Solid state NMR characterization of formation of poly(ϵ‐caprolactone)/maghnite nanocomposites by in situ polymerization

Results of multinuclear MAS NMR spectroscopy are reported for poly (ε‐caprolactone)/maghnite nanocomposite formation, with ε‐caprolactone in situ polymerized in the presence of maghnite, a proton exchanged montmorillonite clay. Exfoliated and intercalated materials with different maghnite loading in the range 3–15 wt % were investigated. ¹H NMR evidences Brønsted acid hydroxyl groups in the silicate layers and shows that their broad signal at 7.6 ppm present in the parent clay disappears in the nanocomposite material. ²⁷Al MAS NMR results show that beside the hexacoordinated aluminum signal, two additional peaks corresponding to two different tetrahedral Al sites are present in the clay framework. The NMR signal intensity of only one of them was found to be affected in the nanocomposites compared with the parent maghnite, suggesting that these specific aluminum sites are the reactive ones at the initial stages of the polymerization. However almost no changes occurred in the ²⁹Si NMR spectra, confirming that the polymer grafting, as indicated earlier by atomic force microscopy, took place on the aluminum tetracoordinated sites rather than on the silicon sites. A mechanism of maghnite surface catalyzed polymerization of ε‐caprolactone was proposed, involving Brønsted and Lewis acid sites. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 3060–3068, 2007     

Maximal σ‐polynomials of connected 3‐chromatic graphs

In the set of graphs of order n and chromatic number k the following partial order relation is defined. One says that a graph G is less than a graph H if c_i(G) ≤ c_i(H) holds for every i, k ≤ i ≤ n and at least one inequality is strict, where c_i(G) denotes the number of i‐color partitions of G. In this paper the first ? n/2 ? levels of the diagram of the partially ordered set of connected 3‐chromatic graphs of order n are described. © 2003 Wiley Periodicals, Inc. J Graph Theory 43: 210–222, 2003     

Li3Sn的电子和几何结构:第一原理计算

CuSn化合物在近来的锂电池负极材料研究中引起了相当的重视.使用基于混合基表示的第一原理赝势法,研究了Li插入CuSn完全替代了Cu而且占满所有间隙位置后形成的Li3Sn的电子与几何结构性质.给出了其"结构～能量"关系图,电子能带结构,电子态密度以及电荷密度分布等.     

Low-energy ion-assisted control of interfacial structures in metallic multilayers

A molecular dynamics method has been used to simulate the argon ion-assisted deposition of Cu/Co/Cu multilayers and to explore ion beam assistance strategies that can be used during or after the growth of each layer to control interfacial structures. A low-argon ion energy of 5–10 eV was found to minimize a combination of interfacial roughness and interlayer mixing (alloying) during the ion-assisted deposition of multilayers. However, complete flattening with simultaneous ion assistance could not be achieved without some mixing between the layers when a constant ion energy approach was used. It was found that multilayers with lower interfacial roughness and intermixing could be grown either by modulating the ion energy during the growth of each metal layer or by utilizing ion assistance only after the completion of each layers deposition. In these latter approaches, relatively high-energy ions could be used since the interface is buried and less susceptible to intermixing. The interlayer mixing dependence upon the thickness of the over layer has been determined as a function of ion energy.     

Shevrin问题的若干充要条件

利用偏序讨论了Ｉ＿３一半群的一些性质，并给出了Ｓｈｅｖｒｉｎ问题的若干充要条件。     

最小二乘解存在的充分必要条件

本文提出了当观测值的权矩阵为正定或半正定的前提下，其最小二乘解存在的充分必要条件为并以间接平差为例验证了该结论的正确性。     

Synthesis and characterization of poly(higher‐α‐olefin)s with a nickel(α‐diimine)/methylaluminoxane catalyst system: Effect of chain running on the polymer properties

Homopolymerization of octadecene‐1 at different reaction conditions has been studied. Significant chain running can be seen at higher polymerization temperatures. Interestingly, insertion of octadecene‐1 into a sterically hindered nickel‐cation/carbon (secondary) bond is observed. The microstructure of the polymer was established using NMR spectroscopy. The effects of chain running on polymer melting, crystallization behavior, and dynamic mechanical thermal properties were studied using DSC and DMTA. The extent of chain running (i.e., 2,ω‐, 1,ω‐enchainments) decreases with an increase in the carbon number of α‐olefins. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 191–210, 2007     

