非设计工况下叶轮进口附近的流动及其控制

对叶轮进口附近流动在偏离设计工况下的回流和汽蚀(空化)两大特性进行了系统的描述,阐述了它们的诱发机理及其对泵性能的影响.根据回流的诱发机理对诱导轮的作用进行了全面的分析,提出了控制回流发生的有效方法,从叶片进口流动这一角度完善了离心泵叶片设计理论.     

室温下压致铁钴镍合金的bcc→hcp相变

 本文采用高压X光衍射方法在金刚石对顶压砧中在位地（in situ）研究了Fe₆₈Co₂₄Ni₈（wt%）合金在室温下的压致bcc→hcp结构相变和直到40.5 GPa的等温压缩行为。实验结果表明该合金在常压下为bcc结构，晶格常数a₀=(0.287 0±0.000 1) nm，体积V₀=(7.119±0.007) cm³/mol，密度ρ₀=(7.981±0.008) g/cm³；在20.9 GPa附近出现bcc→hcp结构相变，两相共存压力区约10 GPa，在此区域内有晶面间距d(002)_hcp=d(110)_bcc，且原子平面(002)_hcp//(110)_bcc，hcp相比bcc相体积减小(0.33±0.02) cm³/mol；高压相hcp结构的晶格参数比值c/a=1.608±0.004；相变后原子配位数的增加使得hcp相(002)平面内及(002)平面间的最近邻原子间距比bcc相最近邻原子间距分别增大约1.6%和0.5%；用Murnaghan状态方程对实验数据进行最小二乘法拟合，得到bcc相B₀=(130±13) GPa，B₀'=12.6±0.5；hcp相V₀=(6.62±0.04) cm³/mol，B₀=(243±21) GPa，B₀'=6.8±0.3；对于该合金的bcc→fcp相变时的结构转变机制做了详细的讨论。     

高压下液态Ag-20 at%Ge合金的凝固及密排六方亚稳相的形成

 利用高压淬火方法，在液态Ag-20at%Ge合金的凝固过程中，对比液态急冷低四个数量级的冷却速率得到了单相密排六方结构亚稳相，其点阵参数为a=0.289 8 nm，c=0.470 8 nm，c/a=1.625。     

High Speed Cutting Inconel 718 with Coated Carbide and Ceramic Inserts

High speed machining (HSM) technology is one of important aspects of advanced manufacturing technology. Nickel-based superalloys have been widely used in the aircraft and nuclear industry due to their exceptional thermal resistance and the ability to retain mechanical properties at elevated temperatures of service environment over 700 ℃. However, they are classified as difficult-to-cut materials due to their high shear strength, work hardening tendency, highly abrasive carbide particles in the microstructur...     

Simulation and Experimental Analysis of Super High-Speed Grinding of Ductile Material

This study aims to reduce the work-affected layer of the machined surface by carrying out the grinding at the speed over static pr o pagation speed of plastic wave of ductile materials and also aims to clarify suc h super high-speed machining mechanism.This paper reports on the result obtain ed through the molecular dynamics simulations and experiments on the super-spee d grinding below and beyond static propagation speed of aluminum.From the simul ation results,it is verified that the plastic deformation ...     

Evidence for the short-period oscillations in spin-resolved photoemission of thin Cr(110) films

The spin-resolved electronic structure of thin Cr overlayers on top of the Fe(110) surface was investigated by means of spin- and angle-resolved photoelectron spectroscopy. The initial fast drop of photoelectron spin-polarization at the Fermi level, followed by weak oscillatory behavior with the period of about 2 ML, can give an evidence for the first time spectroscopic observation of the short period oscillations in (110)-oriented thin Cr films.     

Gas solubility of carbon dioxide in poly(lactic acid) at high pressures: Thermal treatment effect

The sorption of carbon dioxide in glassy Poly(lactic acid) (PLA) films was studied by quartz crystal microbalance (QCM) at high pressures. Two thermal treatments, melted and quenched, were performed in PLA with two different L:D contents, 80:20 and 98:2, films and compared with a third thermal protocol, annealed, and used in a previous work. The results obtained show that for pressures higher than 2 MPa, the carbon dioxide solubility is larger in PLA 80:20 than in PLA 98:2, indicating that the L:D plays a dominant role on this property. The thermal treatments only affect the gas solubility in PLA 98:2. Sorption isotherms at temperatures 303, 313, and 323 K, below the glass transition temperature of the polymer, and pressures up to 5 MPa were measured and analyzed with three different models, the dual‐mode sorption model, the Flory–Huggins equation, and a modified dual‐mode sorption model where the Henry's law term was substituted by the Flory–Huggins equation. This last model performs especially well for CO₂ in PLA 80:20, due to the convex upward curvature of the solubility isotherms for that system. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 616–625, 2007     

Refraction of light in media

The roles of the magnetic field and electric field of the light are investigated when the light is refracted in the medium. The model of the electron cloud conductor is presented. Electron cloud in a molecule is treated as a conductor and the Faraday’s Law is applied to this conductor that is in the alternating magnetic field of the light. dB _M/dt of the light gives rise to an alternating induced current on the electron cloud conductor, and the light exchanges energy, i.e. the refractive energy, with the electron cloud conductor. Formulas of refractive index, which is the ratio of light speed in vacuum to that in the medium, are derived with this model. These formulas are tested with several mediums and Langevin’s diamagnetic susceptibility of helium gas, and the results are in good agreement with the measured data. The anisotropy and the nonlinearity of the refractive index are explained with the theory described in this work. Supported by Beijing Science and Technology New Star Program (Grant No. 952870400), the Beijing Municipal Commission of Education and the Excellent Young Teachers Program of Ministry of Education of China     

碳化硅压腔和高压下的中子衍射

使用宝石级碳化硅晶体作为压砧材料，成功研制出了碳化硅压腔（MAC），并应用全景式MAC进行了高压下物质的中子衍射实验研究。结果表明，MAC是一种既能产生高的压力又具有大的高压样品室的装置，特别适合于高压下的中子衍射研究。     

一种新的磷化铟复合沟道高电子迁移率晶体管小信号物理模型

针对磷化铟(InP)复合沟道高电子迁移率晶体管(HEMT)的特点，对常规单沟道HEMT的小信号物理模型进行了修正，提出了一种新的用于复合沟道HEMT的小信号物理模型，用商用器件模拟软件ISE(integrated systems engineering)对其进行了仿真验证，对比了实测和仿真的I-V特性及转移特性曲线，重点研究了在InGaAs/InP双层沟道中考虑量子效应后的电场和电流密度随着不同栅电压的变化趋势，研究结果表明，由于在沟道中存在量子效应，在栅下靠源端低电场区域，电流主要分布在InGaAs沟道 关键词： 高电子迁移率晶体管 复合沟道 物理模型 磷化铟