Completely biodegradable composites of poly(propylene carbonate) and short,lignocellulose fiber Hildegardia populifolia

The composites of biodegradable poly(propylene carbonate) (PPC) reinforced with short Hildegardia populifolia natural fiber were prepared by melt mixing followed by compression molding. The mechanical properties, thermal properties, and morphologies of the composites were studied via static and dynamic mechanical measurements, thermogravimetric analysis, and scanning electron microscopy (SEM) techniques, respectively. Static tensile tests showed that the stiffness and tensile strength of the composites increased with an increasing fiber content. However, the elongation at break and the energy to break decreased dramatically with the addition of short fiber. The relationship between the experimental results and the compatibility or interaction between the PPC matrix and fiber was correlated. SEM observations indicated good interfacial contact between the short fiber and PPC matrix. Thermogravimetric analysis revealed that the introduction of short Hildegardia populifolia fiber led to a slightly improved thermooxidative stability of PPC. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 666–675, 2004     

光纤光栅选频掺Yb3+双包层光纤激光器

利用相位掩模法 ,在D形内包层掺Yb3 双包层光纤一端直接写制出Bragg光栅 ,用作双包层光纤激光器的输出腔镜 .试验得到了线宽为 0 196nm ,波长为 10 5 8 2nm ,最高输出功率为 5 70mW的稳定激光输出 ,解决了激光器中模式竞争造成的输出不稳定现象 .从速率方程出发 ,对激光器的输出功率与抽运功率、光栅反射率的关系以及最佳光纤长度进行了理论分析 ,结果与实验符合很好     

用楔形柱面光纤微透镜耦合的1.3μm SOA组件

运用激光模式耦合理论分析了半导体光放大器(SOA)与单模通信光纤的连接损耗,并设计制作了楔形柱面光纤微透镜用来实现两者的模斑匹配,有效地降低了器件的光耦合损耗.本文介绍了楔形柱面光纤微透镜耦合的1.3 μm半导体光放大器(SOA)组件及其制作方法.该组件的最大增益不小于14 dB,其偏振灵敏度小于1 dB,增益波动不大于0.5 dB.     

两段级联掺铒光纤放大器的优化研究

基于Giles模型,研究了980 nm和1480 nm泵浦的两段级联掺铒光纤放大器(EDFA)的设计,得出了掺铒光纤(EDF)的最佳长度和光隔离器的最佳位置随泵浦功率和信号功率的变化关系.比较980 nm和1480 nm泵浦的两段级联EDFA,可以发现,前者的最佳EDF长度短,而光隔离器最佳位置距EDFA输入端远.     

Nd~(3+):YAG激光的光纤传输

首先叙述了光纤传输Nd~(3+): YAG激光的优点,接着分析了不同光纤和其传输Nd~(3+): YAG激光的特点。然后通过对光纤传输系统各部分的分析与设计,结合实际,设计了光纤耦合机构。最后,对来自于工件反射光问题提出了解决方案。     

Optical bistability in an all-optical fiber nonlinear fabry-perot resonator with linear absorption

An all-optical fiber nonlinear Fabry-Perot resonator is proposed. The steady-state model for describing this resonator is developed. The transmission and refection bistabilities are shown numerically. Our results show that the bistability in this system is similar to that in a normal nonlinear Fabry-Perot etalon, except that the characteristics of the bistability can be changed not only by the cavity length but also by the phase shifts of the fiber loop mirrors.     

环形光纤延迟线高速脉冲串发生器的理论分析与设计原则

本文对用环形光纤延迟线产生高速光脉冲串的方法进行了理论分析,制定了一整套有关参数的计算和测试方法,并提出了整个系统的设计原则.     

挠率几何与有挠引力

本文提出一种统一描述引力场、规范场及自旋自相互作用的纤维丛理论.它把现有的挠率概念包含在其中,如Cartan理论、Brans-Dicke理论、规范引力理论等.本文还给出了一种拉伸纤维的映射,它为进一步探讨挠率产生的几何机制和物理机制提供了新的研究方式.     

利用CWDM实现多路信号传输的光纤通信系统

介绍了一种利用CwDM（粗波分复用）实现包括视频信号、网络信号和多路数据信号传输的光纤通信系统，其中较详细地介绍了多路数据信号传输的设计及实现方法，包括其编／解码原理和利用CPLD来实现同步码的生成与提取过程．此系统已经应用于科研项目中，而且较好地实现了多路信号的传输，工作状态一直很稳定．     

An experimental study of dynamic tensile properties of glass fiber at low-temperatures

Tensile impact experiments of EC8.0−24×7 glass fiber bundles at different low temperaturesT(14°C, −40°C and −10°C) and strain rates ɛ were carried out, and complete stress-strain curves were obtained. Within the range of the experiment temperatures and strain rates, it is found that the initial modulusE, the ultimate strength σ_max and the unstable strain ɛ _b of the glass fiber bundles all increase with ɛ at an identicalT. At an identical ɛ, with the decrease ofT, E and σ_max increase; but ɛ _b increases when 10°C>T>−40°C and decreases when −40°C>T>−100°C. The strain-rate- and temperature-dependent bimodal Weibull statistical constitutive theory was adopted for the statistical analysis of the experimental results, and the Weibull parameters of single fiber were obtained. The results show that the bimodal Weibull distribution function is suitable to represent the strength distribution of the glass fiber at low temperature and different strain rates. The differences in the mechanical properties between EC8.0−24×7 and EC5.5−12 ×14 glass fiber bundles were also discussed. Project supported by the National Natural Science Foundation of China (No. 19772058).