Nitrated polynuclear aromatic hydrocarbons in ambient air in Italy. A brief overview

When nitrated polynuclear aromatic hydrocarbons (NPAH) were recognised as long‐term toxic compounds and were also identified in several anthropogenic emissions and among the by‐products of photochemical smog they became objects of investigation in ambient air in both polluted and clean environments. In Italy the first investigations focussing on atmospheric NPAH were performed in the early eighties and encompassed both the canyon streets and dwelling areas of Rome. Because NPAH were indicated as markers of vehicle emission, new investigations were performed in other cities and also in rural and (nominally) unpolluted locations. In general, the first measurements of NPAH were episodic and could not be assumed to be strictly representative of the sites investigated. In contrast, nowadays consistent data bases on NPAH have been built up and are discussed in the technical literature, so that both neat concentrations and the yearly timed variation of the most important NPAH congeners have been measured in Italian air. Although concentrations of NPAH in air are usually much lower than those of PAH, owing to their very high potency in inducing mutations and tumours NPAH are regarded as having an important health impact on populations living in Italian urban areas. In this regard the genotoxicity of atmospheric aerosols is partly associated with nitrofluoranthenes and nitropyrenes whereas nitronaphthalenes and methylnitronaphthalenes seem to contribute to that of the gaseous organic fraction. Several civic and regional administrations are introducing control of atmospheric NPAH among ways of improving air quality in cities.     

Effect of biotransformation on multispecies plume evolution and natural attenuation

Biological transformation of volatile organic compounds is one of the key factors that influence contaminant-plume evolution and thus natural attenuation. In this study we investigate the effect of biological transformation on the transport of contaminants in the aqueous and gaseous phases. The analysis includes the study of the effect of density-driven advection of contaminants in the gaseous phase on multiphase and multispecies flow, fate and transport modeling in the subsurface. Trichloroethylene (TCE) and its two byproducts, dichloroethylene and vinyl chloride, are analyzed as the target contaminants. Our results indicate that density-driven advection of the gaseous phase, which is initiated by evaporation of TCE as a nonaqueous phase liquid, increases the downward and also the lateral migration of TCE within the unsaturated zone. This process also influences the location of high-concentration zones of the byproducts of TCE in the unsaturated and the saturated zones. Biotransformation of TCE contributes to the reduction of dissolved TCE plume development as expected. The daughter byproducts, which are introduced into the subsurface system, show distinct transport patterns as they are affected by their independent degradation kinetics and density-driven advection. These observations, which are based on our simulation results for biotransformation and transport of TCE and its byproducts, are useful in evaluating the natural attenuation processes, its potential health hazards and also the evaluation of potential plume development at contaminated sites.     

营口地区公路抗盐碱栽植新技术的研究

以辽宁省营口地区作为研究实例,通过土壤全盐量的测定,对营口地区抗盐碱栽植新技术进行了分析,并对结果进行了评价。     

A density functional theory computational study of the role of ligand on the stability of CuI and CuII species associated with ATRP and SET‐LRP

Atom transfer radical polymerization (ATRP) and single electron‐transfer living radical polymerization (SET‐LRP) both utilize copper complexes of various oxidation states with N‐ligands to perform their respective activation and deactivation steps. Herein, we utilize DFT (B3YLP) methods to determine the preferred ligand‐binding geometries for Cu/N‐ligand complexes related to ATRP and SET‐LRP. We find that those ligands capable of achieving tetrahedral complexes with Cu^I and trigonal bipyramidal with axial halide complexes with [Cu^IIX]⁺ have higher energies of stabilization. We were able to correlate calculated preferential stabilization of [Cu^IIX]⁺ with those ligands that perform best in SET‐LRP. A crude calculation of energy of disproportionation revealed that the same preferential binding of [Cu^IIX]⁺ results in increased propensity for disproportionation. Finally, by examining the relative energies of the basic steps of ATRP and SET‐LRP, we were able to rationalize the transition from the ATRP mechanism to the SET‐LRP mechanism as we transition from typical nonpolar ATRP solvents to polar SET‐LRP solvents. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 4950–4964, 2007     

