工程实践中的体系与系统

 介绍了国际上通行的体系概念，通过实例阐述了常见的体系类型，从多个维度描述了系统与体系的区别，根据实践总结，提出体系与系统的核心界定准则，并结合工程实践进行了详细描述。     

多纤芯弹性光网络中虚拟网络映射模型及算法

为解决多纤芯弹性光网络虚拟化中的虚拟结点映射、链路映射和频谱分配问题,首先建立了一个以最小化占用的频谱数及最小化最大占用频隙号为目标的全局约束优化模型.其次,设计了具有高效的交叉、变异及不可行解可行化算子的全局优化遗传算法,以有效求解该模型得到最优的虚拟节点、链路映射方案.最后,为验证算法的有效性进行了不同的仿真实验.结果表明,所设计的算法能够有效地减小网络中占用的频谱数和最大占用频隙号.     

考虑外委的露天矿剥岩计划的优化研究

针对“剥岩高峰”对矿山生产带来的不利影响，研究了设备配置更新策略与露天开采外委剥离的优化问题.基于铲运设备的运营成本与生产能力随设备役龄变化的关系，建立了决策单台设备退役时间的动态经济寿命计算模型，并根据此模型给出了具体的设备配置算法步骤.设置一系列不同的矿山自剥离量与外委剥离量的分界水平，计算各分界水平条件下的外委单价可行区间，然后在区间内确定外委商谈价格并分析得出与之对应的总成本净现值最低的外委方案.实例计算证明，采用该方法减少设备投资的成本要高于外委岩石剥离成本.     

基于免疫粒子群优化的移动Sink路径规划算法

为了减少能量空洞和延长网络生命周期，在无线传感网中采用移动 Sink 的方式收集节点采集的数据是解决能 量效率问题的有效措施．采集路径的规划问题类似于旅行商问题，无法得到多项式时间的解．提出了将人工免疫算法和粒子群算法相结合，针对移动 sink 数据收集的路径规划问题寻求近似最优解，仿真结果表明: 与其他算法进行性能比较，所提出的优化算法能够有效减少能耗和缩短遍历路径．     

Synthesis of diisocyanides with phenolic groups and their polymerization to helically chiral poly(quinoxaline‐2,3‐diyl)s

The development of synthetic routes which lead to five new diisocyanide monomers with one or two phenolic groups is described. Their polymerization behavior is studied with Pd‐ and Ni‐based initiators, as well as under microwave irradiation. The polymerizability is mainly dominated by steric effects as is concluded from experiments using different protecting groups. Chiroptical properties of these new polymers are studied by CD‐spectroscopy. After deprotection, helically chiral poly(quinoxalin‐2,3‐diyl)s are obtained which display a Brønsted function attached to a stereolabile biaryl axis whose configuration should be influenced by the chiral polymer backbone. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2015 , 53, 1320–1329     

基于串联两阶段网络DEA模型的供应链规模收益分析

数据包络分析(DEA)是评价供应链系统(Supply chain system)间相对有效性的一种重要的工具,但是传统的DEA不考虑供应链的内部结构,对系统效率评价偏高;而本文所研究两阶段串联供应链系统,考虑把部分中间产品作为最终产品输出,增加额外中间投入的情形.基于所提出的供应链系统结构,本文建立相应的串联结构下的网络DEA模型,并针对所建立模型进行相关理论的研究,给出了串联结构下的生产可能集和规模收益情况判定方法.最后,进行数值实验,以验证我们提出的结论.     

The deformation and fracture of balloons

Inflation of balloons provides a straightforward way of achieving large biaxial deformations. Previous studies have shown that when a balloon bursts, crack propagation occurs at very high speed – much higher than would be expected from the low strain modulus and elastic wave velocity of the rubber. The present paper is concerned with studies of the deformation and fracture of cylindrical balloons. On inflation, the deformations of such a balloon pass through an unstable region but subsequently increase monotonically with pressure. In this relatively high pressure region, the ratio of the longitudinal and circumferential extension ratios is broadly in accord with expectations from high-strain elasticity theory when the ratio of the corresponding stresses is taken into account. On bursting, crack speeds up to around 300 m/s in this region. It is shown that these speeds are in accord with large increase in incremental moduli for the highly-strained rubber. Marked changes in crack tip profile observed at very high crack speeds are consistent with control of the rate of growth by inertia rather than by the viscoelastic properties of the rubber (as is believed to be the case at lower speeds). Consistent with this, various elastomers having different glass transition temperatures show similar crack growth behaviour in the very high speed region.     

2008—2012年《中华实用儿科临床杂志》载文文献计量分析

目的:分析《中华实用儿科临床杂志》近5年发展情况,为提高该刊质量提供参考依据. 方法:通过"中国生物医学文献数据库"收集该刊2008—2012年的文献题录,采用文献计量学方法,对文献的时间分布、单位分布、作者分布、作者合作情况、单位合作情况、高频关键词、高频主题词等指标进行统计分析. 结果:2008—2012年《中华实用儿科临床杂志》共载文3 459篇,单篇论文的长度在逐年增长;涉及作者13 870位,每篇论文作者平均数量大于4,每篇论文的平均合作单位数量多于1.45,关键词和主题词符合本刊的主题.2008—2010年被引的文献为1 131条,占期间总文献量的62%.结论:2008—2012年发表的论文选择更具有针对性,向着更为合理性的方向发展,研究方法也多采用定量分析方法,并且论文形式多样,文献被引次数越来越多.