Liquid-Liquid Equilibrium for 1-Butanol-Water-KF and 1-Butanol-Water-K2CO3 Systems

KF or K2CO3 was added into the 1-butanol-water system and two phases were formed： water-rich phase （water phase） and 1-butanol-rich phase （1-butanol phase）. The liquid liquid equilibrium （LLE） data for 1-butanol-water-KF and 1-butanol-water-K2CO3 systems were measured at 25℃ and showed that 1-butanol phase contained negligible salt and water phase contained negligible 1-butanol when the concentrations of KF and K2CO3 in the water phase were equal to or higher than 27.11% and 31.68% , respectively. Thus water could be separated efficiently from 1-butanol-water by adding KF or K2CO3 into the system. A theoretical calculation of LLE data was calculated by using the Pitzer theory to get water activity in the water phase, and by the models, such as the Wilson, NRTL or the UNIQUAC for the 1-butanol phase. For 1-hutanol-water-KF system, the experimental data were found in good agreement with the calculated results by using Pitzer theory and Wilson equa tion, while for 1-butanol-water-K2CO3 system, the experimental data were found in good agreement with the calculated results by using Pitzer theory and UNIQUAC eauation.     

Heterograft copolymers of poly(ε‐caprolactone) prepared by combination of ATRA “grafting onto” and ATRP “grafting from” processes

This paper aims at reporting on the synthesis of a heterograft copolymer by combining the “grafting onto” process based on atom transfer radical addition (ATRA) and the “grafting from” process by atom transfer radical polymerization (ATRP). The statistical copolymerization of ε‐caprolactone (εCL) and α‐chloro‐ε‐caprolactone (αClεCL) was initiated by 2,2‐dibutyl‐2‐stanna‐1,3‐dioxepane (DSDOP), followed by ATRA of parts of the chlorinated units of poly(αClεCL‐co‐εCL) on the terminal double bond of α‐MeO,ω‐CH₂?CH? CH₂? CO₂‐poly(ethylene oxide) (PEO). The amphiphilic poly(εCL‐g‐EO) graft copolymer collected at this stage forms micelles as supported by dynamic light scattering (DLS) and transmission electron microscopy (TEM). The unreacted pendant chloro groups of poly(εCL‐g‐EO) were used to initiate the ATRP of styrene with formation of copolymer with two populations of randomly distributed grafts, that is PEO and polystyrene. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 6015–6024, 2006     

Synthesis and characterization of mid‐ and end‐chain functional telechelics by controlled polymerization methods and coupling processes

Well‐defined polystyrene‐ (PSt) or poly(ε‐caprolactone) (PCL)‐based polymers containing mid‐ or end‐chain 2,5 or 3,5‐ dibromobenzene moieties were prepared by controlled polymerization methods, such as atom transfer radical polymerization (ATRP) or ring opening polymerization (ROP). 1,4‐Dibromo‐2‐(bromomethyl)benzene, 1,3‐dibromo‐5‐(bromomethyl)benzene, and 1,4‐dibromo‐2,5‐di(bromomethyl)benzene were used as initiators in ATRP of styrene (St) in conjunction with CuBr/2,2′‐bipyridine as catalyst. 2,5‐Dibromo‐1,4‐(dihydroxymethyl)benzene initiated the ROP of ε‐caprolactone (CL) in the presence of stannous octoate (Sn(Oct)₂) catalyst. The reaction of these polymers with amino‐ or aldehyde‐functionalized monoboronic acids, in Suzuki‐type couplings, afforded the corresponding telechelics. Further functionalization with oxidable groups such as 2‐pyrrolyl or 1‐naphthyl was attained by condensation reactions of the amino or aldehyde groups with low molecular weight aldehydes or amines, respectively, with the formation of azomethine linkages. Preliminary attempts for the synthesis of fully conjugated poly(Schiff base) with polymeric segments as substituents, by oxidative polymerization of the macromonomers, are presented. All the starting, intermediate, or final polymers were structurally analyzed by spectral methods (¹H NMR, ¹³C NMR, and IR). © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 727–743, 2006