Atomic-scale simulation of nano-grains:structure and diffusion properties

Nanograins are characterized by a typical grain size from lto 100 nm.Mclecular dynamics aimubations have been carried out for the nanograin sphere with the diameters from 1.45 to 10.12 nm.We study the influence of grain size on structure and diffusion properties of the nanograins.The results reveal that as the grain size is reduced,the fraction of grain surface increases significantly,and the surface width is approximately constant；the diffusicn coefficlent is increased sharply,and the relation of the diffusion coefficient and the grain size is close to exponential relation below 10nm.     

非晶金刚石膜的性能及其应用

非品金刚石薄膜具有超高硬度等一系列优异的特殊性能，为工程界孜孜追求的材料表面镀膜。用百纳科技公司研发制造的过滤阴极真空电弧离子镀膜机镀制的非晶金刚石薄膜，SP^3金刚石结构量≥80％，硬度高，膜／基结合力高，摩擦系数小，耐磨损，耐腐蚀，透光率高，在电子，机械，光学，生物医学上有广泛应用前景。我们已在视窗玻璃，丝锥，模具，硬质合金刀头等产品上成功应用。     

Asymptotics of estimates in constrained nonlinear regression with long-range dependent innovations

The purpose of this paper is to investigate the asymptotic properties of the least squares estimates (L ₂-estimates) and the least absolute deviation estimates (L ₁-estimates) of the parameters of a nonlinear regression model subject to a set of equality and inequality restrictions, which has a long-range dependent stationary process as its stochastic errors. Then we will compare the asymptotic relative efficiencies of the above estimators.     

偏硼酸钠与镁和氢反应的硼氢化钠生成

高的氢压和反应温度有利于片硼酸钠与镁和氢反应生成硼氢化钠，但温度接近镁的熔点时不利于硼氢化钠的生成。在反应物中添加铁、镍和钴将加速硼氢化钠的生成，而铜的加入却阻碍硼氢化钠的生成。     

Effect of short glass fiber on structure and viscoelastic behavior of olefinic polymers synthesized with metallocene catalyst

Several composites were prepared on the basis of an ethylene homopolymer and different copolymers of ethylene and 1‐hexene, synthesized with a metallocene catalyst, as matrices and a content of a 5 wt % of short glass fiber. The effect of the fiber incorporation on the structure and mechanical and viscoelastic behaviors was analyzed for the different samples. The glass fibers induced a slightly higher crystallinity, and the crystallite morphology significantly changed (long spacings and crystal orientation). The incorporation of fibers did not reinforce the different matrices under study at this low content; consequently, the mechanical parameters, such as Young's modulus, yielding stress, and microhardness, were lower in the composites as compared with those values found in the neat polyolefins. The location and apparent activation energies of distinct relaxation processes are also discussed. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 1244–1255, 2003     

具有可调紫外滤光性能的富勒烯胺/壳聚糖共混膜的研究

通过溶液共混及流涎成膜法制备了一系列不同C60乙醇胺含量的壳聚糖共混膜。以及含Cu（Ⅱ）的C60乙醇胺/壳聚糖共混膜。研究表明，C60乙醇胺/壳聚糖共混膜具有优异的可调紫外滤光性能，随着C60乙醇胺含量的增加，其紫外滤光波长从200nm红移至400nm左右。在该复合体系中引入Cu（Ⅱ）能有效改善膜的紫外光学性能，同时还初步探讨了这类复合材料的紫外滤光机制。     

激光诱导间质肿瘤热疗的数值模拟和实验研究

本文在考虑生物组织物性动态变化的情况下建立了激光诱导间质肿瘤热疗(LITT)的物理数学模型,采用MonteCarlo方法数值模拟了LITT中激光能量在生物组织内的传输过程,基于Pennes生物传热方程和Arrhenius方程数值求解了组织内的温度分布和热损伤体积的变化,分析了热物性及血液灌注率的动态变化对LITT过程的影响,并与相应的离体实验结果进行了对比。数值模拟结果表明,组织的热物性及血液灌注率的动态变化对于热损伤体积的变化具有重要的影响。因此在激光诱导间质肿瘤热疗的数值模拟中应该考虑热物性及血液灌注率的动态变化以期为临床治疗方案的制定提供更为准确的依据。     

Transport properties of acetone aqueous solutions: molecular dynamics simulation and NMR studies

Two quantities η_rel and are applied to study the nonideal acetone–water association mixture. An all-atom acetone model and a TIP5P water model have been adopted for molecular dynamics simulation. We study the transport properties of the system comparing the 's of strong hydrogen bond and weak contact based on transport properties, MD simulations together with NMR experimental data and find good agreement of concentration dependence, which exhibits the cooperation effect.     

Novel,organosoluble, light‐colored fluorinated polyimides based on 2,2′‐bis(4‐amino‐2‐trifluoromethylphenoxy)biphenyl or 2,2′‐bis(4‐amino‐2‐trifluoromethylphenoxy)‐1,1′‐binaphthyl

Two series of fluorinated polyimides were prepared from 2,2′‐bis(4‐amino‐2‐trifluoromethylphenoxy)biphenyl ( 2 ) and 2,2′‐bis(4‐amino‐2‐trifluoromethylphenoxy)‐1,1′‐binaphthyl ( 4 ) with various aromatic dianhydrides via a conventional, two‐step procedure that included a ring‐opening polyaddition to give poly(amic acid)s, followed by chemical or thermal cyclodehydration. The inherent viscosities of the polyimides ranged from 0.54 to 0.73 and 0.19 to 0.36 dL/g, respectively. All the fluorinated polyimides were soluble in many polar organic solvents, such as N,N‐dimethylacetamide and N‐methylpyrrolidone, and afforded transparent and light‐colored films via solution‐casting. These polyimides showed glass‐transition temperatures in the ranges of 222–280 and 257–351 °C by DSC, softening temperatures in the range of 264–301 °C by thermomechanical analysis, and a decomposition temperature for 10% weight loss above 520 °C both in nitrogen and air atmospheres. The polyimides had low moisture absorptions of 0.23–0.58%, low dielectric constants of 2.84–3.61 at 10 kHz, and an ultraviolet–visible absorption cutoff wavelength at 351–434 nm. Copolyimides derived from the same dianhydrides with an equimolar mixture of 4,4′‐oxydianiline and diamine 2 or 4 were also prepared and characterized. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 2416–2431, 2004