The facile reduction of carbon dioxide to carbon monoxide with an amido-digermyne

Taking the fizz out: A digermyne compound with a Ge?Ge single bond has been shown to quantitatively reduce CO(2) to CO at temperatures as low as -40?°C. The mechanism of this unprecedented reaction has been probed by spectroscopic and computational techniques and involves a metastable intermediate (see picture; Ar*=C(6) H(2) {C(H)Ph(2) }(2) Me-2,6,4).     

Enantioselective Titanium(III)-Catalyzed Reductive Cyclization of Ketonitriles

Reduction, please! The title reaction affords α-hydroxyketones, a common structural motif in biologically active natural products, in good yields and high enantioselectivities at room temperature. The commercially available ansa-titanocene 1 was found to be an efficient catalyst for this process, which presumably proceeds by addition of a ketyl radical to a nitrile.     

褐煤催化加氢气化实验研究

在加压固定床反应器中研究了碱金属K对褐煤加氢气化的催化作用,考察了温度、压力和催化剂添加量对褐煤加氢气化反应性能的影响。结果表明,碱金属K对褐煤加氢气化具有良好的催化效果,气化反应的碳转化率约为95%,产品气中甲烷的质量分数可达89%;升高温度、提高压力和增加催化剂添加量均能明显提高气化反应性能,催化剂的饱和添加量约为15%。利用扫描电子显微镜(SEM)和气体吸附/脱附分析,对不同催化剂添加量煤样的表面形态和孔结构进行分析,发现比表面积和孔容积随K添加量的增加先减少后增大。     

焙烧及还原温度对 Co-Pt-ZrO2/γ-Al2O3催化剂费托合成反应性能的影响

采用浸渍法制备了Co-Pt-ZrO₂/γ-Al₂O₃催化剂,对其进行了BET、XRD和TPR等表征,并在浆态床反应器上考察了焙烧温度和还原温度对催化剂费托合成反应性能的影响。结果表明,焙烧温度过高,容易造成Co物种和载体间的相互作用增强,使部分氧化钴颗粒聚集或烧结,导致催化剂的F-T合成反应活性和C₅₊烃选择性降低。还原温度较低时,钴物种不能充分还原,CO加氢活性低,甲烷选择性高,重质烃选择性低;还原温度过高,则可能造成活性物种的烧结,反而降低了催化剂的活性和重质烃选择性。在原料气n(H₂)/n(CO)=2.0、483 K、2.4 MPa和空速3.6 L/(gcat·h)的条件下,31.08%Co～0.11%Pt～7.16%ZrO₂/Al₂O₃催化剂在673 K焙烧。纯H₂下653 K还原后,其费托性能最佳;CO转化率为27.0%,C₅₊的选择性为83.0%。     

还原温度对Fe-Mo催化剂性质及F-T合成性能的影响

研究了还原温度对Fe-Mo催化剂性质及费托(F-T)合成性能的影响。采用N₂物理吸附、X射线衍射、穆斯堡尔谱和H₂程序升温脱附技术对催化剂进行了表征。结果表明,随还原温度升高,金属铁晶粒粒径增大,金属铁上的H₂吸附量先升后降;催化剂还原度提高,反应态催化剂碳化铁含量递增。催化剂F-T合成性能在280 ℃、1.5 MPa、2 000 h^-1、合成气H₂/CO比为2.0条件下在固定床反应器中测试。反应结果表明,随还原温度提高,催化剂接近稳态时的活性和重质烃选择性(C₅⁺)先升后降,而甲烷选择性则先降后升。350 ℃还原催化剂具有最佳F-T合成反应性能。     

铂-氢钨青铜电极的制备及对氢氧化的电催化

采用电化学还原法在表面改性的碳布上,通过改变催化剂沉积顺序及氢钨青铜沉积时间制备铂-氢钨青铜复合催化剂,所得电极作为质子交换膜燃料电池(PEMFC)阳极。利用X射线衍射(XRD)、热重分析(TG)、扫描电子显微镜(SEM)、循环伏安(CV)及单电池极化性能测试研究了催化剂的组成、沉积量、分散性及其对氢氧化的电催化活性。实验结果表明,氢钨青铜沉积时间及催化剂沉积顺序对电极催化性能有显著影响,当氢钨青铜沉积时间为10 min,先沉积氢钨青铜、后沉积铂所得Pt/HxWO3电极对氢氧化具有最佳的催化活性。适量的氢钨青铜才能与铂形成较好的协同催化效应。     

石墨烯/银复合薄膜的制备及表征

采用静电自组装技术,通过交替沉积聚(二烯丙基二甲基氯化铵)(PDDA)(或硝酸银)和氧化石墨烯,制备氧化石墨烯/PDDA薄膜和氧化石墨烯/硝酸银复合薄膜。然后在600℃下通入氩气和氢气进行气氛还原得到石墨烯薄膜和石墨烯/银复合薄膜。采用AFM、SEM、XPS、UV-Vis以及四探针电阻仪等对薄膜结构及性质进行表征。结果表明,通过静电自组装法可以获得生长均匀的薄膜。对比于相同自组装次数的石墨烯薄膜,石墨烯/银复合薄膜具有更好的透光性和更低的薄膜方块电阻。在λ=500 nm时,四层石墨烯/银复合薄膜的透过率为85%左右,而石墨烯薄膜的透过率为72%左右;石墨烯薄膜的方阻为161.39 kΩ.□-1,而石墨烯/银复合薄膜的方阻为99.11 kΩ.□-1。     

磁性碳包铁纳米粒子在重金属元素检测分离富集中的应用

以氩电弧等离子体法制备的碳包铁纳米粒子为固相萃取材料,采用等离子体原子发射光谱法(ICP-AES)系统研究了该材料对Cr、Ni、Cd、Pb离子的吸附性能,并确定了最佳吸附和洗脱条件。实验结果表明:当pH值为8.0～9.0时,分析物均可被碳包铁纳米粒子定量吸附;采用酸性溶液(pH=1.0～2.0)可将吸附在碳包铁纳米粒子上的金属离子完全脱附。该法对Cr、Ni、Cd、Pb的检出限分别为3.6、4.1、1.1、9.8μg/L,Cr、Ni、Cd的线性范围为1～500μg.L-1,Pb的线性范围为10～1 000μg.L-1,线性相关系数均大于0.999。方法用于自来水中Cr、Ni、Cd、Pb离子的测定,回收率可达到93%～105%;碳包铁纳米粒子对Cr、Ni、Cd、Pb离子的吸附量分别为3.6、4.8、6.3、2.1 mg/g。     

FACILE REDUCTION OF AROMATIC NITRO COMPOUNDS WITH HYDROIODIC ACID UNDER MICROWAVE IRRADIATION ON SOLID SUPPORT

Reduction of aromatic nitro compounds to amine with hydroiodic acid was revisited. Under microwave irradiation on solid support the reduction proceeded efficiently and rapidly.     

Dielectric Properties of Polymer Composites Filled with Different Metals

Electrically conductive composite systems based on polyvinyl chloride (PVC) and polymethyl methacrylate (PMMA) filled with metal powders of Al and Cu have been studied. The composite preparation conditions allow the formation of a random distribution of metallic particles in the polymer matrix. Dependence of the dielectric and conductivity properties of the PVC and PMMA/fillers was studied over a broad range of frequency and volume fraction of metal fillers. The experimental results could be explained by means of the conductivity of fillers and the interface polarization between polymers and fillers. Percolation was also seen in this study when the volume fraction of conducting fillers was close to critical value, in which the composites undergo an insulator‐conductor transition. The relation among the dielectric property and the fillers with different conductivity was proposed.