并得到薄板的计算结果．给出了位移和微转动分量，并绘制了相应图形．给出了若干特殊情况的研究结果及对称和斜对称模态特征方程的图示．     

关于非平行板电容器电容计算的讨论

用串联方法计算非平行板电容器的电容，简便地得到与其他方法相同的结果。     

大焦深成像系统仿真实验研究

如何增大非相干光学成像系统的焦深是应用光学研究领域的热点问题.本文对采用高次非球面光学掩模板与图像处理相结合增大成像光学系统焦深的新方法进行了深入分析,建立了大焦深成像系统仿真实验模型,并进行了大焦深成像系统仿真实验.实验结果证明了该方法在维持原相对孔径的同时使光学系统在较大的离焦范围内有好的成像质量.实际应用中还要综合考虑模板参量、信噪比等关键因素.     

Load-Carrying Capacity of Circular Plates Made of a Fiber-Reinforced Composite

The load-carrying capacity of circular plates made of a fiber-reinforced composite and loaded with axisymmetric transverse forces under axisymmetric boundary conditions is investigated. The plates can be freely supported or clamped along their contour. To the known yield condition used, in the plane of main bending moments, there correspond irregular hexagons, which depend on the mechanical properties of composite constituents and some characteristic geometrical parameters. It is shown that, depending on the ratio of ultimate radial and circumferential bending moments, in the plastic state, the circular plates (the central part of the clamped plates) take the form of a cone or a frustum of cone. For each of the cases, the limit load is found, which is a function of the above-mentioned mechanical parameters. The statically allowable fields of bending moments and the corresponding allowable fields of deflection rates are determined. The solutions found are exact. Special cases for the freely supported plates are analyzed, and the results obtained are presented in the form of graphs.__________Translated from Mekhanika Kompozitnykh Materialov, Vol. 41, No. 2, pp. 177–192, March–April, 2005.     

Relation between the Hydrodynamic and Elastic Parameters in Surface Wave Diffraction on a Floating Plate

The problem of surface wave diffraction on a floating elastic plate is considered. The relation between the parameters of the elastic vibrations of the plate and the transmitted and reflected wave amplitudes is investigated. It is shown that the maximum amplitudes of the plate stresses and deflections depend nonmonotonically on the incident wave frequency and are reached simultaneously with the maxima of both the transmission coefficient and the length of the wave penetrating into the plate. This makes it possible to use the transmission coefficient as a parameter for investigating the maximum and minimum amplitudes of the hydroelastic vibrations of the plate. As an example, this criterion is used to minimize the vibrations of a plate whose leading edge is elastically connected to the bottom.     

草酸生产水洗塔设计

对目前国内合成法生产草酸所用水洗塔,采用加大水量到50m~3/h,提高塔板开孔率到19.55%(一般推荐6%～12%),降低溢流堰高为25mm,增大降液管到下层塔板间距为95mm 的办法,使洗涤后的气体达到要求。     

三种测应变线路的比较

介绍了三种测应变的线路,通过实验证实,在测扭矩时,用4片电阻应变片构成的线路,可以排除弯矩的影响。