Preparation of organic thin-film field effect transistor

The organic thin-film field effect transistor was prepared through vacuum deposition by using teflon as di-electric material. Indium-tin-oxide acted as the source and drain electrodes. Copper phthalocyanine and teflon were used as the semiconductor layer and dielectric layer, respectively. The gate electrode was made of Ag. The channel length between the source and drain was 50 μm. After preparing the source and drain electrodes by lithography, the copper phthalocyanine layer, teflon layer and Ag layerwere prepared by vacuum deposition sequentially. The field effect electron mobility of the device reached 1.1×10ˉ6 cm2/(V@s), and the on/off current ratio reached 500.     

Catalytic Activity of Nickel Alloys in Anodic Oxidation of the Hypophosphite Ion as a Function of Their Composition

The rate of anodic oxidation of the hypophosphite ion on alloys Ni-P, Ni-B, and Ni-Mo-P is studied as a function of their composition and structure. The organic compounds that are customarily used to stabilize electrolytes of electroless nickel plating are shown to come useful when controlling composition of the Ni-P coatings at the expense of their different influence on the rates of partial processes of deposition of the alloy components. The formation of catalytic activity of such coatings is affected mostly by a structural factor. With alloys Ni-P, Ni-B, and Ni-Mo-P, whose composition was varied by altering the concentration of the source of the alloying component, dependence of catalytic activity of the surface on the composition is defined mainly by an electronic factor.__________Translated from Elektrokhimiya, Vol. 41, No. 8, 2005, pp. 972–980.Original Russian Text Copyright © 2005 by Sotskaya, Dolgikh, Ryabinina.     

一种新型有机电致微腔结构的双模发射

采用结构Glass／DBR／ITO／NPB／NPB：Alq／Alq／Al制作了有机微腔电致发光器件。将空穴传输材料与发光材料以一定比例混合作为发光层，为了便于对比，在不改变有机层的膜厚的情况下同时制作了传统的异质结微腔器件，发现两种器件的发光光谱有很大不同，器件的复合效率与传统的异质结器件相比也得到了很大提高，这是因为将两种有机材料混合能消除界面势垒，提高器件的复合效率，从而提高了器件的发光性能，实现了微腔双模发射，且两个模式的半峰全宽分别为8nm和12nm。通过进一步优化器件结构可以实现微腔白光发射。     

分子间作用力对制备含有机废弃之水泥浆体影响研究

研究以水泥处理固体有机物时，有机物对水泥水化的影响。以膜流模式说明水份在水泥浆体内传输的现象。水膜存在半干之水泥浆体，其厚度小于100nm，膜流由离分压所驱动，而离分压来自分子间作用力。膜拟结果发现，水泥浆体内局部位置可用以进行水化之水量为Q=-Aslv／6vπ。当有机物添加在水泥浆体内时，会影响Hamaker常数，Aslv因此可能使膜流不稳定或完全抑制膜流，因而使水泥浆体内局部缺水，影响水化进行，造成成品强度降低，影响品质。     

Effect of the pore surface modification of an inorganic substrate on the plasma‐grafting behavior of pore‐filling‐type organic/inorganic composite membranes

We have investigated the effect of the surface state and surface treatment of the pores of an inorganic substrate on the plasma‐grafting behavior of pore‐filling‐type organic/inorganic composite membranes. Shirasu porous glass (SPG) was used as the inorganic substrate, and methyl acrylate was used as the grafting monomer. The grafting rate increased as the density of silanol on the SPG substrate increased. This result suggests that radicals are generated mainly at the silanol groups on the pore surface by plasma irradiation. The SPG substrates were treated with silane coupling agents used to control the mass of organic material bonded to the pore surface. The thickness of the grafted layer became thinner as the mass of organic material bonded to the pore surface of SPG increased. This decrease in the thickness of the grafted layer could be explained by the decrease in the penetration depth of vacuum ultraviolet rays contained in plasma having a wavelength of less than 160 nm that generated radicals in the pores of the substrate. The thickness of the grafted layer inside the SPG substrates could be controlled through the control of the mass of organic material bonded to the pore surface of the SPG substrate. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 846–856, 2006