光纤的能量传输特性及应用

着重分析了影响光纤传输能量以及光纤传输中造成能量损耗的因素。这些因素主要包括光纤材料、构造、光纤的折射率分布、光纤的长度和芯径、光纤的数值孔径和热效应以及耦合等。同时 ,结合激光二极管点火的实例 ,分析探讨了其背景和应用价值。结论是 :为了尽可能减少能量损耗、提高光纤输出的激光功率和激光功率密度 ,应当选取合适的激光工作波长、较小的光纤长度、较小的芯径和较小的数值孔径 ,应采用渐变折射率分布光纤 ,应减少弯曲与耦合     

Fiber torsion sensor demodulated by a high-birefringence fiber Bragg grating

A new high-birefringence (Hi-Bi) fiber torsion sensor demodulated by a Hi-Bi fiber Bragg grating (FBG) is proposed in this study. The twisted Hi-Bi fiber sensor characteristics are analyzed using the Jones matrix. The intensity ratio from two reflected Bragg wavelengths is associated with the twist angle of the measured Hi-Bi fiber. It is found that the twist angle resolution is estimated at around 0.3° under ±0.1 dB readout from an optical spectrum analyzer if the polarization state of the light source is stable. The advantages of this new torsion sensor are: (1) insensitivity to intensity variations from the light source, (2) insensitivity to the torsion gauge length, and (3) absolute measurement in the twist angle. However, the polarization state of light in the proposed method needs to be controlled, and any birefringence change in the twisted Hi-Bi fiber needs to be prevented.     

光纤光栅激光器激射波长的研究

一般认为，用光纤光栅作选频元件的光纤激光器，激射波长与光纤光栅中心反射波长一致，本文报道了不同的实验研究结果。通过细致的实验研究，发现光纤光栅激光器激射波长相对于光纤光栅中心反射波长有一定的偏移。激射波长可以出现在光栅中心反射波长的长波端，也可以出现在其短波端。对不同腔结构的掺镱、掺铒光纤光栅激光器的深入研究证明，谐振腔的各向异性对激光器的激射波长偏移起到决定性的作用，波长最大偏移量主要受限于光纤光栅的反射带宽。通过激光腔内的偏振控制器改变谐振腔的各向异性，可以在光纤光栅的反射带宽内控制激射波长的位置。     

A study on the electrical conductivity of multi-walled carbon nanotube aqueous solution

The electrical conductivity was investigated for multi-walled carbon nanotubes (MWNTs) dissolved in chloroform and toluene, respectively. The electrical conductivity remarkably increased with increase in the content of MWNTs, which is in accordance with Archie's equation . Furthermore, a hypothesis of the electronic transport process was proposed to explain the difference between the solution and the solid compound. In addition, the temperature dependence of the electrical conductivity shows that log σ vs. 1/T exist in a good linear relationship. The activation energy of the electrical conductivity decreased with increase in concentration and an inflexion was observed at 60 °C in MWNT/toluene solution.     

Theoretical Study on the Reaction Mechanism between Dichlorocarbene and Armchair Single-walled Carbon Nanotubes

1 INTRODUCTION Carbon nanotubes have many potential applica- tions due to their unique structures and properties[1～4]. Physicists have been studying their electrical, me- chanical and other properties since their discove- ries[5, 6]. Recently, chemists are interested in carbon nanotubes because their properties can be altered by chemical functionalization[7～14], and these functiona- lized nanotubes can undergo further chemical trea- tment. So the potential application range of such na- …     

Non‐empirical calculations of NMR indirect carbon–carbon coupling constants. Part 4: Bicycloalkanes

A systematic study of the one‐bond and long‐range J(C,C), J(C,H) and J(H,H) in the series of nine bicycloalkanes was performed at the SOPPA level with special emphasis on the coupling transmission mechanisms at bridgeheads. Many unknown couplings were predicted with high reliability. Further refinement of SOPPA computational scheme adjusted for better performance was carried out using bicyclo[1.1.1]pentane as a benchmark to investigate the influence of geometry, basis set and electronic correlation. The calculations performed demonstrated that classical ab initio SOPPA applied with the locally dense Dunning's sets augmented with inner core s‐functions used for coupled carbons and Sauer's sets augmented with tight s‐functions used for coupled hydrogens performs perfectly well in reproducing experimental values of different types of coupling constants (the estimated reliability is ca 1–2 Hz) in relatively large organic molecules of up to 11 carbon atoms. Additive coupling increments were derived for J(C,C), J(C,H) and J(H,H) based on the calculated values of coupling constants within SOPPA in the model bicycloalkanes, in reasonably good agreement with the known values obtained earlier on pure empirical grounds. Most of the bridgehead couplings in all but one bicycloalkane appeared to be essentially additive within ca 2–3 Hz while bicyclo[1.1.1]pentane demonstrated dramatic non‐additivity of ?14.5 Hz for J(C,C), +16.6 Hz for J(H,H) and ?5.5 Hz for J(C,H), in line with previous findings. Non‐additivity effects in the latter compound established at the SOPPA level should be attributed to the through‐space non‐bonded interactions at bridgeheads due to the essential overlapping of the bridgehead rear lobes which provides an additional and effective non‐bonding coupling path for the bridgehead carbons and their protons in the bicyclopentane framework. Copyright © 2003 John Wiley & Sons, Ltd.     

用于机械振动实时监测的光纤光栅有源传感装置

把一对中心反射波长分别为1562.11nm和1562.71nm的光纤光栅粘贴在均质、等厚、等腰三角形悬臂梁上下表面作为环形腔光纤激光器端镜，当机械振动激励自由端时，通过观测激光输出脉冲，地施加于自由端的机械振动的频率进行了实时监测；观察两光栅波长漂移量差值的变化，可在0～6.1mm的范围内判断所测振动的振幅。低于100Hz时，实验结果与实际值基本吻合。     

Supercritical CO2 as a superior solvent for the cyclization of diallylmalonate catalyzed by palladium-containing zeolites

Palladium-containing zeolites catalyze the cycloisomerization of diethyl diallylmalonate to dimethylcyclopentenes. When the reaction is carried out in toluene, the performance of the palladium catalyst depends on the pore size of the zeolites. At 60 °C, palladium adsorbed on large pore size Beta zeolite (pore size ∼7.4 Å) is more active than medium pore size ZSM-5 (pore size ∼5.4 Å). This lower activity of ZSM-5 compared to Beta is attributable to the restricted diffusion of reagent and products through the ZSM-5 channels as compared to Beta zeolite. However, due to the gas-like diffusion characteristic of the supercritical state, the activity of ZSM-5 increases and becomes identical to that of Beta zeolite using supercritical CO₂ as medium.     

OADM环网的实验研究

研究了光分插复用器(OADM)的关键技术,重点分析了相关的实现技术,完成了利用OADM构建全光环网的实验研究,给出了重要的实验数据,包括眼图、光谱图、光信噪比、保护与恢复等,并对这些实验数据进行了分析,为光传送网的设计与构建提供了重要的参考依据.     

锥形光纤间耦合特性的分析与检测

将通信光纤的末端拉制成锥形，利用光信号在光纤锥形区特有的传输和耦合特性，实现了光纤的耦合、连接和分束。用耦合模理论分析了锥形光纤间的传输和耦合性质，给出了光信号两锥形光纤间的耦合与两锥形光纤的距离和锥形区重叠长度等实验结果。